Search

We experimentally demonstrate the first carrier- and LO-free 800G/{\lambda} receiver enabling direct compatibility with standard coherent transmitters via phase retrieval, achieving net 835-Gb/s transmission over 100-km SMF and record 8.27-b/s/Hz net optical spectral efficiency., Comment: 3 pages, 3 figures

We experimentally investigate transmitting high-order quadrature amplitude modulation (QAM) signals with carrierless and intensity-only measurements with phase retrieval (PR) receiving techniques. The intensity errors during measurement, including noise and distortions, are found to be a limiting factor for the precise convergence of the PR algorithm. To improve the PR reconstruction accuracy, we propose a distortion-aware PR scheme comprising both training and reconstruction stages. By estimating and emulating the distortion caused by various channel impairments, the proposed scheme enables enhanced agreement between the estimated and measured amplitudes throughout the PR iteration, thus resulting in improved reconstruction performance to support high-order QAM transmission. With the aid of proposed techniques, we experimentally demonstrate 50-GBaud 16QAM and 32QAM signals transmitting through a standard single-mode optical fiber (SSMF) span of 40 and 80 km, and achieve bit error rates (BERs) below the 6.25% hard decision (HD)-forward error correction (FEC) and 25% soft decision (SD)-FEC thresholds for the two modulation formats, respectively. By tuning the pilot symbol ratio and applying concatenated coding, we also demonstrate that a post-FEC data rate of up to 140 Gb/s can be achieved for both distances at an optimal pilot symbol ratio of 20%., Comment: 12 pages, 12 figures

We propose and implement a novel fibre sensing control device and associated sensing control plane that effectively controls backscatter and polarization-based fibre sensing. We experimentally demonstrate in a fibre network that this device and associated control plane can achieve sub-us response time.

We experimentally demonstrate optical detection at 12.5~bits per incident photon, 9.4~dB higher than the theoretical limit of conventional coherent detection. A single laser transmits both data and optical clock, undergoes 77~dB of attenuation before quantum detection followed by optical clock and data recovery.

We monitor a 524km live network link using an FPGA-based sensing-capable coherent transceiver prototype during a human-caused cable break. Post-analysis of polarization data reveals minute-level potential warning precursors and baseline-exceeding changes directly preceding the break., Comment: 3 pages

We demonstrate the digital twin of a network, network elements, and operating environment using machine learning. We achieve network card failure localization and remote collaboration over 86 km of fiber using augmented reality.

In this work we demonstrate an FPGA-based coherent optical frequency domain reflectometry setup for cable monitoring. Using coherent detection for averaging and narrowband filtering, we significantly improve the signal-to-noise ratio (SNR) compared to traditional intensity-only techniques while also enabling continuous monitoring of phase and polarization. In addition, the probe signal has constant power, avoiding the nonlinear distortions and thereby enabling continuous use without interfering with data channels. We perform a field demonstration over a trans-oceanic cable using loopback configurations present in each repeater, demonstrating measurement SNR exceeding 30 dB for all about 80 repeaters with an averaging window of 1 second. We furthermore compare cable monitoring using coherent processing to today's solutions using power-only measurements. Our results show how transitioning to coherent technology for cable monitoring can improve sensitivity and enable new types of monitoring, exploring knowledge gained from transitioning from incoherent to coherent data transmission., Comment: 9 pages, 7 figures. Published at Suboptic2023

Off-axis digital holography is used to align a few-mode fiber to a multi-mode fiber in a free-space optical setup. Alignment based on power coupling measurements alone cannot guarantee low mode-dependent loss. The proposed alignment method enables reliable fiber coupling with low mode-dependent loss and crosstalk., Comment: Accepted for presentation at ECOC 2022

Angular resolved digital holography is presented as a technique for real-time characterization of the full optical field (amplitude and phase) of space-division multiplexing components and fibers, here a 6-mode photonic-lantern is characterized., Comment: Demo zone paper to be presented at the 2022 Optical Fiber Communication Conference (OFC), March 7, 2022 from 2:00 PM to 4:15 PM PST

The increase in capacity provided by coupled SDM systems is fundamentally limited by MDG and ASE noise. Therefore, monitoring MDG and optical SNR is essential for accurate performance evaluation and troubleshooting. Recent works show that the conventional MDG estimation method based on the transfer matrix of MIMO equalizers optimizing the MMSE underestimates the actual value at low SNR. Besides, estimating the optical SNR itself is not a trivial task in SDM systems, as MDG strongly influences the electrical SNR after the equalizer. In a recent work we propose an MDG and SNR estimation method using ANN. The proposed ANN-based method processes features extracted at the receiver after DSP. In this paper, we discuss the ANN-based method in detail, and validate it in an experimental 73-km 3-mode transmission link with controlled MDG and SNR. After validation, we apply the method in a case study consisting of an experimental long-haul 6-mode link. The results show that the ANN estimates both MDG and SNR with high accuracy, outperforming conventional methods., Comment: Submitted to JLT, currently under review

Time-of-flight measurements are key to study distributed mode coupling and differential mode group delay (DMDG) in multimode fibers (MMFs). However, current approaches using regular photodetectors with limited sensitivity preclude the detection of weak modal interactions in such fibers masking interesting physical effects. Here we demonstrate the use of high-sensitivity superconducting nanowire single-photon detectors (SNSPDs) to measure the mode transfer matrix of a commercial graded-index multimode fiber. Two high performance 45-mode multi-plane light conversion (MPLC) devices served as the mode multiplexer/demultiplexer. Distributed mode coupling and DMDG among different mode groups are accurately quantified from the impulse response measurement. We also observed cladding modes of the MMF as a pedestal of the pulse in the measurement. This work paves way for applications such as quantum communications using many spatial modes of the fiber., Comment: 10 pages, journal paper

We implement a real-time coherent transceiver with fast streaming outputs for environmental sensing. Continuous sensing using phase and equalizer outputs over 12800km of a submarine cable is demonstrated to enable time resolved spectroscopy in broad spectral range of 10mHz - 1kHz.

We propose a digital interference mitigation scheme to reduce the impact of mode coupling in space division multiplexing self-homodyne coherent detection and experimentally verify its effectiveness in 240-Gbps mode-multiplexed transmission over 3-mode multimode fiber., Comment: 2 pages, 3 figures, submitted to OFC 2021

Digital holography measures the complex optical field and transfer matrix of a device, polarization-diversity is often achieved through spatial multiplexing. We introduce angular multiplexing, to increase flexibility in the optical setup. Comparatively, similar values for cross-talk and mode-dependent loss are measured for a photonic lantern., Comment: Accepted for presentation at the European Conference on Optical Communications (ECOC) 2020

We experimentally demonstrate a record net capacity per wavelength of 1.23~Tb/s over a single silicon-on-insulator (SOI) multimode waveguide for optical interconnects employing on-chip mode-division multiplexing and 11$\times$11 multiple-in-multiple-out (MIMO) digital signal processing.

We experimentally solve the problem of maximizing capacity under a total supply power constraint in a massively parallel submarine cable context, i.e., for a spatially uncoupled system in which fiber Kerr nonlinearity is not a dominant limitation. By using multi-layer neural networks trained with extensive measurement data acquired from a 12-span 744-km optical fiber link as an accurate digital twin of the true optical system, we experimentally maximize fiber capacity with respect to the transmit signal's spectral power distribution based on a gradient-descent algorithm. By observing convergence to approximately the same maximum capacity and power distribution for almost arbitrary initial conditions, we conjecture that the capacity surface is a concave function of the transmit signal power distribution. We then demonstrate that eliminating gain flattening filters (GFFs) from the optical amplifiers results in substantial capacity gains per Watt of electrical supply power compared to a conventional system that contains GFFs., Comment: arXiv admin note: text overlap with arXiv:1910.02050

We designed, fabricated and tested an optical hybrid that supports an octave of bandwidth (900-1800 nm) and below 4-dB insertion loss using multiplane light conversion. Measured phase errors are below 3-degree across a measurement bandwidth of 390 nm., Comment: 3 pages, 4 figures, accepted by OFC 2020

Conventional optical coherent receivers capture the full electrical field, including amplitude and phase, of a signal waveform by measuring its interference against a stable continuous-wave local oscillator (LO). In optical coherent communications, powerful digital signal processing (DSP) techniques operating on the full electrical field can effectively undo transmission impairments such as chromatic dispersion (CD), and polarization mode dispersion (PMD). Simpler direct detection techniques do not have access to the full electrical field and therefore lack the ability to compensate for these impairments. We present a full-field measurement technique using only direct detection that does not require any beating with a strong carrier LO. Rather, phase retrieval algorithms based on alternating projections that makes use of dispersive elements are discussed, allowing to recover the optical phase from intensity-only measurements. In this demonstration, the phase retrieval algorithm is a modified Gerchberg Saxton (GS) algorithm that achieves a simulated optical signal-to-noise ratio (OSNR) penalty of less than 4dB compared to theory at a bit-error rate of 2 times 10-2. Based on the proposed phase retrieval scheme, we experimentally demonstrate signal detection and subsequent standard 2x2 multiple-input-multiple-output (MIMO) equalization of a polarization-multiplexed 30-Gbaud QPSK transmitted over a 520-km standard single-mode fiber (SMF) span.

We realize mode-multiplexed full-field reconstruction over six spatial and polarization modes after 30-km multimode fiber transmission using intensity-only measurements without any optical carrier or local oscillator at the receiver or transmitter. The receiver's capabilities to cope with modal dispersion and mode dependent loss are experimentally demonstrated.

We experimentally achieve a 19% capacity gain per Watt of electrical supply power in a 12-span link by eliminating gain flattening filters and optimizing launch powers using machine learning by deep neural networks in a massively parallel fiber context.

We demonstrate the first transmission of a new twelve-dimensional modulation format over a three-core coupled-core multicore fiber. The format occupies a single time slot spread across all three linearly-coupled spatial modes and shows improved MI and GMI after transmission compared to PDM-QPSK., Comment: 4 pages, 4 figures

Lossless linear wave propagation is symmetric in time, a principle which can be used to create time reversed waves. Such waves are special 'pre-scattered' spatiotemporal fields, which propagate through a complex medium as if observing a scattering process in reverse, entering the medium as a complicated spatiotemporal field and arriving after propagation as a desired target field, such as a spatiotemporal focus. Time reversed waves have previously been demonstrated for relatively low frequency phenomena such as acoustics, water waves and microwaves. Many attempts have been made to extend these techniques into optics. However, the much higher frequencies of optics make for very different requirements. A fully time reversed wave is a volumetric field with arbitrary amplitude, phase and polarisation at every point in space and time. The creation of such fields has not previously been possible in optics. We demonstrate time reversed optical waves with a device capable of independently controlling all of light's classical degrees of freedom simultaneously. Such a class of ultrafast wavefront shaper is capable of generating a sequence of arbitrary 2D spatial/polarisation wavefronts at a bandwidth limited rate of 4.4 THz. This ability to manipulate the full field of an optical beam could be used to control both linear and nonlinear optical phenomena.

Temporal waveform manipulation is a fundamental functionality in optics and crucial for applications like optical communications, microwave photonics and quantum optics. Traditional IQ- or phase-amplitude modulators shape light by carving energy from the input lightwave and are thus fundamentally lossy, and cannot apply independent modulation to multiple input wavelengths simultaneously. Taking inspiration from the space-time duality, we produce arbitrary unitary spectro-temporal transformations on multiple temporal input vectors with a modulation structure comprising of only lossless phase modulation and dispersive allpass filtering. The bandwidth of the output waveforms is not restricted by the driving electronics and independent transformations can be performed simultaneously on multiple orthogonal inputs such as spectrally separated frequency tones. This overcomes the main limitations of traditional electro-optic modulators and offers fundamental new insight into temporal wave manipulation.

We realize dual-polarization full-field recovery using intensity only measurements and phase retrieval techniques based on dispersive elements. 30-Gbaud QPSK waveforms are transmitted over 520-km standard single-mode fiber and equalized from the receiver outputs using 2X2 MIMO.

Light's spatial properties represent an infinite state space, making it attractive for applications requiring high dimensionality, such as quantum mechanics and classical telecommunications, but also inherently spatial applications such as imaging and sensing. However, there is no demultiplexing device in the spatial domain comparable to a grating or calcite for the wavelength and polarisation domains respectively. Specifically, a simple device capable of splitting a finite beam into a large number of discrete spatially separated spots each containing a single orthogonal spatial component. We demonstrate a device capable of decomposing a beam into a Cartesian grid of identical Gaussian spots each containing a single Laguerre-Gaussian component. This is the first device capable of decomposing the azimuthal and radial components simultaneously, and is based on a single spatial light modulator and mirror. We demonstrate over 210 spatial components, meaning it is also the highest dimensionality mode multiplexer of any kind.

We use white Gaussian noise as a test signal for single-mode and multimode transmission links and estimate the link capacity based on a calculation of mutual information. We also extract the complex amplitude channel estimations and mode-dependent loss with high accuracy., Comment: submitted to The Optical Networking and Communication Conference (OFC) 2018