Search

An attractive solution to mitigate tars and also to decompose lighter hydrocarbons in biomass gasification is secondary catalytic reforming, converting hydrocarbons to useful permanent gases. Albeit that it has been in use for a long time in fossil feedstock catalytic steam reforming, understanding of the catalytic processes is still limited. Naphthalene is typically present in the biomass gasification gas and to further understand the elementary steps of naphthalene transformation, we investigated the temperature dependent naphthalene adsorption, dehydrogenation and passivation on Ni(111). TPD (temperature-programmed desorption) and STM (scanning tunneling microscopy) in ultrahigh vacuum environment from 110 K up to 780 K, combined with DFT (density functional theory) were used in the study. Room temperature adsorption results in a flat naphthalene monolayer. DFT favors the dibridge[7] geometry but the potential energy surface is rather smooth and other adsorption geometries may coexist. DFT also reveals a pronounced dearomatization and charge transfer from the adsorbed molecule into the nickel surface. Dehydrogenation occurs in two steps, with two desorption peaks at approximately 450 and 600 K. The first step is due to partial dehydrogenation generating active hydrocarbon species that at higher temperatures migrates over the surface forming graphene. The graphene formation is accompanied by desorption of hydrogen in the high temperature TPD peak. The formation of graphene effectively passivates the surface both for hydrogen adsorption and naphthalene dissociation. In conclusion, the obtained results on the model naphthalene and Ni(111) system, provides insight into elementary steps of naphthalene adsorption, dehydrogenation, and carbon passivation, which may serve as a good starting point for rational design, development and optimization of the Ni catalyst surface, as well as process conditions, for the aromatic hydrocarbon reforming process.

The concept of bonding and antibonding orbitals is fundamental in chemistry. The population of those orbitals and the energetic difference between the two reflect the strength of the bonding interaction. Weakening the bond is expected to reduce this energetic splitting, but the transient character of bond-activation has so far prohibited direct experimental access. Here we apply time-resolved soft X-ray spectroscopy at a free electron laser to directly observe the decreased bonding antibonding splitting following bond-activation using an ultrashort optical laser pulse.

We show that coadsorbed oxygen atoms have a dramatic influence on the CO desorption dynamics from Ru(0001). In contrast to the precursor-mediated desorption mechanism on Ru(0001), the presence of surface oxygen modifies the electronic structure of Ru atoms such that CO desorption occurs predominantly via the direct pathway. This phenomenon is directly observed in an ultrafast pump-probe experiment using a soft x-ray free-electron laser to monitor the dynamic evolution of the valence electronic structure of the surface species. This is supported with the potential of mean force along the CO desorption path obtained from density-functional theory calculations. Charge density distribution and frozen-orbital analysis suggest that the oxygen-induced reduction of the Pauli repulsion, and consequent increase of the dative interaction between the CO 5 sigma and the charged Ru atom, is the electronic origin of the distinct desorption dynamics. Ab initio molecular dynamics simulations of CO desorption from Ru(0001) and oxygen-coadsorbed Ru(0001) provide further insights into the surface bond-breaking process., AuthorCount:25

We studied CO oxidation on Ru(0001) induced by 400 nm and 800 nm femtosecond laser pulses where we find a branching ratio between CO oxidation and desorption of 1: 9 and 1: 31, respectively, showing higher selectivity towards CO oxidation for the shorter wavelength excitation. Activation energies computed with density functional theory show discrepancies with values extracted from the experiments, indicating both a mixture between different adsorbed phases and importance of non-adiabatic effects on the effective barrier for oxidation. We simulated the reactions using kinetic modeling based on the two-temperature model of laser-induced energy transfer in the substrate combined with a friction model for the coupling to adsorbate vibrations. This model gives an overall good agreement with experiment except for the substantial difference in yield ratio between CO oxidation and desorption at 400 nm and 800 nm. However, including also the initial, non-thermal effect of electrons transiently excited into antibonding states of the O-Ru bond yielded good agreement with all experimental results.

Femtosecond x-ray laser pulses are used to probe the carbon monoxide (CO) oxidation reaction on ruthenium (Ru) initiated by an optical laser pulse. On a time scale of a few hundred femtoseconds, the optical laser pulse excites motions of CO and oxygen (O) on the surface, allowing the reactants to collide, and, with a transient close to a picosecond (ps), new electronic states appear in the OK-edge x-ray absorption spectrum. Density functional theory calculations indicate that these result from changes in the adsorption site and bond formation between CO and O with a distribution of OC-O bond lengths close to the transition state (TS). After 1 ps, 10% of the CO populate the TS region, which is consistent with predictions based on a quantum oscillator model., AuthorCount:30

We demonstrate the use of intense, quasi-half-cycle THz pulses, with an associated electric field component comparable to intramolecular electric fields, to direct the reaction coordinate of a chemical reaction by stimulating the nuclear motions of the reactants. Using a strong electric field from a THz pulse generated via coherent transition radiation from an ultrashort electron bunch, we present evidence that CO oxidation on Ru(0001) is selectively induced, while not promoting the thermally induced CO desorption process. The reaction is initiated by the motion of the O atoms on the surface driven by the electric field component of the THz pulse, rather than thermal heating of the surface.

At low coverage of water on Cu(110), substrate-mediated electrostatics lead to zigzagging chains along [001] as observed with STM [T. Yamada, S. Tamamori, H. Okuyama, and T. Aruga, Anisotropic water chain growth on Cu(110) observed with scanning tunneling microscopy Phys. Rev. Lett. 96, 036105 (2006)]. Using x-ray absorption spectroscopy we find an anomalous low-energy resonance at similar to 533.1 eV which, based on density functional theory spectrum simulations, we assign to an unexpected configuration of water units whose uncoordinated O-H bonds directly face those of their neighbors; this interaction repeats over trough sites with enhanced electron density and is analogous to the case of a hydrated electron., AuthorCount:10

We report on an experimental system designed to probe chemical reactions on solid surfaces on a sub-picosecond timescale using soft X-ray emission spectroscopy at the Linac Coherent Light Source (LCLS) free electron laser (FEL) at the SLAC National Accelerator Laboratory. We analyzed the O 1s X-ray emission spectra recorded from atomic oxygen adsorbed on a Ru(0001) surface at a synchrotron beamline (SSRL, BL13-2) and an FEL beamline (LCLS, SXR). We have demonstrated conditions that provide negligible amount of FEL induced damage of the sample. In addition we show that the setup is capable of tracking the temporal evolution of electronic structure during a surface reaction of submonolayer quantities of CO molecules desorbing from the surface., AuthorCount:18

Vibrational spectroscopy using sum-frequency generation has been used to investigate the coupling between a ferromagnetic thin film and adsorbed molecules, here CO on Ni/Cu(100). The CO stretching vibration exhibits a strong magnetic contrast with a pronounced temperature dependence, underlining the high sensitivity of this adsorbate-specific spectroscopy method. Our results indicate that the strong temperature dependence is caused by dynamical changes in the surface chemical bond when the CO stretch vibration is coupled to thermally excited external vibrational modes., AuthorCount:6