Search

A capillary gas chromatography method with a short run time, using a flame ionization detector, has been developed for the quantitative determination of trace level analysis of mesityl oxide and diacetone alcohol in the atazanavir sulfate drug substance. The chromatographic method was achieved on a fused silica capillary column coated with 5% diphenyl and 95% dimethyl polysiloxane stationary phase (Rtx-5, 30 m x 0.53 mm x 5.0 µm). The run time was 20 min employing programmed temperature with a split mode (1:5) and was validated for specificity, sensitivity, precision, linearity, and accuracy. The detection and quantitation limits obtained for mesityl oxide and diacetone alcohol were 5 µg/g and 10 µg/g, respectively, for both of the analytes. The method was found to be linear in the range between 10 µg/g and 150 µg/g with a correlation coefficient greater than 0.999, and the average recoveries obtained in atazanavir sulfate were between 102.0% and 103.7%, respectively, for mesityl oxide and diacetone alcohol. The developed method was found to be robust and rugged. The detailed experimental results are discussed in this research paper. [ABSTRACT FROM AUTHOR]

A new unknown impurity of cefoxitin formed during a gradient reverse phase high performance liquid chromatography (HPLC) analysis of stress stability samples of the drug substance cefoxitin, and the level of this impurity was found at up to 0.9%. This impurity was identified by LC-MS and characterized by (1H NMR, 13C NMR, LC/MS/MS, elemental analysis and FT-IR). Based on the spectral data, the impurity was named as, 3-[[(2R,3S)-[3-methoxy-3-N-[2-(thiophen-2-yl)acetamido]]-4-oxoazetidin-2-ylthio]-2-[(carbamoyloxy)methyl]]-acrylic acid. The structure of this impurity was also established unambiguously, prepared by isolation and co-injected into HPLC to confirm the retention time. To the best of our knowledge, this impurity has not been reported elsewhere. Structural elucidation of the impurity by spectral data is discussed in detail.

The present study relates to the optimization of an ion chromatography method to determine the content of monoethylsulfate at very low levels in Indinavir sulfate drug substance, and subsequent validation of the method to prove its suitability, reliability and sensitivity. Monoethylsulfate is a potential impurity of Indinavir sulfate, and may forms during the preparation as well as during storage. The ion chromatography method was developed in such a way that to enhance the detection level by introducing suppressor, and minimizing acquisition time by using suitable buffer of 3.2 mmole of sodium carbonate and 1 mmole of sodium hydrogen carbonate in water as eluent. The retention time of monoethylsulfate was about 9.5 min and the total acquisition time was 25 min. The optimized method was validated to prove its performance characteristics by demonstrating selectivity, sensitivity (limit of detection and quantification), linearity, precision and accuracy. The established limit of detection and quantification of monoethylsulfate in Indinavir sulfate by this method was found to be 24 ng/ml and 74 ng/ml respectively, and the overall percent accuracy (recovery) of samples evaluated at different concentration levels was found to be 97.1, indicating the sensitivity and accuracy of this optimized ion chromatography method.