Search

Here, we review the efficient removal of organic micropollutants from water by degradation during filtration using specialized bacteria and enzymes. In both approaches, the filter provides essential binding sites where efficient degradation can occur. A model is presented that enables the simulation and prediction of the kinetics of filtration for a given pollutant concentration, flow rate, and filter dimensions and can facilitate the design of experiments and capacity estimates; it predicts the establishment of a steady state, during which the emerging concentrations of the pollutants remain constant. One method to remove cyanotoxins produced by Microcystis cyanobacteria, which pose a threat at concentrations above 1.0 µg L−1, is to use an activated granular carbon filter with a biofilm; this method resulted in the complete removal of the filtered toxins (5 µg L−1) during a long experiment (225 d). This system was analyzed using a model which predicted complete toxin removal when applied at a 10-fold-higher concentration. Enzymes are also used in filtration processes for the degradation of trace organic contaminants, mostly through the use of membrane bioreactors, where the enzyme is continuously introduced or maintained in the bioreactor, or it is immobilized on the membrane.

The efficiency in water treatment by granulated complexes formed from the clay bentonite with (i) micelles of the cations of octadecyltrimethyl-ammonium (ODTMA) or (ii) liposomes of didodecyldimethyl-ammonium (DDAB) was investigated. The bentonite–ODTMA complexes were synthesized in three variations: I. mass ratio of 68/32, which resulted in an excess of positive charge of half of the clay cation exchange capacity and is denoted “ordinary”; II. complexes having higher loads of ODTMA, denoted “enriched”; and III. “neutral”. These variations were designed to optimize the efficiency and reduce the costs of water treatment. “Ordinary” and “neutral” complexes of DDAB were also synthesized. The “ordinary” complex of ODTMA was shown to be efficient in the removal of anionic/hydrophobic molecules and bacteria. The “enriched” complexes were more active in removal of bacteria from water by filtration due to the higher release of free ODTMA cations, which causes biostatic/biocidal effects. The corresponding “ordinary” and “neutral” complexes of ODTMA and DDAB yielded the same efficiency in removal from water of the neutral and hydrophobic herbicides, S-metolachlor (i) and alachlor (ii), respectively. Model calculations, which considered sorption/desorption and convection yielded simulations and predictions of filtration results of the herbicides. The neutral complexes are advantageous since their production saves about 1/3 of the amount of ODTMA or DDAB, which constitutes the expensive component in the respective composite.

This review deals with modification of montmorillonite and other clay-minerals and clays by interacting them with organic cations, for producing slow release formulations of herbicides, and efficient removal of pollutants from water by filtration. Elaboration is on incorporating initially the organic cations in micelles and liposomes, then producing complexes denoted micelle- or liposome-clay nano-particles. The material characteristics (XRD, Freeze-fracture electron microscopy, adsorption) of the micelle– or liposome–clay complexes are different from those of a complex of the same composition (organo-clay), which is formed by interaction of monomers of the surfactant with the clay-mineral, or clay. The resulting complexes have a large surface area per weight; they include large hydrophobic parts and (in many cases) have excess of a positive charge. The organo-clays formed by preadsorbing organic cations with long alkyl chains were also addressed for adsorption and slow release of herbicides. Another examined approach includes “adsorptive” clays modified by small quaternary cations, in which the adsorbed organic cation may open the clay layers, and consequently yield a high exposure of the siloxane surface for adsorption of organic compounds. Small scale and field experiments demonstrated that slow release formulations of herbicides prepared by the new complexes enabled reduced contamination of ground water due to leaching, and exhibited enhanced herbicidal activity. Pollutants removed efficiently from water by the new complexes include (i) hydrophobic and anionic organic molecules, such as herbicides, dissolved organic matter; pharmaceuticals, such as antibiotics and non-steroidal drugs; (ii) inorganic anions, e.g., perchlorate and (iii) microorganisms, such as bacteria, including cyanobacteria (and their toxins). Model calculations of adsorption and kinetics of filtration, and estimation of capacities accompany the survey of results and their discussion.

Granulated micelle–clay complexes including the organic cation octadecyltrimethylammonium (ODTMA) were shown to be efficient in removal of total bacteria count (TBC) from water. Microwave (MW) heating of granules to restore bacterial removal was investigated. Drying of granules by MW required 20-fold less energy than by conventional heating. When water content of granules approached 10%, or less, their heating period by MW had to be below 1 min, e.g., 30 s, and less, in order to avoid ignition and irreversible structural changes. Structural and thermal properties of MW heated samples were studied by FT-IR spectra and thermo gravimetric analyses (TGA). Inactivation of bacteria in water was more efficient by MW than by conventional oven, or by electric plate. For elimination of bacteria from water, MW heating was at least five-fold more efficient than by conventional heating. The results have established an adequate regeneration procedure by MW heating at durations depending on the remaining percentage of water associated with the granules. Tests of first and second regenerations by MW heating, and HCl washing of columns, were carried out. It was concluded that MW treatment may be chosen for optimal regeneration of the granulated micelle–clay complex as an efficient and low-cost procedure.

Objective: To evaluate the historical descriptive origins of the extracranial transnasal transsphenoidal route to the sphenoid sinus and sella turcica focusing on the works of two otolaryngologists: Markus Hajek (1861–1941) and Oskar Hirsch (1877–1965). Data Sources: A collection of primary references of author publications, and contemporary references and textbooks. Review Methods: Primary references were reviewed with specific focus on surgical routes to the sphenoid sinus and sella turcica. Chronology was cross‐referenced with contemporary publications by contemporaries. Translations from German were conducted by author AM when necessary. Results: Markus Hajek elegantly described the surgical approach to the posterior ethmoids and sphenoid sinus in 1904 using a transnasal route. Building on this foundation, Oskar Hirsch described the fully extracranial endonasal transethmoid transsphenoidal approach in 1909. He was first to describe surgical entrance to the sella using this exclusively unilateral endonasal route, which he demonstrated on a cadaver. He reports performing this procedure on a live patient in April, 1910, under local anesthesia in stages over 5 weeks. For better exposure, Hirsch consolidated his method with Killian's submucosal window resection of the posterior nasal septum allowing for bilateral access to the sphenoid sinus and sella, and completed a single stage procedure on a patient in June 1910. Conclusion: Oskar Hirsch was the first to describe and perform a stepwise surgical approach to the sella using an exclusively extracranial, endonasal, transethmoid, and transsphenoidal approach. He built upon his mentor Markus Hajek's approaches to the posterior ethmoid cells and sphenoid sinus. Level of Evidence: NA: Background information, synthesis from multiple sources emphasizing factual information Laryngoscope, 133:807–813, 2023 [ABSTRACT FROM AUTHOR]