Search

Severe bone resorption is a vexing clinical problem, especially in patients without teeth. To study resorption in vivo, measurements of bone mineral density (BMD) of the mandible of both patients with and without teeth are needed. Using a Hologic QDR-1000 bone densitometer designed to measure lumbar spine and hips, ex vivo and in vivo measurements were made in selected areas of the mandible. The mandible was positioned such that the X-ray beam was perpendicular to its sagittal plane. In this way the beam hits first one half of the mandible and then the other. The reproducibility--expressed as coefficient of variation--of the ex vivo measurements was 0.5%. For in vivo measurements this coefficient was 3%. The method used for mandibular BMD would make it possible to define an average BMD in several categories of the normal population and of patients, and to compare bone density in the mandible with that in the axial and perpendicular skeleton. Improvement may be obtained by repeating the measurement. The entrance dose per scan is low, equalling that of one bitewing/radiograph.

Objectives: The purpose of this study was to investigate the stress patterns associated with prefabricated endodontic posts during the various stages of insertion according to a number of design characteristics. Methods: In a photoelastic material with elastic properties comparable to dentin, analyses were performed of the overall stress patterns with polarized light revealing substantial differences in stresses generated by the various posts. The effects of variations in design for certain configurations of the posts were also assessed. Results: One geometric feature was the retentive thread of the post. The stress patterns within the photoelastic material revealed a homogeneous distribution of stress along the entire length of the thread, and more threads induced additional stress. The stress recorded with a vent when the pitch of the thread was 0.8–1.0 mm was classified as minimal-to-mild stress. Another geometric feature considered was the head (coronal extension) of the post. Minimal stress was recorded in the material in contact with the head and the apical end of the post when the contact surface of head was more than 3 mm2. Conclusions: This study suggests that during insertion of threaded posts the least stress occurs when the head contact surface is sufficient (⩾3 mm2). A thread with a pitch of 0.8–1.0 mm is most desirable in stress reduction. The number of windings should also be limited (less than six windings) as samples with a substantial number of windings (N=13 or 30) produce severe stress.

Contains fulltext : 20667.PDF (Publisher’s version ) (Open Access)

The morphology of dentinal cavity walls, wetting by poly (methyl methacrylate), and resistance to tensile forces was studied with a scanning electron microscope, before and after etching or fixation, or both, with glutaraldehyde. Results indicated that the surface layer of dentinal cavity walls after etching is of an aqueous-organic nature, that glutaraldehyde fixation improves the mechanical properties of the surface layer of the cavity wall, and that wetting by poly (methyl methacrylate) is effective.

Tritiated proline was administered to domestic cats during the development of their permanent dentition. The amount of residual radioactivity was determined autoradiographically at various times after cavity preparation in mature molars and premolars. Two wk after cavity preparation, the amount of radiolabel beneath the axial cavity wall decreased to about 50% of that present in corresponding contralateral cavity-free teeth. The observed decreases are ascribed to an enhancement of the protein metabolism in dentin. At 45 wk, 80-90% of the radiolabel has disappeared. This paper discusses the role of an eventual effect of microleakage on the latter results.

The adherence of 4 strains of oral bacteria to hydroxyapatite and to chemically modified hydroxyapatite was investigated in vitro. It was found that successive treatment of hydroxyapatite beads with potassium phytate and hexadecylamine lead to complete inhibition of the adherence of three Gram-positive strains, Streptococcus mutans, Streptococcus sanguis and Actinomyces viscosus, but not of the Gram-negative Fusobacterium strain. Coating of the hydroxyapatite surface with saliva prior to treatment with phytate and amine did not significantly change bacterial adherence. When phytate and amine-treated hydroxyapatite was post-treated with saliva, the adherence of S. mutans and A. viscosus, but not of S. sanguis, was still completely blocked.

To investigate the permeability of the dental enamel of erupted and unerupted human pre-molars and its variation with depth, we determined the resistivity of successive 100-μm-thick layers. The electrical resistance of halved tooth crowns at zero Hertz, which according to Scholberg et al. (1982, 1984) is inversely related to the permeability, was measured before and after removal of successive enamel layers from the outer surface toward the dentino-enamel junction (D.E.J.). The resistivity of the successive enamel layers increased from the D.E.J. toward the outer surface in approximately the same way in erupted as well as in unerupted pre-molars, except within the outermost layer of 100 to 200 μm thickness. The resistivity of this layer in erupted pre-molars was considerably higher than that in unerupted pre-molars, which may be due to post-eruptive mineralization.

Intact roots of human molars, which had not been exposed to the oral environment, were exposed to buffer solutions of pH 5.5, which contained, besides calcium and phosphate, various concentrations offluoride. Densitometric measurements on contact-microradiograms of transverse sections of these roots produced data which were used to calculate the rate of demineralization ( Vdem). Vdem appeared to be reduced with increasing fluoride concentration and with decreasing pIOHA (i.e., the negative logarithm of the ionic product of hydroxyapatite) of the buffer solution. In addition, it was observed that, after some days of exposure, remineralization started to occur within the surface layer at some μm from the outer surface and that the region within which remineralization took place was extended inward with increasing time of exposure. These data suggest that fluoride is effective in the prevention of root surface caries. The mechanism of the interaction of fluoride with the root mineral is discussed.

Tritiated proline was administered as protein marker to domestic cats during the development of their permanent dentition (age 11-18 wk). At 30, 43, 56, and 75 wk, the amount of tritium in the mature dentin was determined by quantitative autoradiography. At 43, 56, and 75 wk the residual amount of label was 92, 92, and 77%, respectively, of that at 30 wk. The metabolism of dentinal collagen (with possibly a recycling of proline) and the metabolism of non-collagenous proline-containing proteins are suggested as factors that may contribute to the decrease of tritium label.

Crowns and roots of human molars, the roots from which had not been exposed to the oral environment, were exposed for 0, 3.5, 7, and 14 days to buffer solutions which were undersaturated or supersaturated with respect to hydroxyapatite. Densitometric measurements on contact-microradiograms of transverse sections of the crowns and of the cervical parts of the roots yielded plots of the mineral content as a function of the distance to the outer surface. From these plots, the rate of demineralization was calculated. It was found that the mineral of the roots dissolved even in buffer solutions which were supersaturated with respect to hydroxyapatite. Comparison of the results obtained from the crowns with those from the roots showed that the root hard tissues were more vulnerable to demineralization than was the dental enamel.

Roots of extracted human molars were treated for both 10 and 30 min with a saturated solution of dicalcium phosphate dihydrate (DCPD) of pH 2.4 and subsequently with a 5.3 mmol.L -1 solution of sodium fluoride of pH 7.0. The objective of these combined treatments was to convert the highly-soluble root mineral into the less-soluble fluoridated hydroxylapatite, with DCPD as an intermediate, to improve caries resistance. The mineral content of the surface layer was not affected in a significant way. Roots treated in this way were subjected to 50 mmol.L-1 acetate buffer solutions of pH 5.5 and with pIOHA-values of 112, 116, and 122. The proportional reduction of the rate of demineralization (Vdem) of similarly treated roots subjected to buffer solutions of pIOHA 112 and 116 appeared to be equal initially. Since fluoridated hydroxylapatite is insoluble under these conditions, these findings are in agreement with expectations. The reduction of Vdem amounted to about 45 and 70% for roots treated for 10 and 30 min, respectively. When roots were treated for 10 and 30 min and then exposed to buffer solutions with a pIOHA 122, reductions of Vdem of about 30 and 55%, respectively, were found. Conversion of the root mineral into fluoridated hydroxylapatite can eliminate, in principle, the existing difference in caries susceptibility of the root and of the dental enamel.

Fluoride specifically adsorbed to hydroxyapatite reduces the rate of dissolution of hydroxyapatite. Since specific adsorption is a property which anions of all weak acids have in common, it is expected that the anions of lactic and acetic acid will be specifically adsorbed to hydroxyapatite too and in this way will cause a reduction in the rate of dissolution of hydroxyapatite. In order to investigate this, we used the experimental results from Featherstone and Rodgers (1981). Calculations of the rate of increase of the lesion depth in dental enamel per mmol. L -1 of the un-ionized acid revealed that lesion progress was pH-dependent and was lowest at that pH which corresponds with the pK-value of the relevant acid. It is concluded that the anions of lactic and acetic acid are specifically adsorbed to the enamel mineral and in this way reduce the rate of dissolution of the mineral. This suggests that a description of the development of an artificial caries lesion in mathematical terms should include the effect on the rate of dissolution of the mineral of specific adsorption of the relevant acid anions to the mineral.

P ermanent filling materials have some deficiencies such as dehydration of dentin by the withdrawal of water during the hardening process, penetration of pulpirritating components of the filling material into dentin, and microleakage around the filling due to lack of adaptation. To protect the pulp against these irritations, an applied intermediary base material that has good sealing properties should be used. Intermediary base materials can be divided into three groups: varnishes, liners (varnish with additives such as calcium hydroxide or zinc oxide), and cements. In vitro the amount of most varnishes applied as a continuous layer has slight permeability.‘” However, in vivo experiments suggest that these varnishes are not always as effective as pulp protectors as might be expected from the results of the in vitro experiments.‘-” This discrepancy may occur because in most in vitro experiments the investigated materials are applied on materials different from dentin. For testing the sealing capacity of varnishes, the kind of supporting material is important. A supporting material with bad wetting properties may lead to discontinuities in the obtained layers.* This investigation studied the sealing properties of some intermediary base materials applied in vitro on dentin in a way that corresponds as much as possible with the in vivo situation in dental practice.

Tritiated proline was administered to domestic cats during the development of their permanent premolars. The metabolic activity of collagen in the mature premolar dentin was determined by quantitating the amount of tritiated hydroxyproline in the dentin as a function of time. It has been demonstrated that the metabolic activity of the dentinal collagen was extremely low and remained within the experimental error for a period of 45 weeks.

Whole roots of molars that had never been exposed to the mouth were exposed to calcium and phosphate-containing buffer solutions with discrete values of pIOHA [i.e. -log(a10Ca2+ X a6PO4(3-) X a2OH-)] at various pH. From densitometric measurements on contact-microradiographs of transverse sections of the roots the rate of demineralization (Vdem) was calculated. Vdem changed non-linearly as a function of pIOHA and became zero at a pIOHA-value of 105.3 +/- 0.4; this is substantially lower than the corresponding value of 118 +/- 1 for enamel. Thus root mineral is more soluble than enamel mineral. The critical pH for root caries appears to be about 6.7, provided that the plaque fluid follows about the same pH-pIOHA- pathway as acidified saliva.