Search

ATLAS Technical Proposal, CERN/LHCC/94-43 has adopted n-side read out single-sided detectors as the baseline technology for the silicon microstrips due to the anticipated radiation tolerance of such a design ATLAS Inner Detector Technical Design Report, CERN/LHCC/97-17. This results from the reasonable efficiencies anticipated for charge collection, even when the detectors are run well below the final depletion voltage. Full-sized prototypes 64×63.6 mm 2 detectors have been produced with a range of manufacturers to a common specification and shown to work well in test-beam with ATLAS electronics. A selection of detectors was also scanned in the CERN PS beam for runs of two weeks giving an integrated dose over the full surface of 2×10 14 p/cm 2 . This dose corresponds to the highest charged hadron fluence expected in 10 yr of operation in ATLAS. Results are presented on these detectors both from parametric measurements and from studies using analogue LHC speed electronics. The detectors are shown to remain fully operational after these doses and to yield high signal/noise for read-out of 12 cm strip length. The performance partially depleted is also shown to match expectations and operation at down to half the final depletion voltage gives adequate efficiencies. Uncertainties in the anticipated dose and damage effects argue strongly for this additional robustness in detectors which must operate with very limited access in the hostile environment of the LHC for 10 yr.