Search

Due to population growth and industrial development consumption of non-renewable energy sources, and consequently pollution, has increased. In order to reduce energy utilisation and preserve the environment, developed and developing countries are increasingly trying to find solutions based on renewable energy sources. Cost-effective wastewater treatment methods using solar energy would significantly ensure effective water source utilisation, thereby contributing towards sustainable development goals. In this paper, special emphasis is given to the use of solar energy as the driving force of the process, as well as the use of highly active magnetic TiO2-based catalysts. Therefore, in this study, we investigated the possibility of photocatalytic degradation of aqueous magenta graphic dye using titanium dioxide as a catalyst and DSD model in order to achieve the best process optimisation. TiO2 was successfully coated with magnetic nanoparticles by one step process and characterized using different techniques (BET, SEM/EDS, FTIR, XRD). Based on DSD statistical method optimal reaction conditions were pH = 6.5; dye concentration 100 mg/L; TiO2–Fe3O4 0.6 g/L, at which the highest degree of magenta dye decolourisation was achieved (85%). Application of solar energy coupled with magnetic TiO2 catalyst which could be recovered and reused makes this approach a promising alternative in green wastewater treatment.

This paper examines the impact of the CO2 laser parameters on the tensile strength, which is one of the most important properties of paper packaging in the process of cutting paper material. The study was performed on a paper material sample Fbb Board/Ningbo Spark C1S Ivory Board by examination of the influence of four independent variables: paper material grammage, cutting speed, laser power, and resolution on the tensile strength by using definitive screening design. Optimum process conditions of four variables that maximize the tensile strength were predicted and validated accordingly. Results confirm that laser power, paper material grammage, and cutting speed are the main process parameters that mostly affect the tensile strength. Besides individual parameters, two statistically significant interactions were obtained: laser power and cutting speed, and cutting speed and laser resolution. Maximum tensile strength values (20.37 N/mm) were achieved using the laser power of 60.6%, cutting speed of 3.24%, resolution of 2500 Hz, and a paper material grammage of 326.85 g/m2. With laser power at middle values and at a lower speed, a maximum tensile strength value can be obtained. Increasing the laser power and cutting speed will produce a slight lowering of tensile strength.

This research investigates the potential use of pyrite cinder (PC) as an efficient Fenton-like catalyst for the removal of the reactive azo dye Reactive Red 120 (RR120) from aqueous solutions. The characterization of its PC structure and composition confirmed its great potential to act as catalytic iron source in a heterogeneous Fenton system. Dye removal optimization was performed in terms of PC dosage (0.4–8 g/L), H2O2 concentration (2–25 mM), pH value (2–4.6), initial dye concentration (50–200 mg/L), and mixing time. The highest decolorization efficiency (92%) was achieved after a reaction time of 480 min under following conditions: RR120 = 50 mg/L, PC = 4 g/L, H2O2 = 10 mM, and pH = 3. After decolorization, an extensive analysis of the generated effluent was performed regarding metal leaching, mineralization, toxicity, and degradation product formation. The metal leaching indicated the necessity for a pH increase in order to remove the settled metal hydroxides. The mineralization efficiency was satisfactory, reaching 85% and 62% of the COD and TOC removal, respectively. The respirometry measurements and bioluminescence tests indicated the detoxification of the treated solution. The absorption spectra and GC/MS analysis confirmed the changes in the molecular structure in the form of the destruction of the azo bond, with a simpler aromatic and aliphatic intermediates formation. This study provides an effective method for removing azo dye in polluted water by employing waste tailings as alternative Fenton-like catalysts, while also using waste tailings as the secondary resource.