Search

The exploration and development of tight gas is a significant area of interest, yet the efficient development of this resource still faces considerable challenges. Statistical data indicate that China possesses approximately 1.5 × 1012 m3 of proven dense gas reserves, which are concentrated in areas with high water content and a low abundance of pores. This makes it challenging to utilise these reserves effectively and to extract them in a cost-effective manner. As exploration and development continue, numerous challenges emerge, including low production capacity, significant discrepancies between single gas wells, uncertain control reserves of horizontal gas wells, and the unclear distribution law of the remaining gas. In light of the aforementioned issues, this study examined a representative dense and high-water-bearing gas reservoir in the D gas wells region of the S gas field. The gas wells within the target gas block were classified and analysed. By elucidating the seepage mechanism of the dense and high-water-bearing gas reservoir and integrating it with the material balance equation, a recovery prediction method for the dense and high-water-bearing gas reservoir was devised. [ABSTRACT FROM AUTHOR]

The brittleness index, as the most important parameter for brittleness evaluation, directly affects the compressibility of unconventional reservoirs. Currently, there is no unified calculation method for the brittleness index. This article uses a three-axis rock mechanics servo testing system to test the rock mechanics parameters of shale oil reservoirs in Block Y of the Ordos Basin and uses an X'Pert PRO X-ray diffractometer to test the rock mineral composition. The average volume fraction of quartz minerals, feldspar, and clay minerals in 36 samples of Block Y was tested to be 22.6%, 51.6%, and 18%, respectively. Calcite, dolomite, and pyrite are only present in a few samples. When the confining pressure is 30 MPa, the elastic modulus of the Chang 7 shale in this block is 14.72–34.58 GPa, with an average value of 23.77 GPa; The Poisson's ratio ranges from 0.106 to 0.288, with an average of 0.182; The differential stress ranges from 100.8 to 260.1 MPa, with an average of 164.36 MPa; The peak strain ranges from 0.57 to 1.21, with an average of 0.91. This article compares several mainstream brittle index evaluation methods and identifies the most suitable brittle index evaluation method for Block Y. Using the Jarvie mineral composition method to calculate the brittleness index 1 (MBI), the average value of 36 experimental results is 0.5393. Using the Rickman normalized Young's modulus and Poisson's ratio average value to calculate the brittleness index 2 (EBI), the average value of 36 experimental results is 0.5204. Based on the stress-strain curve and energy method, a model for brittleness index 3 (DBI) is established, and the average value of 36 experimental results is 0.5306. The trend of the brittleness index calculated by the three methods is consistent, indicating the feasibility of the newly established brittleness evaluation method. From the perspectives of mineral composition, rock mechanics parameters, and energy, establishing a brittleness evaluation method for shale oil reservoirs and studying its evaluation method is of great significance for sweet spot prediction in reservoir engineering, providing theoretical support for the selection of fractured intervals in the Chang 7 shale oil reservoir in Block Y of the Ordos Basin. [ABSTRACT FROM AUTHOR]

The Chang 7 continental shale oil reservoir is tight. The recovery factor is extremely low, the remaining oil is very high, and injecting water to improve oil recovery effectiveness is too hard. Therefore, in this paper, physical simulation experiments of CO2 huff-n-puff shale oil and NMR tests were conducted to study the cycle numbers and permeability on the recovery degree, as well as the characteristics of shale oil mobilization and the remaining oil micro distribution. The results showed that the cumulative oil recovery factors (ORFs) gradually increased in the natural logarithmic form, the single cycle ORFs decreased rapidly in exponential form with the huff-n-puff cycle number, and the biggest economic cycle numbers were between approximately 3 and 5. Furthermore, the higher the permeability, the higher the ORF, but the difference of ORF decreased between the two experimental samples with the cycles. In addition, the gap of production and recovery degree was large between the different scale pores, the ORF of macropores was 6–8 times that of micropores, and the final remaining oil was mainly distributed in the micropores, accounting for 82.29% of the total amount; meanwhile, the macropores comprised less than 0.5%. In the process of huff-n-puff, CO2 flowed into macropores, mesopores, and smallpores under the pressure differential effect, but a small amount of CO2 slowly diffused into micropores, resulting in the ORF of the former with more free oil being higher and the ORF of micropores with more adsorbed oil being lower. Therefore, promoting a better contact and reaction between CO2 and shale oil of micropores is one of the key ways to effectively develop the Chang 7 continental shale oil and enhance oil recovery. [ABSTRACT FROM AUTHOR]