Search

We use density functional theory calculations to characterize the early stages of fluorination of silver's (100) and (110) surfaces. In the Ag(100) surface, the hollow site is the most favorable for F adatoms. In the Ag(110) surface, three adsorption sites, namely hollow, long bridge, and short bridge, exhibit similar energies. These locations are also more favorable than an F adatom occupying a vacancy site irrespectively of whether the vacancy was present or not in the pristine surface. The computed energy as a function of surface coverage is used to compute the equilibrium thermodynamics phase diagram. We argue that for the typical pressure and temperature of fluorination experiments, the state of the surface is not determined by thermodynamics but by kinetics. Combining these results with scanning tunneling microscopy (STM) topographic simulations, we propose assignments to features observed experimentally. We present a minimal model of the apparent topography of adatoms in different locations in terms of hydrogenic orbitals, explaining the observed trends. The model links the STM apparent topography to structural information and the oxidation states of the Ag atoms near the adatom., Comment: 18 pages, 12 Figures

We investigated the reactivity of layered GeAs in the presence of oxygen and/or water using synchrotron-based X-ray photoelectron spectroscopy and ab initio calculations.

We use low-temperature scanning tunneling microscopy (LT-STM) to characterize the early stages of silver fluorination. On Ag(100), we observe only one adsorbate species, which shows a bias-dependent STM topography. Notably, at negative bias voltages, $V_{\rm B}<0$, the apparent shape can be described as a round protrusion surrounded by a moat-like depression (sombrero). As the voltage increases, the apparent shape changes, eventually evolving into a round depression. From the STM images, we determine the adsorption site to be the hollow position. On Ag(110) we find adsorbates with three distinct STM topographies. One type exhibits the same shape change with $V_{\rm B}$ as observed on Ag(100), that is, from a sombrero shape to a round depression as the voltage changes from negative to positive values; the other two types are observed as round depressions regardless of $V_{\rm B}$. From the STM images, we find the three adsorbates to be sitting on the short-bridge, hollow and top position on the Ag(110) surface, with a relative abundance of 60\%, 35\% and 5\%., Comment: 13 pages, 7 figures

Recent advances in nanomaterials have pushed the boundaries of nanoscale fabrication to the limit of single atoms (SAs), particularly in heterogeneous catalysis. Single atom catalysts (SACs), comprising minute amounts of transition metals dispersed on inert substrates, have emerged as prominent materials in this domain. However, overcoming the tendency of these SAs to cluster beyond cryogenic temperatures and precisely arranging them on surfaces pose significant challenges. Employing organic templates for orchestrating and modulating the activity of single atoms holds promise. Here, we introduce a novel single atom platform (SAP) wherein atoms are firmly anchored to specific coordination sites distributed along carbon-based polymers, synthesized via on-surface synthesis (OSS). These SAPs exhibit atomiclevel structural precision and stability, even at elevated temperatures. The asymmetry in the electronic states at the active sites anticipates the enhanced reactivity of these precisely defined reactive centers. Upon exposure to CO and CO2 gases at low temperatures, the SAP demonstrates excellent trapping capabilities. Fine-tuning the structure and properties of the coordination sites offers unparalleled flexibility in tailoring functionalities, thus opening avenues for previously untapped potential in catalytic applications., Comment: Main text (12 pages, 4 figures) and supplementary information (15 pages, 16 figures)

Thin Ge layers deposited on Si(105) form a stable single-domain film structure with large terraces and rebonded-step surface termination, thus realizing an extended and ordered Ge/Si planar hetero-junction. At the coverage of four Ge monolayers angle-resolved photoemission spectroscopy reveals the presence of two-dimensional surface and film bands displaying energy-momentum dispersion compatible with the 5x4 periodicity of the system. The good agreement between experiment and first-principles electronic structure calculations confirms the validity of the rebonded-step structural model. The direct observation of surface features within 1 eV below the valence band maximum corroborates previously reported analysis of the electronic and optical behavior of the Ge/Si hetero-interface., Comment: 15 pages, 5 figures

We report electroluminescence originating from L-valley transitions in n-type Ge/Si$_{0.15}$Ge$_{0.85}$ quantum cascade structures centered at 3.4 and 4.9 THz with a line broadening of $\Delta f/f \approx 0.2$. Three strain-compensated heterostructures, grown on a Si substrate by ultrahigh vacuum chemical vapor deposition, have been investigated. The design is based on a single quantum well active region employing a vertical optical transition and the observed spectral features are well described by non-equilibrium Green's function calculations. The presence of two peaks highlights a suboptimal injection in the upper state of the radiative transition. Comparison of the electroluminescence spectra with similar GaAs/AlGaAs structure yields one order of magnitude lower emission efficiency.

Combining scanning tunneling microscopy and angle-resolved photoemission spectroscopy, we demonstrate how to tune the doping of epitaxial graphene from p to n by exploiting the structural changes that occur spontaneously on the Ge surface upon thermal annealing. Furthermore, using first principle calculations we build a model that successfully reproduces the experimental observations. Since the ability to modify graphene electronic properties is of fundamental importance when it comes to applications, our results provide an important contribution towards the integration of graphene with conventional semiconductors.

: n-type Ge/SiGe asymmetric-coupled quantum wells represent the building block of a variety of nanoscale quantum devices, including recently proposed designs for a silicon-based THz quantum cascade laser. In this paper, we combine structural and spectroscopic experiments on 20-module superstructures, each featuring two Ge wells coupled through a Ge-rich tunnel barrier, as a function of the geometry parameters of the design and the P dopant concentration. Through the comparison of THz spectroscopic data with numerical calculations of intersubband optical absorption resonances, we demonstrated that it is possible to tune by design the energy and the spatial overlap of quantum confined subbands in the conduction band of the heterostructures. The high structural/interface quality of the samples and the control achieved on subband hybridization are the promising starting point towards a working electrically pumped light-emitting device.

The magnetic anisotropy and exchange coupling between spins localized at the positions of 3d transition metal atoms forming two-dimensional metal-organic coordination networks (MOCNs) grown on the Au(111) metal surface are studied. In particular, we consider MOCNs made of Ni or Mn metal centers linked by TCNQ (7,7,8,8-tetracyanoquinodimethane) organic ligands, which form rectangular networks with 1:1 stoichiometry. Based on the analysis of X-ray magnetic circular dichroism (XMCD) data taken at T= 2.5 K, we find that Ni atoms in the Ni-TCNQ MOCNs are coupled ferromagnetically and do not show any significant magnetic anisotropy, while Mn atoms in the Mn-TCNQ MOCNs are coupled antiferromagnetically and do show a weak magnetic anisotropy with in-planemagnetization. We explain these observations using both amodelHamiltonian based on mean-fieldWeiss theory and density functional theory calculations that include spin-orbit coupling. Our main conclusion is that the antiferromagnetic coupling between Mn spins and the in-plane magnetization of the Mn spins can be explained neglecting effects due to the presence of the Au(111) surface, while for Ni-TCNQ the metal surface plays a role in determining the absence of magnetic anisotropy in the system., Comment: 17 pages, 7 figures, submitted to Molecules (MDPI) on February 21st 2018, Supplementary Material in submit/2172866