Search

Because routine assays for pancreatic lipase catalytic activity are not yet standardized, between-method comparability is very poor. This is mainly due to the lack of reference materials (RMs). The aim of this study was to assign values of catalytic concentration to two human pancreatic lipase RMs, one prepared from human pancreatic juice (BCR 693), the other obtained by recombinant technology (BCR 694). Lipase catalytic activity was assayed in five experienced laboratories, using aliquots from the same lot of triolein emulsion and a standardized titrimetric procedure, optimized with regard to substrate, cofactors and pH. The accepted sets of data (n = 4) gave a mean +/- the corresponding uncertainty expressed as the 0.95 confidence interval of 1732 +/- 72 U/l and 1043 +/- 60 U/l for BCR 693 and 694, respectively. Transferability of the whole operating procedure proved to be quite satisfactory. The authors conclude that both RMs can be used to verify the correct implementation of the standardized measurement procedure and to assign values to secondary lipase materials (commercial calibrators, control products) which, in turn, ensures traceability to the standardized procedure in this study, and contributes to the harmonization of laboratory results according to the Directive for in vitro Diagnostic Medical Devices.

There is a lack of certified reference material (CRM) for lipase catalytic activity. Consequently between-method comparability is very poor. The aim of this study was to produce two lipase CRMs, one from human pancreatic juice (BCR 693), and another using recombinant technologies (BCR 694). Lipase was purified from pancreatic juice, using column chromatography and isoelectric focusing. Recombinant lipase was produced with a transfected cell line and purified with column chromatography. Adding buffered bovine serum albumin and subsequent freeze-drying were used to stabilize both materials. A standardized titrimetric method was employed to compare their catalytic properties to those of two plasma pools of patients suffering from acute pancreatitis. About 5 kU (titrimetry, 37 degrees C) of each material were obtained. They were lyophilized without apparent modifications of their catalytic properties, which stayed identical to those exhibited by the enzyme present in patient's pools. Stability of both materials was estimated at several years when stored in a dry form at -20 degrees C. Both materials appear to have similar catalytic properties and stability and were found commutable as regards a reference method and a routine measurement procedure. An international certification campaign will be carried out to assign values to BCR 693 and BCR 694.

We describe the certification of a mass concentration value in the already prepared creatine kinase-2 reference material (BCR 608). Creatine kinase-2 was purified from human heart. The purified enzyme was diluted in order to measure its protein concentration by the Doetsch method. A protein concentration value of 124.30+/-13.17 mg/l was assigned to the stock solution of purified creatine kinase-2. This stock solution was diluted in 25 mmol/l piperazine-N,N'-bis[2-ethanesulfonic acid] (PIPES) pH 7.2, containing 2 mmol/l ADP, 5 mmol/l 2-mercaptoethanol, 154 mmol/l sodium chloride and 50 g/l human albumin to obtain a stable liquid standard of known creatine kinase-2 mass concentration (80.36 microg/l). This standard was then used to recalculate the creatine kinase-2 mass concentration measured in the BCR 608 material by immunoassay. The mass concentration of creatine kinase-2 in samples of reconstituted BCR 608 was certified to be 93.30+/-9.65 microg/l.

We describe the preparation of a lyophilized material containing purified human pancreatic alpha-amylase and the certification of its catalytic concentration. The enzyme was purified from human pancreas by ammonium sulphate precipitation and chromatography successively on DEAE-Sephacel, CM-Sepharose and Sephadex G-75. The purified enzyme had a specific activity of 52.9 kU/g protein and was > 99% pure on polyacrylamide gel electrophoresis. Only trace amounts of lipase and lactate dehydrogenase were detected in the purified fraction. The purified pancreatic alpha-amylase had a molar mass of 57,500 g/mol and an isoelectric point at 7.1. The material was prepared by diluting the purified alpha-amylase in a matrix containing PIPES buffer 25 mmol/l, pH 7.0, sodium chloride 50 mmol/l, calcium chloride 1.5 mmol/l, EDTA 0.5 mmol/l and human serum albumin 30 g/l, dispensing in ampoules and freeze-drying. The ampoules were homogeneous and the yearly loss of activity on the basis of accelerated degradation studies was less than 0.01% at -20 degrees C. The certified value for alpha-amylase catalytic concentration in the reconstituted reference material is 555 U/l +/- 11 U/l when measured by the specified method at 37 degrees C. The material can be used to verify the comparability of results from laboratories, for intra-laboratory quality control or for calibration of alpha-amylase catalytic concentration measurements.

This paper describes the assessment of the homogeneity and stability of a purified and lyophilized human thyroglobulin (Tg), and characterizes its immunoreactivity. The purified and lyophilized Tg is intended to be used as a primary reference material to establish calibration of working serum based reference material. The programme involved the participation of 15 European laboratories and one laboratory from the United States. The homogeneity of the content of the ampoules was considered acceptable (< 9%). The stability was tested by accelerated temperature degradation showing predicted annual relative losses of 0.01% at -70 degrees C and 1.04% at -20 degrees C. The immunoreactivity of the Tg material as measured in different laboratories varied mostly according to the method used rather than the laboratory. The interlaboratory variability showed that the two commercial methods used in several laboratories (kit 1 and 2) had an interlaboratory variation (CV) of 15.9% (N = 5) and 7.1% (N = 3), respectively, whereas the total interlaboratory CV was 64.3% (N = 18). The immunoreactive Tg had dilution curves parallel with other Tg calibrators (those of the methods). Dilution curves of the Tg material after storage at various temperatures and time were parallel in both RIA and IRMA. In conclusion, we have prepared a Tg reference material which in extensive studies in several participating laboratories has demonstrated a sufficient homogeneity and stability as well as dilution curves parallel to the calibrators of all the immunoassays tested in the study. This reference material is considered the first step towards decreasing the interlaboratory variability between Tg immunoassays.

This report describes the characterization of a purified human thyroglobulin (Tg) reference material, and details the procedures used in its certification. The purified Tg is intended to be used as a primary reference material to establish calibration of working serum based reference material for immunoassay procedures. The programme involved the participation of 15 European laboratories and one laboratory from the United States. The physicochemical characterization showed by polyacrylamide gel electrophoresis and immunoblotting that the purified Tg had for the major part the expected molecular size of 660 kDa with traces of lower molecular forms. The amino acid composition was close to that demonstrated for the cDNA and the content of iodine was in keeping with a moderately to highly iodinated Tg. The mass concentration in reference material RM 457 is certified to be (0.324 +/- 0.018) g/L on the basis of protein determined by the Lowry method and supported by nitrogen determination, absorbance measurement, and amino acid analysis. This reference material is considered the first step towards decreasing the interlaboratory variability between Tg methods of measurement.

Abut twenty years ago, the European Commission established the BCR (Bureau Communautaire de Référence) programme with the objective of improving the quality of the results of measurements, in order to assist in the establishment of reliable and comparable measurement systems in the EU member states. Its usual procedure consists of collaborative studies--involving preferably laboratories from all member states--in terms of: intercomparisons, research and development and preparation and certification of reference materials when necessary. The aim of the biomedical activities of the programme is to harmonize results obtained from analyses of samples of tissues and biological fluids. In the current programme "measurements and testing" (BCR's successor) emphasis is focused on two categories of activities: 1) feasibility preparation and certification of reference materials (including the appropriate method development when necessary) and 2) collaboration between EU national external quality assessment schemes (EQA).