Search

If a dead body is discovered in water, it nearly always raises the question about the cause of death, often associated with the persistent problem to differentiate between a drowning incident and post-mortem immersion. In numerous cases, a reliable confirmation of death by drowning is often only possible by a combination of diagnoses obtained from autopsy and additional investigations. As to the latter, the use of diatoms has been suggested (and debated) since decades. Based on the consideration that diatoms are present in almost every natural waterbody and are unavoidably incorporated when water is inhaled, their presence in the lung and other tissues can provide evidence of drowning. However, the traditional diatom test methods are still subject of controversial discussion and suspected of erroneous outcome, predominantly through contamination. A promising alternative to minimize the risk of erroneous outcome seems to be disclosed by the recently suggested MD-VF-Auto SEM technique. Especially the establishment of a new diagnostic marker (L/D ratio), which represents the factorial proportion between the diatom concentration in lung tissue and the drowning medium, allows for clearer distinction of drowning and post-mortal immersion and is largely robust to contamination. However, this highly elaborated technique requires specific devices which are frequently unavailable. We therefore developed a modified method of SEM-based diatom testing to enable the use on more routinely available equipment. Process steps such as digestion, filtration, and image acquisition were thoroughly broken down, optimized, and ultimately validated in five confirmed drowning cases. Taking certain limitations into consideration, L/D ratio analysis provided promising results, even in cases of advanced decomposition. We conclude that our modified protocol indeed opens a way for a broader use of the method in forensic drowning investigation.

A 9-year-old boy collapsed shortly after complaining of shortness of breath. Despite immediate resuscitation measures, the boy died. A few weeks earlier, he had received antibiotic treatment for respiratory infection. However, the post-mortem examination revealed an advanced tumor mass of the mediastinum with infiltration of vital structures, which was identified as a small blue round neoplasm with aspects of an extramedullary Ewing-like sarcoma by supplementary histological and immunohistochemical examinations.This dramatic clinical course of events shows that the possible presence of serious diseases should always be considered behind harmless symptoms, even in children.

When decomposition of a recovered body is fairly advanced, identification based on common morphologic features is often impossible. In these cases, short tandem repeat (STR) marker genotyping has established itself as a convenient and reliable alternative. However, at very progressed stages of decomposition, postmortem tissue putrefaction processes can decrease DNA yields considerably. Hence, not all types of tissue are equally suitable for successful STR marker-based postmortem identification. Bone or dental material is often analysed in corpses with advanced decompositional changes. However, processing of these materials is very elaborate and time and resource consuming. We have therefore focused on the suitableness of various types of soft tissue swabs, where DNA extraction is easier and faster. By sampling 28 bodies at various stages of decomposition, we evaluated the suitability of different tissues for genotyping at varying degrees of physical decay. This was achieved by a systematic classification of the sampled bodies by morphological scoring and subsequent analysis of multiple tissue swabs of the aortic wall, urinary bladder wall, brain, liver, oral mucosa and skeletal muscle. In summary, we found variable degrees of suitability of different types of soft tissue swabs for DNA-based identification. Swabs of the aortic wall, the urinary bladder wall and brain tissue yielded the best results — in descending order — even at advanced levels of decay. Supplementary Information The online version contains supplementary material available at 10.1007/s00414-021-02601-3.

Backspatter is biological material that is ejected from the entry wound against the line of fire. This phenomenon was also observed in wound ballistic simulations using so called "reference cubes" (12 cm edge length, 10% gelatin, 4 °C, paint pad beneath the cover). High-speed video records from 102 experimental shots to these target models using full metal jacketed bullets in the calibers .32 auto, .38 special, 9 mm Luger and .357 Magnum were analyzed for chronology, morphological appearance and velocity of fluid ejection. Generally, a short tail splashing of surface material occurred when the bullet was penetrating the target. In 51 shots from distance (≥ 5 cm), regardless of caliber and shot range, a linear jet of fluid started in connection with the first collapse of the temporary cavity. The initial velocity of the jet was measured between 6 and 45 m/s. The jet was streaming on for about 60 to 100 ms with a stochastic deviation of ± 13° to the horizontal. Close range and contact shots showed earlier and faster (up to 330 m/s) backspatter depending on the cartridge and the gap between muzzle and target. Gaseous aerosol-like spray and cone-like spatter indicated an increasing influence of muzzle gases with decreasing shot range. Even under standardized experimental conditions, variations of backspatter were observed in near/contact shots. Electronic supplementary material The online version of this article (10.1007/s12024-020-00326-0) contains supplementary material, which is available to authorized users.

ZusammenfassungEin junger Maschinist verlor während der Bedienung eines Mastseilgeräts mit Kran und Prozessor – zum Rücken, Entasten und Einschneiden von Bäumen – plötzlich das Bewusstsein und verstarb trotz Reanimationsmaßnahmen noch an der Arbeitsstätte. Bei der ärztlichen Leichenschau fiel ein ca. 1,5 × 1 cm großer Hautdefekt rechts an der Brustkorbvorderseite auf, welcher nicht genauer zugeordnet werden konnte. Die Umstände des Unfalls konnten durch die Obduktion und Untersuchungen am Unfallort geklärt werden. Die Sägekette des Prozessors war gerissen und ein Teil davon gelangte in die Sicherheitskabine des Mastseilgeräts, da die Sicherheitstür mit 12 mm Polycarbonatverglasung nicht geschlossen war. Dieser Kettenteil traf den Maschinisten in die Brust, was letztlich tödliche Verletzungen verursachte.

In recent years, protein decomposition has become of increasing interest for the use in forensic estimation of the postmortem interval (PMI). Especially skeletal muscle tissue has proven to be a prime target tissue, among other reasons, due to its large abundance in the human body. In this regard, it is important to know whether there are any intra- and intermuscular differences in the behavior of protein degradation. Thus, samples from different locations within several skeletal muscles as well as from cardiac and smooth muscle tissue samples were collected from three autopsy cases with varying degree of decomposition. Samples were analyzed by SDS-PAGE and Western blotting and compared for protein degradation patterns. Intramuscular variations turned out to be minimal and without major influence for the use of the method. Observed intermuscular differences provide possibilities for future improvement of the precision and temporal application range. The results of this study show the strengths and current limitations of protein degradation-based PMI estimation and provide a deeper understanding of intraindividual postmortem protein degradation processes.

Shot range, the muzzle-target distance, is a crucial parameter for forensic reconstruction of deaths by firearms. In a large number of cases, especially suicides, the forensic pathologist is confronted with contact or near-contact shots, where muzzle gases play an additional role. This study was conducted to systematically investigate the influence of muzzle gases on the temporary cavity (TC). A total of 72 shots were fired using full metal-jacketed bullets in four forensically relevant calibres from 10-, 5-, 3-, 2- and 1-cm distance and in close contact. Target model was the so-called reference cube (10% gelatine at 4 °C) with 12-cm edge length. The TC was recorded using high-speed video (HSV). Cross-sectional analysis was performed by cutting the blocks to 1-cm slices, which were evaluated by applying the polygon method. The TC of shots from 10 and 5 cm distance had a tubular form. This aspect changed depending on the cartridge with decreasing distance (≤ 3 cm) into a pear-like form, which was typical for contact shots. The cumulated heights of the TC increased with decreasing distance below 3 cm. Contact shots approximately doubled the extension of the TC compared with exclusive energy transfer. Whereas HSV documented an increasingly asymmetric profile with ballooning at the entry side, cross-sectional analysis of cracks in gelatine resulted in convex graphs with only slight asymmetry for contact shots. Additional damage in gelatine was detected for 3-cm distance or less in calibre .357 Magnum and ≤ 2 cm for .32 auto, .38 special and 9mm Luger. The increasing influence of muzzle gas pressure is detectable with decreasing shot range below 3 cm.