Search

This article presents the design steps of a planar circularly polarized (CP) bowtie‐shaped antenna for 2.4–2.5 GHz industry, science, and medicine band. Using these design steps, an antenna model is developed. The antenna design is extensively described, simulated, measured, and analyzed. The antenna is simulated using the HFSS software and produced by laser etching of copper on a low‐cost Taconic RF‐35 substrate. The presented method of this design is easy to fabricate and is tunable to different frequencies. The produced CP planar antenna has a size of 55 × 55 × 0.25 mm3, a measured axial ratio bandwidth ranging from 2.33 to 2.49 GHz, and a measured peak gain of 3.21 dBiC. The produced antenna is fully planar, compatible with the printing process and thus suitable for Internet of Things applications. [ABSTRACT FROM AUTHOR]

In this paper, a novel compact ultra‐high frequency (UHF) tag antenna for radio frequency identification is presented. This tag uses the Monza‐X from Impinj as a differential radio frequency integrated circuit. A wideband circular polarization was achieved. The frequency range covered for an axial ratio (AR) < 3 dB is from 830 to 903 MHz. The designed antenna is simulated by using the electromagnetic software ansys high frequency structure simulator. The tag antenna is printed on 50 × 50 mm2 of Roger 4350B substrate with a dielectric constant (Ԑr) of 3.66 and thickness of 1.52 mm. The manufactured tag antenna performance has been tested by measuring the reading distance. The measurement results show good values of reading range (RR) especially in the EU Radio Frequency IDentification band. The tag has a maximum RR of about 13.3 m at 865 MHz with an Effective Isotropic Radiated Power of 2 W. [ABSTRACT FROM AUTHOR]

Slot radio frequency identification (RFID) Tag antennas designed for ultra‐high frequency (UHF) band are presented. Two orthogonal slots are used to achieve circular polarization (CP). By selecting an appropriate length of feed‐lines, the input impedance of the tag antenna can be controlled. Experimental results show a good reading range between 9 m and 10 m. A wide band CP band was measured. The design procedure for the proposed antennas are described and the performances are presented and discussed. [ABSTRACT FROM AUTHOR]

This paper presents an original approach to analyze multimode waveguide discontinuities. The generalized scattering parameters are determined by a matrix pencil moment method associated with efficient numerically multimode matched loads placed at each physical port of the discontinuities. The analysis of both microstrip-coupled lines and coplanar lines asymmetric discontinuities is presented and successfully compared to experiments and available published results. Index Terms--Discontinuities, multimode waveguides, numerical technique, scattering parameters.

This letter aims to study a multiantenna tag on a UHF RFID system. Impact of dual antenna on the read range is demonstrated. This letter shows that this enhancement is not only due to a better antenna gain, but also to the design of the backscattering system. Indeed, the backscattering modulator is connected on only one of the two inputs of the antenna. Measurements of prototypes designed in 0.18 CMOS process demonstrate that a tag with such a system stays visible for the reader around 2 m better than a one-antenna system. [ABSTRACT FROM PUBLISHER]

The design of a traveling-wave amplifier (TWA) in 0.13-μm standard CMOS technology is presented. It is designed to maximize the gain-bandwidth product (GBP). An asymmetric cascode, coplanar waveguide (CPW), and loss compensation technique enables maximization of the TWA GBP. Design and modeling of 90-Ω CPW used to synthesize inductors of the TWA lines is presented. Simulations with a design kit and developed models for CPW show a 52-GHz bandwidth with a maximum power gain of 8.5 dB at 10 GHz for a 135-mW power consumption. Measurements up to 40 GHz confirm these results. [ABSTRACT FROM AUTHOR]