Search

In the past years a wide discussion has been held among asphalt researchers regarding the existence and interpretation of observed microstructures on bitumen surfaces. To investigate this, the RILEM technical committee on nano bituminous materials 231-NBM has conducted a round robin study combining differential scanning calorimetry (DSC) and Atomic Force Microscopy (AFM). From this, methods for performing DSC and AFM tests on bitumen samples and determination of the influence of wax on the observed phases, taking into account thermal history, sample preparation and annealing procedure, are presented and critically discussed. DSC is used to measure various properties and phenomena that indicate physical changes such as glass transition temperature (T g) and phase transition such as melting and crystallization. In the case of existence of wax, either natural or synthetic, it can further indicate the melting point of wax, that could be used to determine wax content. The results from seven laboratories show that T g temperatures obtained from the heating scans are more repeatable and easier to obtain in comparison to the cooling scans. No significant difference was noted for T g's obtained from the first and second heating scans. AFM is an imaging tool used to characterize the microstructures on a bituminous surface. Using AFM three phases in the materials with wax could be distinguished. The changes in the phases observed with AFM for increases in temperature were correlated with the DSC curve, and it could be established that the so called "Bee" structure disappeared around the melting peak in the DSC curve. Thus, this research has confirmed the relation between the microstructures on a bitumen surface and the wax content. cop. 2013 RILEM.

Freezing of atmospheric water on bituminous construction and road surfaces is a recurring event during winter. However, droplet freezing on bitumen and passive inhibition methods are poorly understood. Here we investigate relative humidity and substrate cooling effects on condensation freezing on subzero temperature bituminous surfaces and find that droplet freezing is explosive, with rapid local heating. We explain the related physics and find that relative humidity and cooling rate can affect droplet sizes and freezing temperatures. We then rationally embed phase change material microcapsules in bitumen, harnessing their latent heat to significantly delay freezing, demonstrating a viable option for frost mitigation., Construction and Building Materials, 298, ISSN:0950-0618

Laboratory scale mechanical performances on six plant produced mixtures; three semi-dense surface courses and three dense binder courses modified with engineered crumb rubber (ECR) using the dry process are presented. The two types of mixtures produced and investigated fulfilled for the most part, the requirements of the Swiss and/or US standards regarding volumetric properties, water sensitivity and rutting. In advanced testing where no requirements exist, the dense ECR mixtures performed similar to the reference polymer modified mixtures and slightly worse for semi-dense mixtures in high temperature tests, where the binder becomes viscous in the rubber-binder composite and its ability to transfer loads is reduced. The ECR mixtures performed similarly or better than the reference in low temperature tests. Across the advanced testing data set, all obtained results were well within acceptable values for both ECR and reference polymer mixtures indicating that crumb rubber can effectively replace polymer in asphalt mixtures.