Search

In this letter we experimentally validate, for the first time, the Stokes space algorithm (SSA) equalizer for space division multiplexing (SDM) transmission systems. We introduce the frequency domain (FD)-SSA and FD least-mean square (FD-LMS) algorithms, and evaluate their performance for different frequency offsets by computer simulations. Our simulations show that FD-SSA is insensitive to the frequency offsets, not requiring carrier frequency estimation (CFE) before equalization (pre-CFE) or carrier phase estimation (CPE) inside the loop (L-CPE). Our experimental results confirm that FD-SSA presents the same performance as FD-LMS, where the required digital signal processing (DSP) stack for FD-SSA is simpler compared to the FDLMS.

In this paper, a new method for the separation of noise categories based on Four-Wave Mixing is presented. The theoretical analysis is grounded in the Gaussian Noise model and verified by split step simulations. The noise categories react differently to the introduced perturbations, by performing a set of perturbations the behaviour of the different categories can be separated by means of a least-square fitting. Given ASE is independent of the induced perturbations, it is possible to separate noise contributions. The analysis includes constant and variable power perturbations. The estimation of the noise categories is discussed from two points of view: NSR evolution post-DSP processing, and over the power spectral density in a notched region. The NSR estimation can only be performed at reception, whereas the power spectral density approach can be performed along the optical link if a high resolution Optical Spectrum Analyzer is available. Additionally, we perform a simple experimental verification considering of two WaveLogic 3 transceivers for the NSR, successfully estimating the noise contributions., Comment: 7 Pages

In this paper, we discuss a new technique for measuring transceiver noise, skew, and for the detection of uncompensated transceiver impairments. The method consists on the introduction of frequency domain notch or notches at the transmitter, which allows to estimate of the Signal-to-Noise and Distortion Ratio (SNDR) at different stages over the transmission chain. The proposed technique requires the detection of the signal spectrum using either: a modem receiver, an Optical Spectrum Analyzer (OSA), an oscilloscope, or an Electrical Spectrum Analyzer (ESA), depending on the stage where the spectrum is measured and requiring minimal processing of the received signal. Our analysis is focused on Ciena's WaveLogic Ai commercial transceiver and a 95 Gbaud DAC. We demonstrate that symmetrically placed frequency domain notches can be used to mitiguate the influence of crosstalk on the SNDR estimates. Finally, we show how a single notch spectrum can be used to detect and compensate for impairments, and we perform skew estimation as an example.

Perturbed spectra are modelled to estimate OSNR for a single channel amplified link. Perturbation-dependent nonlinear noise is separated from constant ASE noise using a set of propagated perturbed spectra. A least mean square fitting is used to estimate OSNR with standard deviation of 0.16 dB., Comment: 5 pages