Search

Vertical temperature profiles influence the wind power generation of large offshore wind farms through stability-dependent effects such as blockage and gravity waves. However, numerical tools that are used to model these effects are often computationally too expensive to cover the large variety of atmospheric states occurring over time. Generally, an informed decision about which representative nonidealized situations to simulate is missing because of the lack of easily available information on representative vertical profiles, taking into account their spatiotemporal variability. Therefore, we present a novel framework that allows a smart selection of vertical temperature profiles. The framework consists of an improved analytical temperature model for the atmospheric boundary layer and lower troposphere, a subsequent clustering of these profiles to identify representatives, and last, a determination of areas with similar spatiotemporal characteristics of vertical profiles. When applying this framework on European ERA5 data, physically realistic representatives were identified for Europe, excluding the Mediterranean. Two or three profiles were found to be dominant for the open ocean, whereas more profiles prevail for land. Over the open ocean, weak temperature gradients in the boundary layer and a clear capping inversions are widespread, and stable profiles are absent except in the region of the East Icelandic Current. Interestingly, according to the ERA5 data, at its resolution, coastal areas and seas surrounded by land behave more similar to the land areas than to the open ocean, implying that a larger set of model integrations are needed for these areas to obtain representative results for offshore wind power assessments in comparison with the open ocean. SIGNIFICANCE STATEMENT: Numerical tools used to simulate the effect of large, offshore wind farms on neighboring farms and the atmosphere are very expensive. Therefore, they can only be computed for a limited number of cases. As temperature is one of the most important parameters in these kinds of simulations, this work provides a new vertical temperature model and an analysis framework that allows for a smart selection of these cases such that they ideally represent the full variation of the atmosphere's temperature profiles. [ABSTRACT FROM AUTHOR]

Reservoir expansion over the last century has largely affected downstream flow characteristics. Yet very little is known about the impacts of reservoir expansion on the climate. Here, we implement reservoir construction in the Community Land Model by enabling dynamical lake area changes, while conserving mass and energy. Transient global lake and reservoir extent are prescribed from the HydroLAKES and Global Reservoir and Dam databases. Land‐only simulations covering the 20th century with reservoir expansion enabled, highlight increases in terrestrial water storage and decreases in albedo matching the increase in open water area. The comparison of coupled simulations including and excluding reservoirs shows only limited influence of reservoirs on global temperatures and the surface energy balance, but demonstrates substantial responses locally, in particular where reservoirs make up a large fraction of the grid cell. In those locations, reservoirs dampen the diurnal temperature range by up to −1.5 K (for reservoirs covering >15% of the grid cell), reduce temperature extremes, and moderate the seasonal temperature cycle. This study provides a first step towards a coupled representation of reservoirs in Earth System Models. Key Points: Global reservoir expansion is implemented in the Community Land Model as growing lakesDuring the 20th century, reservoir expansion increases the terrestrial water storage and decreases the albedoLocally, reservoirs dampen the diurnal temperature range and mute temperature extremes [ABSTRACT FROM AUTHOR]

Belgium is one of the areas within Europe experiencing the highest levels of air pollution. A high-resolution (3 km) modelling experiment is employed to provide guidance to policymakers about expected air quality changes in the near future (2026-2035). The regional air quality model AURORA (Air quality modelling in Urban Regions using an Optimal Resolution Approach), driven by output from a regional climate model, is used to simulate several 10-year time slices to investigate the impact of climatic changes and different emission scenarios on near-surface O3 concentrations, one of the key indices for air quality. Evaluation of the model against measurements from 34 observation stations shows that the AURORA model is capable of reproducing 10-year mean concentrations, daily cycles and spatial patterns. The results for the Representative Concentration Pathways (RCP)4.5 emission scenario indicate that the mean surface O3 concentrations are expected to increase significantly in the near future due to less O3 titration by reduced NOx emissions. Applying an alternative emission scenario for Europe is found to have only a minor impact on the overall concentrations, which are dominated by the background changes. Climate change alone has a much smaller effect on the near-surface O3 concentrations over Belgium than the projected emission changes. The very high horizontal resolution that is used in this study results in much improved spatial correlations and simulated peak concentrations compared to a standard 25 km simulation. An analysis of the number of peak episodes during summer revealed that the emission reductions in RCP4.5 result in a 25% decrease of these peak episodes. [ABSTRACT FROM AUTHOR]

Optically thin ice clouds play an important role in polar regions due to their effect on cloud radiative impact and precipitation on the surface. Cloud bases can be detected by lidar-based ceilometers that run continuously and therefore have the potential to provide basic cloud statistics including cloud frequency, base height and vertical structure. Despite their importance, thin clouds are however not well detected by the standard cloud base detection algorithm of most ceilometers operational at Arctic and Antarctic stations. This paper presents the Polar Threshold (PT) algorithm that was developed to detect optically thin hydrometeor layers (optical depth τ ⩾ 0.01). The PT algorithm detects the first hydrometeor layer in a vertical attenuated backscatter profile exceeding a predefined threshold in combination with noise reduction and averaging procedures. The optimal backscatter threshold of 3×10-4 km-1 sr-1 for cloud base detection was objectively derived based on a sensitivity analysis using data from Princess Elisabeth, Antarctica and Summit, Greenland. The algorithm defines cloudy conditions as any atmospheric profile containing a hydrometeor layer at least 50m thick. A comparison with relative humidity measurements from radiosondes at Summit illustrates the algorithm's ability to significantly differentiate between clear sky and cloudy conditions. Analysis of the cloud statistics derived from the PT algorithm indicates a year-round monthly mean cloud cover fraction of 72% at Summit without a seasonal cycle. The occurrence of optically thick layers, indicating the presence of supercooled liquid, shows a seasonal cycle at Summit with a monthly mean summer peak of 40 %. The monthly mean cloud occurrence frequency in summer at Princess Elisabeth is 47 %, which reduces to 14% for supercooled liquid cloud layers. Our analyses furthermore illustrate the importance of optically thin hydrometeor layers 25 located near the surface for both sites, with 87% of all detections below 500m for Summit and 80% below 2 km for Princess Elisabeth. These results have implications for using satellite-based remotely sensed cloud observations, like CloudSat, that may be insensitive for hydrometeors near the surface. The results of this study highlight the potential of the PT algorithm to extract information in polar regions about a wide range of hydrometeor types from measurements by the robust and relatively low-cost ceilometer instrument. [ABSTRACT FROM AUTHOR]

The ability of the one-dimensional lake model FLake to represent the mixolimnion temperatures for tropical conditions was tested for three locations in East Africa: Lake Kivu, Lake Tanganyika's northern and southern basins. Meteorological observations from surrounding Automatic Weather Stations were corrected and used to drive FLake, whereas a comprehensive set of water temperature profiles served to evaluate the model at each site. Careful forcing data correction and model configuration allowed to reproduce the observed mixed layer seasonality at Lake Kivu and Lake Tanganyika (northern and southern basins), with correct representation of both the mixed layer depth and temperature structure. At Lake Kivu, mixolimnion temperatures predicted by FLake were found sensitive both to minimal variations in the external parameters (lake depth and water transparency) as to small changes in the meteorological driving data, in particular wind velocity. In each case, small modifications may already lead to a regime switch from the correctly represented seasonal mixed layer deepening to either completely mixed (down to the model lake bottom) or permanently stratified (from ~10m downwards) conditions. In contrast, model temperatures are found robust close to the surface, with acceptable predictions of near-surface water temperatures even when the seasonal mixing regime is not reproduced. FLake can thus be a suitable tool to parameterize tropical lake water surface temperatures within atmospheric predictionmodels, but may be less appropriate, in its current form, to study complex limnological processes within tropical lakes. Furthermore, a study of different initial conditions showed that for tropical lakes lacking reliable initial data, a fully mixed, artificially warm initialisation is to be preferred, but only if the model is allowed to spin up until convergence is reached. Finally, FLake was used to attribute the seasonal mixing cycleat Lake Kivu to variations in the near-surface meteorological conditions. It was found that the annual mixing down to 60m during the main dry season is primarily due to enhanced lake evaporation and secondarily due to the decreased incoming long wave radiation, both causing a significant heat loss from the lake surface and associated mixolimnion cooling. [ABSTRACT FROM AUTHOR]

The urban heat island (UHI) over Paris during summer 2006 was simulated using the Advanced Regional Prediction System (ARPS) updated with a simple urban parametrization at a horizontal resolution of 1 km. Two integrations were performed, one with the urban land cover of Paris and another in which Paris was replaced by cropland. The focus is on a five-day clear-sky period, for which the UHI intensity reaches its maximum. The diurnal evolution of the UHI intensity was found to be adequately simulated for this five day period. The maximum difference at night in 2-m temperature between urban and rural areas stemming from the urban heating is reproduced with a relative error of less than 10%. The UHI has an ellipsoidal shape and stretches along the prevailing wind direction. The maximum UHI intensity of 6.1 K occurs at 23:00UTC located 6 km downstream of the city centre and this largely remains during the whole night. An idealized one-column model study demonstrates that the nocturnal differential sensible heat flux, even though much smaller than its daytime value, is mainly responsible for the maximum UHI intensity. The reason for this nighttime maximum is that additional heat is only affecting a shallow layer of 150m. At the same time, an idealized study shows that the orography around the city of Paris induces an uplift. This leads to a considerable nocturnal adiabatic cooling over cropland. In contrast, this uplift has little effect on the mixed-layer temperature over the city. About twenty percent of the total maximum UHI intensity is estimated to be caused by this uplift. [ABSTRACT FROM AUTHOR]

In spite of the strict EU regulations, concentrations of surface ozone and PM10 often exceed the pollution standards for the Netherlands and Europe. Their concentrations are controlled by (precursor) emissions, social and economic developments and a complex combination of meteorological actors. This study tackles the latter, and provides insight in the meteorological processes that play a role in O3 and PM10 levels in rural mid-latitudes sites in the Netherlands. The relations between meteorological actors and air quality are studied on a local scale based on observations from four rural sites and are determined by a comprehensive correlation analysis and a multiple regression (MLR) analysis in 2 modes, with and without air quality variables as predictors. Furthermore, the objective Lamb Weather Type approach is used to assess the influence of the large-scale circulation on air quality. Keeping in mind its future use in downscaling future climate scenarios for air quality purposes, special emphasis is given to an appropriate selection of the regressor variables readily available from operational meteorological forecasts or AOGCMs (Atmosphere-Ocean coupled General Circulation Models). The regression models perform satisfactory, especially for O3, with an R2 of 57.0% and 25.0% for PM10. Including previous day air quality information increases significantly the models performance by 15% (O3) and 18% (PM10). The Lamb weather types show a seasonal distinct pattern for high (low) episodes of average O3 and PM10 concentrations, and these are clear related with the meteorology-air quality correlation analysis. Although using a circulation type approach can provide important additional physical relations forward, our analysis reveals the circulation method is limited in terms of short-term air quality forecast for both O3 and PM10 (R2 between 0.12 and 23%). In summary, it is concluded that the use of a regression model is more promising for short-term downscaling from climate scenarios than the use of a weather type classification approach. [ABSTRACT FROM AUTHOR]