Search

Intense, millisecond-duration bursts of radio waves (named fast radio bursts) have been detected from beyond the Milky Way 1 . Their dispersion measures-which are greater than would be expected if they had propagated only through the interstellar medium of the Milky Way-indicate extragalactic origins and imply contributions from the intergalactic medium and perhaps from other galaxies 2 . Although several theories exist regarding the sources of these fast radio bursts, their intensities, durations and temporal structures suggest coherent emission from highly magnetized plasma 3,4 . Two of these bursts have been observed to repeat 5,6 , and one repeater (FRB 121102) has been localized to the largest star-forming region of a dwarf galaxy at a cosmological redshift of 0.19 (refs. 7-9 ). However, the host galaxies and distances of the hitherto non-repeating fast radio bursts are yet to be identified. Unlike repeating sources, these events must be observed with an interferometer that has sufficient spatial resolution for arcsecond localization at the time of discovery. Here we report the localization of a fast radio burst (FRB 190523) to a few-arcsecond region containing a single massive galaxy at a redshift of 0.66. This galaxy is different from the host of FRB 121102, as it is a thousand times more massive, with a specific star-formation rate (the star-formation rate divided by the mass) a hundred times smaller.

We describe the design and implementation of a controller-area-network bus (CANbus) monitor and control system for a millimeter wave interferometer. The Combined Array for Research in Millimeter-wave Astronomy (CARMA) is a 15-antenna connected-element interferometer for astronomical imaging, created by the merger of two university observatories. Its new control system relies on a central computer supervising a variety of subsystem computers, many of which control distributed intelligent nodes over CANbus. Subsystems are located in the control building and in individual antennas and communicate with the central computer via Ethernet. Each of the CAN modules has a very specific function, such as reading an antenna encoder or tuning an oscillator. Hardware for the modules was based on a core design including a commercial CANbus-enabled single-board computer and some standard circuitry for interfacing to peripherals. Hardware elements were added or changed as necessary for the specific module types. Similarly, a base set of embedded code was implemented for essential common functions such as CAN message handling and time keeping and extended to implement the required functionality for the different hardware. Using a standard CAN messaging protocol designed to fit the requirements of CARMA and a well-defined interface to the high-level software allowed separate development of high-level code and embedded code with minimal integration problems. Over 30 module types have been implemented and successfully deployed in CARMA, which is now delivering excellent new science data.

The fabrication and optimization of composite submillimeter wave bolometers with metal film absorbing elements and doped Ge thermometers are described. Performance characteristics are given for 4 x 4-mm bolometers designed for operation at both (4)He and (3)He temperatures. The performance expected from such bolometers when they are optimized for various values of background loading is calculated. Current dependent noise, which can arise from any of several sources, is included in the analysis. This can make it impossible to reach the background fluctuation noise limit. Feed structures for these bolometers which employ Winston light concentrators are described.