Search

Minerals are reported to dominate the electrical properties of honey and indicate its botanical and geographical origins. In this study, Electrochemical Impedance Spectroscopy (EIS) was used to assess the relation between mineral elements, electrical properties and botanical origin using three honey varieties - Citrus sp., Eucalyptus sp., and Erica sp. These varieties are identified through pollen analysis and market labelling. Flame atomic absorption and emission spectroscopies were used to quantify the concentrations of eight elements (potassium, sodium, calcium, magnesium, manganese, zinc, copper, and iron). Among all the mineral elements, potassium showed a consistent correlation with impedance. The potassium estimation in honey and standard solutions (calibration curve) had similar sensitivities of 153.43 nF/mM and 132.68 nF/mM, respectively. Additionally, the analysis revealed that potassium dominates the mineral composition, with the other species present in minimal quantities. The EIS technique showed high sensitivity to potassium and other ionisable species, making it possible to classify the botanical origin of these three honey types. The EIS technique proved to be both time and cost effective, yielding a classification rate higher than that achieved by analysing mineral composition. [Display omitted] • Potassium is the predominant element influencing the electrical properties of honey. • Electrochemical impedance measurements provide a quantitative assessment of potassium concentration in honey. • An impedance-based sensor classifies honey samples according to their botanical origin. • The impedance-based sensor is time and cost-effective, when compared with mineral composition analysis. [ABSTRACT FROM AUTHOR]

The aim of this work was to compare Cr(III) and Cr(VI) removal kinetics from water by Pistia stratiotes and Salvinia herzogii. The accumulation in plant tissues and the effects of both Cr forms on plant growth were also evaluated. Plants were exposed to 2 and 6 mg L−1of Cr(III) or Cr(VI) during 30 days. At the end of the experiment, Cr(VI) removal percentages were significantly lower than those obtained for Cr(III) for both macrophytes. Cr(III) removal kinetics involved a fast and a slow component. The fast component was primarily responsible for Cr(III) removal while Cr(VI) removal kinetics involved only a slow process. Cr accumulated principally in the roots. In the Cr(VI) treatments a higher translocation from roots to aerial parts than in Cr(III) treatments was observed. Both macrophytes demonstrated a high ability to remove Cr(III) but not Cr(VI). Cr(III) inhibited the growth at the highest studied concentration of both macrophytes while Cr(VI) caused senescence. These results have important implications in the use of constructed wetlands for secondary industrial wastewater treatment. Common primary treatments of effluents containing Cr(VI) consists in its reduction to Cr(III). Cr(III) concentrations in these effluents are normally below the highest studied concentrations in this work. [ABSTRACT FROM PUBLISHER]