Search

This paper includes a discussion of the results of tests concerning changes in the thermal and emission parameters of a boiler fuelled with wood biomass under the influence of air gradation in the combustion process. The test results ensure insight into the combustion process of wood biomass with air gradation, which significantly affected the operation of the device, increasing the mass concentration of the emitted nitrogen oxide (NOx) by combustion temperature lowering, especially in the afterburning zone. The authors observed an increase in the emission of particulate matter (PM) and carbon monoxide (CO) related to the change in the combustion process stoichiometry. The tests were carried out with the use of a heating boiler equipped with an automatic pellet burner. Apart from the mass concentration measurement of the pollution emitted, the tests focused on the measurements of temperature and oxygen levels in the flue gas. The objective of the tests was to confirm the applicability of the air gradation techniques in biomass combustion in order to reduce the emission of harmful substances from heating boilers, which is a technique that has recently been used in this group of devices. The test results obtained confirm the necessity for reorganising the technical systems of the currently used pellet burners and implementing further empirical tests. [ABSTRACT FROM AUTHOR]

This article is a summary of many years of work by the author, in which the thermal properties of various types of insulating liquids, used in power transformers, were evaluated. Recently, esters have been displacing mineral oil. There is a common view that mineral oil has better thermal properties than esters. This claim is supported by comparative results of tests of both materials as a liquid only filling the remaining volume of the transformer. The effect of the type of liquid on the thermal properties of the paper–oil insulation has not been analyzed so far. On this basis, the conclusions formulated may be incomplete. For this reason, the author has analyzed the influence of the type of liquid on both the thermal properties of the liquid filling the remaining volume of the transformer and the paper–oil insulation. It was proved that the more effective liquid filling the remaining volume of the transformer was indeed mineral oil. On the other hand, a more effective electrical insulating liquid, which is an element of paper–oil insulation, is a natural ester. A comprehensive assessment that takes into account both the paper–oil insulation and the remaining transformer volume showed that the natural ester proved to be a slightly more effective electrical insulating liquid than the other analyzed liquids. [ABSTRACT FROM AUTHOR]

The paper discusses the results of investigations of the change in thermal and emission-related parameters of a heating boiler fueled with biomass after a modification with a proprietary flue gas recirculation system made for this type of equipment. The results provide insight into the combustion process with a multistage flue gas recirculation that materially affected the boiler operation: a reduction in the mass concentration of nitrogen oxides (NOx) by reducing the combustion temperature. The authors also observed a reduction in the emission of particulate matters (PM) and carbon monoxide (CO). For the investigations, the authors used a heating boiler fitted with an automatic fuel feed (timber pellets) and a proprietary patented flue gas recirculation system (Polish patent Pat. 243395) for low power solid fuel heating boilers. Aside from the measurement of the mass concentration of the emitted pollutants, the research focused on the measurements of the temperature inside the combustion chamber, the temperature of the flue gas and the level of oxygen in the flue gas. The aim of the research was to confirm the validity of using the flue gas recirculation technique to reduce emissions of harmful substances from biomass heating boilers, as a technique not previously used for this group of devices. Moreover, the aim of the research was to test an original engineering solution, in the form of a flue gas distribution valve, and investigate its effect on reducing NOx emissions and improving other thermal and emission parameters of the boiler. The obtained research results confirm the validity of the chosen actions and provide a positive premise for the practical use of this technology in solid fuel heating boilers. [ABSTRACT FROM AUTHOR]

These liquids are an alternative to mineral oil, which is a traditionally used electrical insulating liquid in power transformers. This is a beneficial feature of the liquid, which makes the ability of the liquid to cool the transformer increase as the temperature increases. Nadolny et al. [[3]] described the influence of various parameters of electrical insulating liquids used in power transformers affecting the heat transfer coefficient , which is the key thermal property of the liquid. Nadolny, in [[14]], analyzed the value of dielectric losses that occur in the electrical insulating liquid and paper insulation in the power transformer, using as an example a 110/220 kV unit. [Extracted from the article]

Proper work of the power transformer is determined by many factors. One of them is relatively low operating temperature of the transformer. Too high temperature has many negative consequences, such as fast aging process of the insulation system. The temperature depends on the load of transmission line, losses and heat exchange in transformer. Heat exchange depends on heat transfer factor α of insulation liquid, which is a component of insulation system of transformer. This factor depends on many factors: the type of insulation liquid, the length of the heating element (windings), temperature, winding surface heat load, the winding position (vertical, horizontal), place on the winding (upper, middle or bottom part). The article presents the results of the measurement of heat transfer factor α as a function of type of insulation liquid, winding surface heat load, and place on the windings. The results will be used by designers and operators of power transformers.

The article describes research results of thermal properties of mineral oil and natural ester. Percentage proportions of both the liquids were as follows: 100/0, 95/5, 80/20, 50/50, 20/80, 0/100. The authors present measurement results of thermal conductivity, viscosity, specific heat, density, and thermal expansion of the created mixtures. The measurements were taken in a relatively wide temperature range: 25 °C, 40 °C, 60 °C, and 80 °C. On the basis of the measurement results, convection heat transfer coefficient α was calculated and the most advantageous proportion of both the components of the mixture was pointed in terms of cooling effectiveness of the transformer.

The article presents the results of computer simulation of temperature field of transformer filled with mineral oil and alternatives insulating liquids which include synthetic and natural esters. The analysis was based on the results of computer simulation of temperature field of 10 MVA distribution transformer, using the program COMSOL Multiphysics.

The paper presents the results of the measurements of heat transfer coefficient of insulating liquids used in transformers. The coefficient describes an ability of the liquid to heat transport. On the basis of the coefficient, effectiveness of cooling system of electric power devices can be estimated. Following liquids were used for the measurements: mineral oil, synthetic ester and natural ester. It was assumed that surface heat load is about 2500 W·m-2, which is equal the load of transformer windings. A height of heat element was 1.6 m, because it makes possible steady distribution of temperature on its surface. The measurements of heat transfer coefficient was made as a function of various position of heat element (vertical, horizontal). In frame of horizontal position of heat element, three suppositions were analysed: top, bottom, and side.

Copyright of Przegląd Elektrotechniczny is the property of Przeglad Elektrotechniczny and its content may not be copied or emailed to multiple sites or posted to a listserv without the copyright holder's express written permission. However, users may print, download, or email articles for individual use. This abstract may be abridged. No warranty is given about the accuracy of the copy. Users should refer to the original published version of the material for the full abstract. (Copyright applies to all Abstracts.)