Search

Broken stems are particularly challenging in revision hip arthroplasty, as no standard extraction instruments fit anymore. Well-integrated uncemented stem remnants can be particularly arduous to remove. Stem fatigue failure is not rare with modular stems. Since these are particularly useful in revision hip arthroplasty, increasing numbers of broken stems are to be expected. Usually applied techniques using cortical fenestration distally to the tip of the stem or using an extended transfemoral approach cause supplementary bone defects impairing reconstruction. We present a relatively simple and reproducible revision technique, using a limited standard approach and only regular orthopedic instruments, to extract the remnants of broken uncemented femoral stems in hip arthroplasty. This technique was applied successfully and without complications in 6 cases, permitting eventually the reimplantation of even shorter stems.

Introduction Fracture of the femoral stem is the cause of ~1 % of revisions after total hip arthroplasty. The risk increases intrinsically with modularity, whereby modularity is particularly useful in revision arthroplasty. We present 7 cases of failure of a specific modular, tapered, fluted, titanium alloy Revitan stem and analyse the different failure modes. Methods Retrospective review of all Revitan stems revised at our institutions due to implant failure and analysis of clinical presentation, diagnostic workup, and failure mode. The retrieved components were analyzed by optical and scanning electron microscopy. Results A total of 7 cases were included. There was a significant time lag between symptom onset and correct diagnosis. Conventional radiographs and low-dose CT scans (CT scout imaging) were decisive for diagnosis. All failures occurred at the level of the connection between the proximal component and the distal part of the stem. Three different failure modes were identified: loosening of the proximal component, fatigue fracture of the connection pin, and distal loosening of the connection pin. No alterations of the microstructure or deviation from manufacturing specifications regarding dimensions were observed. Failure was caused by mechanical overload. Conclusion Conventional radiographs are the mainstay in identifying failed modular stems. Repeated radiographs and low-dose CT scans may be helpful additions. No single modification of the connection will address all possible failure modes. Modularity of revision stems offers advantages up until insertion of the definitive stem. Monoblock definitive stems might overcome the potential mechanical weaknesses of modularity and should be considered in relatively young, heavy and active patients.

Objective: We evaluated the mid-term results of the right axillary incision used for the repair of various congenital heart defects. Methods: All the patients who were operated with this incision between March 2001 and December 2007 were reviewed. There were 123 patients (median age 4.7 {0.4—19.4} years and median weight 16.6 {3.8—62} kg) undergoing atrial septal defect (ASD) closure (62), repair of partial anomalous pulmonary venous connection (PAPVC) (22), correction of partial atrioventricular septal defect (AVSD) (19), and restrictive perimembranous ventricular septal defect (VSD) (20). Additional procedures involved tricuspid valve plasty (10), mitral annuloplasty (3), reduction plasty of the aortic sinus (2), resuspension of the aortic valve cusp (2), sub aortic membrane resection (1), or reimplantation of Scimitar vein (1). The surgical technique involved peripheral (groin) and central (SVC aorta) cannulation for institution of cardiopulmonary bypass. Fibrillatory arrest was used for repair of ASDs and cardioplegic arrest for repairs involving the atrioventricular valves as well as VSDs. The median CPB and aortic clamp times were 72 (35—232) and 0 (0—126) min, respectively. Results: There was no need for conversion to another approach in any patient. Early morbidity included transient paresis of left upper arm (1), stenting of SVC after repair of a sinus venosus defect (1) and revision for bleeding (1). Follow-up echo showed no residual defect in 116 patients and minor residual defects in 7 patients: tiny ASD (2), tiny VSD (1) and mitral regurgitation (4). One patient developed stenosis in the right external iliac artery used for cannulation, necessitating surgical intervention. All the patients are in excellent condition after a median follow-up of 4.1 (0.4—7.1) years. The incision healed well and the thorax and the breast showed no deformity on follow-up. Conclusions: The right axillary incision provides a quality of repair for various congenital defects similar to that obtained by using standard surgical approaches. Because of its deceitful location, and the camouflaging effect of being hidden by the resting arm, it has superior cosmetic appeal compared to conventional incisions. The incision does not interfere with subsequent development of the thorax or the breast (in case of females). # 2009 European Association for Cardio-Thoracic Surgery. Published by Elsevier B.V. All rights reserved.