Search

Proper traffic simulation of electric vehicles, which draw energy from overhead wires, requires adequate modeling of traction infrastructure. Such vehicles include trains, trams or trolleybuses. Since the requested power demands depend on a traffic situation, the overhead wire DC electrical circuit is associated with a non-linear power flow problem. Although the Newton-Raphson method is well-known and widely accepted for seeking its solution, the existence of such a solution is not guaranteed. Particularly in situations where the vehicle power demands are too high (during acceleration), the solution of the studied problem may not exist. To deal with such cases, we introduce a numerical method which seeks maximal suppliable power demands for which the solution exists. This corresponds to introducing a scaling parameter to reduce the demanded power. The interpretation of the scaling parameter is the amount of energy which is absent in the system, and which needs to be provided by external sources such as on-board batteries. We propose an efficient two-stage algorithm to find the optimal scaling parameter and the resulting potentials in the overhead wire network. We perform a comparison with a naive approach and present a real-world simulation of part of the Pilsen city in the Czech Republic. These simulations are performed in the traffic micro-simulator SUMO, a popular open-source traffic simulation platform., Comment: 17 pages, 6 figures, 1 table. Submitted to Applications of Mathematics

Accurate knowledge of temperatures in power semiconductor modules is crucial for proper thermal management of such devices. Precise prediction of temperatures allows to operate the system at the physical limit of the device avoiding undesirable over-temperatures and thus improve reliability of the module. Commonly used thermal models can be based on detailed expert knowledge of the device's physical structure or on precise and complete temperature distribution measurements. The latter approach is more often used in the industry. Recently, we have proposed a linear time invariant state-space thermal model based on a compartment representation and its identification procedure that is based on the Expectation-Maximization algorithm from incomplete temperature data. However, the model still requires to measure temperatures of all active elements. In this contribution, we aim to relax the need for all measurements. Therefore, we replace the previous dark gray-box approach with a structured compartment model. The structure of the model is designed by a mesh-based discretization of the physical layout of the module. All compartments are assumed to share parameters that are identified from the data of the measured elements. Temperatures of the unmeasured elements are predicted using the shared parameters. Identification of the parameters is possible only with suitable regularization due to limited amount of the data. In particular, the model tightening is accomplished by sharing parameters among compartments and by constraining the process covariance matrix of the model in this contribution. Applicability of the proposed identification procedure is discussed in terms of growing state-space and therefore speeding up of the identification algorithm is suggested. Performance of the proposed approach is tested and demonstrated on simulated data., Comment: conference paper under review - conference ICIPE 20