Search

The research of the influence of housing material on operation temperature of the idler bearing assembly is presented in this paper. Several radial loads and rotary speeds were applied to the test bench to determine the transient temperature field. The results were monitored and recorded for the whole period until the temperature of the assembly reached stationary stage. The FEM model was created where the rolling elements were replaced with the especially designed artificial body, having the shape of irregular ring. It generates heat and connects only those points of the inner and outer ring which are in operating conditions connected with the rolling elements. The experimental results are compared with FEM results. The conclusion is given on suitability of polymer material for this purpose. [ABSTRACT FROM AUTHOR]

The thermal management of a complex electro-optical system aimed for outdoor application is challenging task due to the requirement of having an air-sealed enclosure, harsh working environment, and an additional thermal load generated by sunlight. It is essential to consider the effect of heating loads in the system components, as well as the internal temperature distribution, that can have influence on the system life expectancy, operational readiness and parameters, and possibility for catastrophic failure. The main objective of this paper is to analyze internal temperature distribution and evaluate its influence on system component operation capability. The electro-optical system simplified model was defined and related thermal balance simulation model based on Solid Works thermal analysis module was set and applied for temperature distribution calculation. Various outdoor environment scenarios were compared to evaluate system temperature distribution and evaluate its influence on system operation, reliability, and life time in application environment. This work was done during the design process as a part of the electro-optical system optimization. The results show that temperature distribution will not be cause for catastrophic failure and malfunction operation during operation in the expected environment. [ABSTRACT FROM AUTHOR]

Thick walled components such as high pressure (HP) steam turbine casings operating under high parameter conditions are subjected to a complex stress state. As a result of that stress state, some parts of HP turbine casing undergo to the creep fatigue caused by the combination of thermal fatigue resulted from repeated start/stop operation and the creep which occurs during long-term operation at high temperature and high-pressure. It is well known that domestic thermal power plants have been in use over 100000 h which means that significant cost is required not only for maintenance, but often for renewal of equipment. Based on comprehensive investigation, the results of residual life assessment of one high pressure steam turbine casing, which belongs to the older turbine generation, taking into account simultaneous action of thermal fatigue and creep, are presented in this paper. Also, the critical flaw crack size of HP turbine casing is determined because this parameter has a strong influence on casing integrity and residual life. The results of residual life assessment provide not only a basis for further maintenance, but also estimated time for reparation or renewal. [ABSTRACT FROM AUTHOR]