Search

Deep tissue injury (DTI) is a potentially life-threatening form of pressure ulcer that onsets in muscle tissue overlying bony prominences and progresses unnoticeably to more superficial tissues. To minimize DTI, the efficacy of wheelchair cushions should be evaluated not only based on their performance in redistributing interface pressures but also according to their effects on stress concentrations in deep tissues, particularly muscles. However, a standard bioengineering approach for such analyses is missing in literature. The goals of this study were to develop an algorithm to couple finite element (FE) modeling of the buttocks with an injury threshold for skeletal muscle and with a damage-stiffening law for injured muscle tissue, from previous animal experiments, to predict DTI onset and progression for different patient anatomies and wheelchair cushions. The algorithm was also employed for identifying intrinsic (anatomical) biomechanical risk factors for DTI onset. A set of three-dimensional FE models of seated human buttocks was developed, representing different severities of pathoanatomical changes observed in chronically sitting patients: muscle atrophy and 'flattening' of the ischial tuberosity (IT). These models were then tested with cushions Of different stiffnesses representing products available on the market and semirigid supports. Outcome measures were the percentage of damaged muscle tissue volumes after 90 min and 110 min of simulated continuous immobilized sitting as well as muscle injury rates post-60 min, -90 min, and -110 min of continuous sitting. Damaged muscle volumes grew exponentially with the level of muscle atrophy. For example, simulation of a subject with 70% muscle atrophy sitting on a soft cushion showed damage to 33% of the muscle volume after 90 min of immobilized sitting, whereas a comparable simulation with a nonatrophied muscle yielded only 0.4% damaged tissue volume. The rates of DTI progression also increased substantially with increasing severities of muscle atrophy, e.g., 70% atrophy resulted in 8.9, 2.7, and 1.6 times greater injury rates compared with the 'reference' muscle thickness cases, after 60 min, 90 min, and 110 min of sitting, respectively. Across all simulation cases, muscle injury rate was higher when a 'flatter' IT was simulated. Stiffer cushions increased both the extent and rate of DTI at times shorter than 90 min of continuous sitting, but after 110 min, volumes and rates of tissue damage converged to approximately similar values across the different cushion materials. The present methodology is a practical tool for evaluating the performances of cushions in reducing the risk for DTI in a manner that goes far beyond the commonly accepted measurements of sitting pressures. [DOI: 10.1115/1.3005195] Keywords: pressure ulcer, decubitus, bedsore, wheelchair cushions, rehabilitation

Background: The management of soft tissue balance during surgery is essential for the success of total knee arthroplasty (TKA) but remains difficult, leaving it much to the surgeon's feel. Previous assessments for soft tissue balance have been performed under unphysiological joint conditions, with patellar eversion and without the prosthesis only at extension and 90 deg of flexion. We therefore developed a new tensor for TKA procedures, enabling soft tissue balance assessment throughout the range of motion while reproducing postoperative joint alignment with the patellofemoral (PF) joint reduced and the tibiofemoral joint aligned. Our purpose in the present study was to clarify joint gap kinematics using the tensor with the CT-free computer assisted navigation system. Method of Approach: Joint gap kinematics, defined as joint gap change during knee motion, was evaluated during 30 consecutive, primary posterior-stabilized (PS) TKA with the navigation system in 30 osteoarthritic patients. Measurements were performed using a newly developed tensor, which enabled the measurement of the joint gap throughout the range of motion, including the joint conditions relevant after TKA with PF joint reduced and trial femoral component in place. Joint gap was assessed by the tensor at full extension, 5 deg, 10 deg, 15 deg, 30 deg, 45 deg, 60 deg, 90 deg, and 135 deg of flexion with the patella both everted and reduced. The navigation system was used to obtain the accuracy of implantations and to measure an accurate flexion angle of the knee during the intraoperative joint gap measurement. Results: Results showed that the joint gap varied depending on the knee flexion angle. Joint gap showed an accelerated decrease during full knee extension. With the PF joint everted, the joint gap increased throughout knee flexion. In contrast, the joint gap with the PF joint reduced increased with knee flexion but decreased after 60 deg of flexion. Conclusions: We clarified the characteristics of joint gap kinematics in PS TKA under physiological and reproducible joint conditions. Our findings can provide useful information for prosthetic design and selection and allow evaluation of surgical technique throughout the range of knee motion that may lead to consistent clinical outcomes after TKA. [DOI: 10.1115/1.2354201]