Search

In this research work, surface-modified nano zerovalent copper (nZVC) was prepared using a simple borohydride reduction method. The spectroscopic and crystallographic results revealed the successful synthesis of surface-modified nano zerovalent copper (nZVC) using solvents such as ethanol (ETOH), ethylene glycol (EG) and tween80 (T80). The as-synthesized material was fully characterized for morphological surface and crystal structural properties. The results indicated that EG provides an excellent synthesis environment to nZVC compared to ETOH and T80 in terms of good dispersion, high surface area and excellent catalytic properties. The catalytic efficiency of nZVC/EG was investigated alone and with peroxymonosulphate (PMS) in the absence of light. The degradation results demonstrated that the involvement of PMS synergistically boosted the catalytic efficiency of synthesized nZVC/EG material. Furthermore, the degradation products (DPs) of CBZ were determined by GC−MS and subsequently, the degradation pathways were proposed. The ecotoxicity analysis of the DPs was also explored. The proposed (nZVC/EG/PMS) system is economical and efficient and thus could be applied for the degradation of CBZ from an aquatic system after altering the degradation pathways in such a way that results in harmless products. [ABSTRACT FROM AUTHOR]

Chromium (Cr), due to its greater contamination in aquifers and distinct eco-toxic impacts, is of greater environmental concern. This study aimed to synthesize nanocomposites of almond shells biochar (BC) with zerovalent bismuth and/or copper (Bi0/BC, Cu0/BC, and Bi0–Cu0/BC) for the removal of Cr from aqueous solution. The synthesized nanocomposites were investigated using various characterization techniques such as XRD, FTIR spectroscopy, SEM, and EDX. The Cr removal potential by the nanocomposites was explored under different Cr concentrations (25–100 mg/L), adsorbent doses (0.5–2.0 g/L), solution pH (2–8), and contact time (10–160 min). The above-mentioned advanced techniques verified successful formation of Bi0/Cu0 and their composite with BC. The synthesized nanocomposites were highly effective in the removal of Cr. The Bi0–Cu0/BC nano-biocomposites showed higher Cr removal efficiency (92%) compared to Cu0/BC (85%), Bi0/BC (76%), and BC (67%). The prepared nanocomposites led to effective Cr removal at lower Cr concentrations (25 mg/L) and acidic pH (4.0). The Cr solubility changes with pH, resulting in different degrees of Cr removal by Bi0–Cu0/BC, with Cr(VI) being more soluble and easier to adsorb at low pH levels and Cr(III) being less soluble and more difficult to adsorb at high pH levels. The experimental Cr adsorption well fitted with the Freundlich adsorption isotherm model (R2 > 0.99) and pseudo-second-order kinetic model. Among the prepared nanocomposites, the Bi0–Cu0/BC showed greater stability and reusability. It was established that the as-synthesized Bi0–Cu0/BC nano-biocomposite showed excellent adsorption potential for practical Cr removal from contaminated water. [ABSTRACT FROM AUTHOR]

Batch scale removal of arsenic (As) from aqueous media was explored using nano-zero valent iron (Fe0) and copper (Cu0) particles. The synthesized particles were characterized using a Brunauer-Emmett–Teller (BET) surface area analyzer, a scanning electron microscope (SEM), and Fourier transform infrared spectroscopy (FTIR). The BET result showed that the surface area (31.5 m2/g) and pore volume (0.0415 cm3/g) of synthesized Fe0 were higher than the surface area (17.56 m2/g) and pore volume (0.0287 cm3/g) of Cu0. The SEM results showed that the morphology of the Fe0 and Cu0 was flowery microspheres and highly agglomerated with thin flakes. The FTIR spectra for Fe0 showed broad and intense peaks as compared to Cu0. The effects of the adsorbent dose (1–4 g/L), initial concentration of As (2 mg/L to 10 mg/L) and solution pH (2–12) were evaluated on the removal of As. Results revealed that effective removal of As was obtained at pH 4 with Fe0 (94.95%) and Cu0 (74.86%). When the dosage increased from 1 to 4 g L−1, the As removal increased from 70.59 to 93.02% with Fe0 and from 67 to 70.59% with Cu0. However, increasing the initial As concentration decreased the As removal significantly. Health risk indices, including estimated daily intake (EDI), hazard quotient (HQ), and cancer risk (CR) were employed and a significant decline (up to 99%) in risk indices was observed in As-treated water using Fe0/Cu0. Among the adsorption isotherm models, the values of R2 showed that isothermal As adsorption by Fe0 and Cu0 was well explained by the Freundlich adsorption isotherm model (R2 > 0.98) while the kinetic experimental data was well-fitted with the Pseudo second order model. The Fe0 showed excellent stability and reusability over five sorption cycles, and it was concluded that, compared to the Cu0, the Fe0 could be a promising technology for remediating As-contaminated groundwater. [ABSTRACT FROM AUTHOR]

In the current study, magnetic oxide nanoparticle-impregnated tea waste (TW-Fe3O4) is employed as an adsorbent to remove phosphate ions (PO43−) from an aqueous solution. By utilizing a variety of analytical methods, the TW-Fe3O4 nano-adsorbent was characterized by FE-SEM, TEM, EDX, BET, FTIR and XRD. The FE-SEM of TW-Fe3O4 demonstrated the adsorbent's granular morphology with a variety of magnetic nanoparticle sizes and shapes. The XRD of TW-Fe3O4 showed two diffraction peaks at 2θ values 30.9° and 35.4°, which are in correspondence with the diffraction pattern of magnetite. The synthesis of a TW-Fe3O4 adsorbent with a greater surface area and porosity was demonstrated by BET analysis. Numerous adsorption factors like initial concentration of PO43− ion, pH of the medium, contact time, temperature and adsorbent dose were optimized for phosphate removal. The maximum removal of 92% was achieved by using the adsorbent dose of 1.2 g at 323 K (pH 5). Pseudo-second-order and intra-particle diffusion models were fitted to the sorption kinetic, whereas adsorption isotherm data were found well fitted to Freundlich and Dubinin–Radushkevich (D-R) models. The highest adsorption capacity of TW-Fe3O4 towards phosphate ions was 226.8 mg/g, which is significantly higher than other reported bio-adsorbents. According to thermodynamic data, phosphate adsorption at the solid–liquid interface was of an endothermic and spontaneous nature and characterized by enhanced inevitability. [ABSTRACT FROM AUTHOR]