Search

Most of the published documents on the friction and wear properties of textured contact surfaces with partially distributed units (e.g., dots, grooves) are focused on sliding tribo-pairs or journal bearings. To study the friction and wear performance of rolling bearings with different distributions of pits, several patterns were introduced: OS-1/4 (Outside, 1/4 of raceway), OS-1/2 (Outside, 1/2 of raceway), OS-3/4 (Outside, 3/4 of raceway), IS-1/4 (Inside, 1/4 of raceway), IS-1/2 (Inside, 1/2 of raceway), IS-3/4 (Inside, 3/4 of raceway), TS (Two sides, 2/3 of raceway), FT (fully textured) and SR (Smooth reference), with two circumferential interval angles (CFIAs, 1.5° and 2.0°). The dimensions of the pits are the same in all patterns (diameter of 300 μm and depth of 15 μm), which were only prepared on the raceways of the shaft washers of 81107 bearings (nylon cages) using the laser marking method. All bearings were tested under 4000 N, 250 RPM and starved lubrication using a vertical universal wear test rig. Their mass losses and worn raceways were measured and observed. Their surface equivalent stresses were also analyzed and compared. The obtained results show that the influence of different distributions of pits on the tribological properties of rolling bearings is significant. The friction-reducing and anti-wear performance of TS is acceptable, whether the CFIA is 1.5° or 2.0°. A fully textured pattern cannot provide the best tribological properties and its behavior even becomes worse when the CFIA is 2.0°. In this work, when the CFIA is 1.5°, the friction-reducing and anti-wear performance of OS-1/4 is the best among all patterns. Using a smooth reference as a benchmark for comparison, its friction-reducing and anti-wear performance can be enhanced by 60.46% and 16.05%, respectively. The results of this work will be an important reference for the optimal design of the “washers-cage-rollers” contact system for rolling bearings.

Differing from the published documents on the effect of texture distributions of sliding tribo-pairs on their friction and wear properties, this study introduced eight patterns to reveal the influence of different distributions of pits on the tribological behavior of textured rolling element bearings with nylon cages under dry condition, namely: Outside-1/4 (OS1/4), Outside-1/2 (OS1/2), Outside-3/4 (OS3/4), Inside-1/4 (IS1/4), Inside-1/2 (IS1/2), Inside-3/4 (IS3/4), Bothside-1/3 (BS) and full (FP). A fiber laser marking system was used to prepare them on the raceways of the shaft washers of cylindrical roller thrust bearings (81107TN). A vertical universal wear test rig was used to obtain their coefficients of friction under an axial load of 2600 N and a rotating speed of 250 RPM, without any lubricant provided. Their wear losses and worn surfaces were characterized. The influence mechanism of different distributions on the tribological properties was also discussed. The results show that the self-lubricating performance of nylon cages can ensure the continuous operation (≥5 h) of cylindrical roller thrust bearings under dry condition. The influence of outside-distributed patterns on the friction and wear properties of bearings is significant. The friction-reducing effect and wear resistance of full textured group is improved but not the best. The friction-reducing and anti-wear behavior of OS1/2 is similar to that of FP. In this work, OS3/4 can provide the best tribological performance under self-lubricating conditions. Compared with the data of smooth bearings, its average coefficient of friction and wear loss can be reduced by 37.68% and 38.85%, respectively. This work would provide a valuable reference for the raceway design and reliability optimization of rolling element bearings.