Search

Precision measurements of space and time, like those made by the detectors of the Laser Interferometer Gravitational-wave Observatory (LIGO), are often confronted with fundamental limitations imposed by quantum mechanics. The Heisenberg uncertainty principle dictates that the position and momentum of an object cannot both be precisely measured, giving rise to an apparent limitation called the Standard Quantum Limit (SQL). Reducing quantum noise below the SQL in gravitational-wave detectors, where photons are used to continuously measure the positions of freely falling mirrors, has been an active area of research for decades. Here we show how the LIGO A+ upgrade reduced the detectors' quantum noise below the SQL by up to 3 dB while achieving a broadband sensitivity improvement, more than two decades after this possibility was first presented.

Cadmium Zinc Telluride Imager (CZTI) aboard AstroSat has been regularly detecting Gamma-Ray Bursts (GRBs) since its launch in 2015. Its sensitivity to polarization measurements at energies above 100 keV allows CZTI to attempt spectro-polarimetric studies of GRBs. Here, we present the first catalog of GRB polarization measurements made by CZTI during its first five years of operation. This presents the time integrated polarization measurements of the prompt emission of 20 GRBs in the energy range 100-600 keV. The sample includes the bright GRBs which were detected within an angle range of 0-60 degree and 120-180 degree where the instrument has useful polarization sensitivity and is less prone to systematics. We implement a few new modifications in the analysis to enhance polarimetric sensitivity of the instrument. Majority of the GRBs in the sample are found to possess less / null polarization across the total bursts' duration in contrast to a small fraction of five GRBs exhibiting high polarization. The low polarization across the bursts can be speculated to be either due to the burst being intrinsically weakly polarized or due to varying polarization angle within the burst even when it is highly polarized. In comparison to POLAR measurements, CZTI has detected a larger number of cases with high polarization. This may be a consequence of the higher energy window of CZTI observations which results in the sampling of smaller duration of burst emissions in contrast to POLAR, thereby, probing emissions of less temporal variations of polarization properties., Comment: Accepted for publication in ApJ

AstroSat is India's first space-based astronomical observatory, launched on September 28, 2015. One of the payloads aboard AstroSat is the Cadmium Zinc Telluride Imager (CZTI), operating at hard X-rays. CZTI employs a two-dimensional coded aperture mask for the purpose of imaging. In this paper, we discuss various image reconstruction algorithms adopted for the test and calibration of the imaging capability of CZTI and present results from CZTI on-ground as well as in-orbit image calibration., Comment: 16 pages, 21 images, Payload Calibration, Accepted in JAA on AstroSat 5 years special issue

A number of synoptic sky surveys are underway or being planned. Typically they are done with small telescopes and relatively short exposure times. A search for transient or variable sources involves comparison with deeper baseline images, ideally obtained through the same telescope and camera. With that in mind we have stacked images from the 0.68~m Schmidt telescope on Mt. Bigelow taken over ten years as part of the Catalina Sky Survey. In order to generate deep reference images for the Catalina Real-time Transient Survey, close to 0.8 million images over 8000 fields and covering over 27000~sq.~deg. have gone into the deep stack that goes up to 3 magnitudes deeper than individual images. CRTS system does not use a filter in imaging, hence there is no standard passband in which the optical magnitude is measured. We estimate depth by comparing these wide-band unfiltered co-added images with images in the $g$-band and find that the image depth ranges from 22.0--24.2 across the sky, with a 200-image stack attaining an equivalent AB magnitude sensitivity of 22.8. We compared various state-of-the-art software packages for co-adding astronomical images and have used SWarp for the stacking. We describe here the details of the process adopted. This methodology may be useful in other panoramic imaging applications, and to other surveys as well. The stacked images are available through a server at Inter-University Centre for Astronomy and Astrophysics (IUCAA)., Comment: 16 pages, 15 figures

The Cadmium Zinc Telluride Imager (CZTI) on AstroSat is a hard X-ray coded-aperture mask instrument with a primary field of view of 4.6 x 4.6 degrees (FWHM). The instrument collimators become increasingly transparent at energies above $\sim$100 keV, making CZTI sensitive to radiation from the entire sky. While this has enabled CZTI to detect a large number of off-axis transient sources, calculating the source flux or spectrum requires knowledge of the direction and energy dependent attenuation of the radiation incident upon the detector. Here, we present a GEANT4-based mass model of CZTI and AstroSat that can be used to simulate the satellite response to the incident radiation, and to calculate an effective "response file" for converting the source counts into fluxes and spectra. We provide details of the geometry and interaction physics, and validate the model by comparing the simulations of imaging and flux studies with observations. Spectroscopic validation of the mass model is discussed in a companion paper, Chattopadhyay 2021., Comment: Accepted in the "AstroSat - 5 years" special issue of the Journal of Astrophysics and Astronomy

The Cadmium Zinc Telluride (CZT) Imager on board AstroSat is a hard X-ray imaging spectrometer operating in the energy range of 20 $-$ 100 keV. It also acts as an open hard X-ray monitor above 100 keV capable of detecting transient events like the Gamma-ray Bursts (GRBs). Additionally, the instrument has the sensitivity to measure hard X-ray polarization in the energy range of 100 $-$ 400 keV for bright on-axis sources like Crab and Cygnus X-1 and bright GRBs. As hard X-ray instruments like CZTI are sensitive to cosmic rays in addition to X-rays, it is required to identify and remove particle induced or other noise events and select events for scientific analysis of the data. The present CZTI data analysis pipeline includes algorithms for such event selection, but they have certain limitations. They were primarily designed for the analysis of data from persistent X-ray sources where the source flux is much less than the background and thus are not best suited for sources like GRBs. Here, we re-examine the characteristics of noise events in CZTI and present a generalized event selection method that caters to the analysis of data for all types of sources. The efficacy of the new method is reviewed by examining the Poissonian behavior of the selected events and the signal to noise ratio for GRBs., Comment: Accepted for publication in JAA

The Cadmium Zinc Telluride (CZT) Imager onboard AstroSat, consists of pixelated CZT detectors, which are sensitive to hard X-rays above 20 keV. The individual pixels are triggered by ionising events occurring in them, and the detectors operate in a self-triggered mode, recording each event separately with information about its time of incidence, detector co-ordinates, and channel that scales with the amount of ionisation. The detectors are sensitive not only to photons from astrophysical sources of interest, but also prone to a number of other events like background X-rays, cosmic rays, and noise in detectors or the electronics. In this work a detailed analysis of the effect of cosmic rays on the detectors is made and it is found that cosmic rays can trigger multiple events which are closely packed in time (called 'bunches'). Higher energy cosmic rays, however, can also generate delayed emissions, a signature previously seen in the PICsIT detector on-board INTEGRAL. An algorithm to automatically detect them based on their spatial clustering properties is presented. Residual noise events are examined using examples of Gamma Ray Bursts as target sources., Comment: 16 pages, 12 figures

We present a machine learning (ML) based method for automated detection of Gamma-Ray Burst (GRB) candidate events in the range 60 keV - 250 keV from the AstroSat Cadmium Zinc Telluride Imager data. We use density-based spatial clustering to detect excess power and carry out an unsupervised hierarchical clustering across all such events to identify the different light curves present in the data. This representation helps understand the instrument's sensitivity to the various GRB populations and identify the major non-astrophysical noise artefacts present in the data. We use Dynamic Time Warping (DTW) to carry out template matching, which ensures the morphological similarity of the detected events with known typical GRB light curves. DTW alleviates the need for a dense template repository often required in matched filtering like searches. The use of a similarity metric facilitates outlier detection suitable for capturing previously unmodelled events. We briefly discuss the characteristics of 35 long GRB candidates detected using the pipeline and show that with minor modifications such as adaptive binning, the method is also sensitive to short GRB events. Augmenting the existing data analysis pipeline with such ML capabilities alleviates the need for extensive manual inspection, enabling quicker response to alerts received from other observatories such as the gravitational-wave detectors., Comment: 9 pages, 7 figures. Matches the published version in MNRAS

The radio as well as the high energy emission mechanism in pulsars is yet not understood properly. A multi-wavelength study is likely to help in better understanding of such processes. The first Indian space-based observatory, ASTROSAT, has five instruments aboard, which cover the electromagnetic spectrum from infra-red (1300 $\AA$) to hard X-ray (380 KeV). Cadmium Zinc Telluride Imager (CZTI), one of the five instruments is a hard X-ray telescope functional over an energy range of 20-380 KeV. We aim to estimate the timing offset introduced in the data acquisition pipeline of the instrument, which will help in time alignment of high energy time series with those from two other ground-based observatories, viz. the Giant Meterwave Radio Telescope (GMRT) and the Ooty Radio Telescope (ORT). PSR B0531+21 is a well-studied pulsar with nearly aligned radio and hard X-ray pulse profiles. We use simultaneous observations of this pulsar with the ASTROSAT, the ORT and the GMRT. The pulsar was especially observed using the ORT with almost daily cadence to obtain good timing solutions. We also supplement the ORT data with archival FERMI data for estimation of timing noise. The timing offset of ASTROSAT instruments was estimated from fits to arrival time data at the ASTROSAT and the radio observatories. We estimate the offset between the GMRT and the ASTROSAT-CZTI to be -4716 $\pm$ 50 $\mu s$. The corresponding offset with the ORT was -29639 $\pm$ 50 $\mu s$. The offsets between the GMRT and Fermi-LAT -5368 $\pm$ 56 $\mu s$. (Abridged), Comment: 6 pages, 5 figures, 2 tables, Revised and Updated, accepted for publication in A&A

AstroStat is an easy-to-use tool for performing statistical analysis on data. It has been designed to be compatible with Virtual Observatory (VO) standards thus enabling it to become an integral part of the currently available collection of VO tools. A user can load data in a variety of formats into AstroStat and perform various statistical tests using a menu driven interface. Behind the scenes, all analysis is done using the public domain statistical software - R and the output returned is presented in a neatly formatted form to the user. The analyses performable include exploratory tests, visualizations, distribution fitting, correlation & causation, hypothesis testing, multivariate analysis and clustering. The tool is available in two versions with identical interface and features - as a web service that can be run using any standard browser and as an offline application. AstroStat will provide an easy-to-use interface which can allow for both fetching data and performing power statistical analysis on them., Comment: Accepted for publication in Astronomy & Computing Journal