Search

Copyright of Journal of Field Ornithology is the property of Resilience Alliance and its content may not be copied or emailed to multiple sites or posted to a listserv without the copyright holder's express written permission. However, users may print, download, or email articles for individual use. This abstract may be abridged. No warranty is given about the accuracy of the copy. Users should refer to the original published version of the material for the full abstract. (Copyright applies to all Abstracts.)

The CAMAG thin-layer chromatography mass spectrometer (TLC--MS) interface has been assessed as a tool for the direct quantitative bioanalysis of drugs from dried blood spot (DBS) samples, using an MS detector, with or without high-performance liquid chromatography (HPLC) separation. The approach gave acceptable sensitivity, linearity, accuracy, and precision data for bioanalytical validations with and without the inclusion of HPLC separation. In addition, the direct elution technique was shown to increase assay sensitivity for a range of analytes representing a wide 'chemical space' for pharmaceutical-type molecules over that obtained by conventional manual extraction of samples (punching of DBS and elution with solvent prior to HPLC--MS analysis). Investigations were performed to optimize extraction time, minimize sample-to-sample carry-over, and compare chromatographic performance. On the basis of this preliminary assessment, it has been demonstrated that the TLC-MS interface has the potential to be an effective tool for the direct analysis of drugs in DBS samples at physiologically relevant concentrations, an approach that could provide significant time and cost savings and greatly simplify bioanalytical procedures compared to current manual practices. Further, the increased sensitivity compared to that of manual extraction may enable the analysis of analytes not currently amenable to DBS sampling due to limitations in assay sensitivity. 10.1021/ac901985e

Rationale: Rapid Evaporative Ionisation Mass Spectrometry (REIMS) has been evaluated as a tool to improve analytical efficiency and add capability in areas within Pharmaceutical Research and Development (Pharma R&D). This article reports the comparison of single MS, and tandem MS/MS REIMS (REIMS and REIMS/MS) methodologies to investigate which mode produces maximum discrimination power for screening applications. Methods: Control tissue samples and cell line suspension samples were analysed using optimised REIMS and REIMS/MS to evaluate which technique produced optimal discrimination power for control tissue and cell line identification. The iKnife sampling tool and a prototype 'cell sampler' were utilised for tissue and cell analysis, respectively. The REIMS source was coupled to a hybrid Quadrupole‐Time Of Flight (QTOF) mass spectrometer. Multivariate Analysis (MVA) was utilised to evaluate the resulting Mass Spectrometry (MS) data and discriminate between sample types. Results: Proof of concept investigations demonstrating that REIMS/MS offered increased MVA discrimination for sample identification, compared with REIMS, is presented for the first time. Control tissue data showed discrimination by timepoint classification over 0‐144 h storage after removal from the host. Timepoint discrimination was optimised using REIMS/MS with a collision energy that effectively maximised ion fragmentation. Similar optimisation was observed when REIMS/MS was applied to the identification of cell lines. Conclusions: The proof of concept results demonstrate that REIMS/MS can offer advantages over REIMS for control tissue quality screening, and cell line identification applications in Pharma R&D. Further work following this proof of concept investigation is being undertaken to implement the technology for these applications, utilising the optimised REIMS/MS methodology. REIMS/MS will also be used as an optimised tool for other applications. [ABSTRACT FROM AUTHOR]

A novel technique is presented that addresses the issue of how to apply internal standard (IS) to dried matrix spot (DMS) samples that allows the IS to integrate with the sample prior to extraction. The TouchSpray, a piezo electric spray system, from The Technology Partnership (TTP), was used to apply methanol containing IS to dried blood spot (DBS) samples. It is demonstrated that this method of IS application has the potential to work in practice, for use in quantitative determination of circulating exposures of pharmaceuticals in toxicokinetic and pharmacokinetic studies. Three different methods of IS application were compared: addition of IS to control blood prior to DBS sample preparation (control 1), incorporation into extraction solvent (control 2), and the novel use of TouchSpray technology (test). It is demonstrated that there was no significant difference in accuracy and precision data using these three techniques obtained using both manual extraction and direct elution. [ABSTRACT FROM AUTHOR]