Search

Through the Gleeble3500 thermal simulation test machine, the phase transformation law of Nb microalloyed steel was studied and tested. After the compression deformation, it was cooled to room temperature at different speeds. Obtain the dynamic continuous cooling transformation diagram and the scanning structure diagram of the test steel, and then analyze the phase composition under different cooling speeds through JMatPro material performance simulation. The results show that: at a lower cooling speed (0.1°C/s), austenite decomposition is a diffusion-type phase change that takes place in a high-temperature region, and carbon atoms can diffuse sufficiently. At a moderate cooling rate (1°C/s), the bainite phase transition is a semi-diffusion phase transition in which carbon atoms are displaced in a non-cooperative thermally activated transition mode. When the cooling rate is high (15°C/s), the martensitic transformation is a non-diffusion-type transformation carried out in the low temperature region, and the atoms are directly transferred from the austenite lattice to the martensite lattice. With the increase of the cooling rate and the decrease of the transition temperature, from low-speed cooling→medium-speed cooling→high-speed cooling, respectively, the diffusion type phase transition→semi-diffusion type phase transition→the non-diffusion type phase transition. At different cooling rates, the continuous cooling transition diagram simulated by JMatPro is basically the same as the phase transition in the dynamic continuous cooling transition diagram of the test steel, which proves that the simulation prediction of the dynamic continuous cooling transition of the test steel by the JMatPro software has high accuracy and applicability.

In this study, a new Fe-6Mn-4Al-0.4C high strength medium manganese hot rolled steel sheet was designed. The influence mechanism of the intercritical annealing (IA) temperature on microstructure evolution and mechanical properties of experimental steel were studied by SEM and XRD. The experimental steel was held for 30 minutes at 640°C, 680°C, 720°C, 760°C, 800°C, respectively. When the annealing temperature was 640°C, cementite particles precipitated between the austenite and ferrite phase boundary. As the annealing temperature increased, the cementite gradually dissolved and disappeared, the fraction of lamellar austenite increased significantly. When the annealing temperature is 800°C, the coarse equiaxed austenite and ferrite appeared. The yield strength (YS) decreased, the product of strength and elongation (PSE) and total elongation (TE) both increased first and then decreased, while the ultimate tensile strength (UTS) showed the opposite trend. The experimental steel exhibited excellent comprehensive mechanical properties after held at 760°C for 30 min. The UTS was 870 MPa, the YS was 703 MPa, and the TE was 77 %, the PSE was 67 GPa·%.

A principle investigation of the fingerprint resistance, alcohol resistance, solvent resistance, humidity resistance, high temperature resistant yellow degeneration and black tarnish resistance of pure Zinc and Zn-Al-Mg coating were performed in this study. To detect above surface performance and make some constructive suggestions, a series of simulations experiments and a surface performance evaluation system based on light color differentiation measurement instrument were designed. The results show that the two products both can meet the needs of users in above-mentioned surface performance, besides pure Zinc coated product has more advantages in this performance in comparison to Zn-Al-Mg coated product. Users should pay attention to clean the fingerprint regularly which attached to the surface of the steel plate during use and the protection with the exposed surfaces of the steel during shipping.