Search

Abstract Background Pharmacological activity of intramammary drugs depends on adequate drug concentrations within the cistern, but sampling is often limited. Insight into the active drug concentration within the mammary cistern may assist in determining effective and appropriate therapeutic decisions for cows being treated for mastitis. Objective Evaluate the disposition of ceftiofur hydrochloride administered intramammary in diseased and nondiseased quarters. Whole milk and ultrafiltrate sampling techniques were compared. Animals Ten mature, late lactation Holstein (n = 9) and Jersey (n = 1) dairy cows (422‐670 kg) with naturally occurring clinical mastitis, producing between 1.4 and 15.9 kg/day of milk. Methods Ultrafiltration probes were placed in both mastitic and healthy quarters. Each quarter was treated with 2 doses of 125 mg ceftiofur hydrochloride suspension, and whole milk and milk ultrafiltrate samples were collected. Ceftiofur concentrations in composite whole milk and milk ultrafiltrate were analyzed. Results The maximum concentration of ceftiofur was higher in ultrafiltrate samples, but no differences were identified in healthy or mastitic quarters. The use of ultrafiltration probes provides a novel technique for free drug concentrations within the mastitic and healthy bovine mammary gland. Conclusions and Clinical Importance Significant inter‐ and intracow variability and lower daily milk weights may overestimate ceftiofur concentrations available within the cistern. The pharmacokinetic (PK) parameters reported in milk ultrafiltrate will help establish a link between the PK and the corresponding drug effect, potentially providing a meaningful rationale for the selection of a safe and effective dose in cows with mastitis.

Goal of this work is the investigation of roughness influences on the abrasive wear behaviour of magnetron sputtered multi-layered, low-friction coatings on carbon-fibre reinforced polymers (CFRP). Higher coating roughness at similar CFRP quality was realized by higher deposition rates, leading to increased heat flux to the substrates during deposition. Thermal expansion of the epoxy matrix on the micro scale results in a wavy, wrinkled surface topography. Both in scratch and reciprocal sliding testing against alumina, the friction coefficients are lower for the smooth coatings, but their wear rate is higher due to low-cycle fatigue caused abrasion.

Abstract Since wound healing requires cells to repopulate a damaged area, cell migration is essential. In addition, migration plays a crucial role in cancer metastasis. Whether tumour cells can invade tissue and metastasize is a crucial factor determining their malignancy or in other words a hallmark of cancer (Lazebnik in Nat Rev Cancer 10: 232–233, 2010, https://doi.org/10.1038/nrc2827 ). Nanodiamonds potentially offer a powerful tool to investigate these migration processes. Due to their unprecedented photostability, they can function as long-term fluorescent labels. Besides, nanodiamonds are robust quantum sensors that can reveal, for instance, the temperature or the concentration of certain chemicals with nanoscale resolution. However, to utilise nanodiamonds to study cell migration, it is essential to understand if and how the presence of nanodiamonds influences cell migration. Here, we investigate this process for the first time. We found that nanodiamonds do not alter the speed at which HeLa cells populate a scratch at any tested concentrations. Furthermore, we tested cell attachment by quantifying focal adhesion points. Oxygen-terminated fluorescent nanodiamonds influence the cell spreading, the number of focal adhesions and the size of focal adhesion points. Interestingly, this is different for other types of nanodiamonds in the literature. For these particles, it has been described in the literature that they hinder cell migration. Our results support that fluorescent nanodiamonds do not influence cell migration strongly and thus can be used in labelling and sensing migrating cells. Graphical Abstract

Pure Zn is well-known for its appropriate corrosion rate, making it suitable for use as future absorbable implants. Yet, it suffers from insufficient strength, thus, both plastic deformation and alloying are required. Hydrostatic extrusion has proven to be an efficient technique, providing high mechanical properties for zinc alloys. However, its effect on degradation rate and biocompatibility of Zn alloys remains unknown. Thus, within the present study, an attempt to evaluate those properties has been made on hydrostatically extruded pure Zn, Zn–Mg and Zn–Mg–Cu alloys. The materials were characterized by advanced microscopy techniques and uniaxial tensile tests. Corrosion properties were assessed based on electrochemical and static immersion tests. Finally, the cytotoxic effect of zinc extracts on endothelial cells were examined by standard MTT assays combined with confocal imaging.The results showed that hydrostatic extrusion results in significant refinement of α-Zn grains and the intermetallic phase Mg2Zn11 for the investigated alloys. The alloys exhibited ultimate tensile strength exceeding 300 MPa and elongation higher than 20%. Corrosion tests demonstrated that all the materials showed a similar level of degradation rate. Moreover, the uniform distribution of the intermetallic phase contributed to homogeneous corrosion of Zn alloys. Biological studies indicated that the least cytotoxic response in endothelial cells was obtained for the Zn–Mg alloy. Such an effect was caused by the limited amount of released Zn ions in the favor of Mg ions.The refinement of α-Zn grains and intermetallic phases caused by hydrostatic extrusion were key factors determining the performance of Zn-based materials.

Due to their similarities in anatomy, physiology, and pharmacology to humans, mice are a valuable model system to study the generation and mechanisms modulating conventional outflow resistance and thus intraocular pressure. In addition, mouse models are critical for understanding the complex nature of conventional outflow homeostasis and dysfunction that results in ocular hypertension. In this review, we describe a set of minimum acceptable standards for developing, characterizing, and utilizing mouse models of open-angle ocular hypertension. We expect that this set of standard practices will increase scientific rigor when using mouse models and will better enable researchers to replicate and build upon previous findings.

BackgroundFlunixin is commonly used in goats in an extra-label manner, indicating a significant need to determine withdrawal intervals for edible tissues.ObjectiveThe objectives of the present study were to investigate the depletion of flunixin meglumine in various goat tissues, including the liver, kidney, fat, and muscle.MethodsTwenty Boer goats were enrolled and administered an intravenous dose (2.2 mg/kg) of flunixin meglumine. Five animals were randomly euthanized at 24, 48, 72, or 96 h following dosing. All samples were analyzed via ultra-performance liquid chromatography coupled with mass spectrometry.ResultsThe concentration of flunixin in all tissues declined rapidly, with the highest mean concentrations quantified in the kidney (0.137 ± 0.062 μg/g) and liver (0.077 ± 0.029 μg/g) tissues at 24 h.ConclusionSince any detection of flunixin residues at slaughter found in goat tissues is considered a violative residue, a conservative withdrawal interval of 17 days was calculated to ensure levels of flunixin fell below the regulatory limits of detection in liver, kidney, and muscle tissues.

Nanodiamonds are increasingly popular in biomedical applications, including optical labelling, drug delivery and nanoscale sensing. Potential new applications are in studying infertility or labelling sperm cells. However, for these applications, it is necessary that nanodiamonds are inert and do not alter sperm properties. In this article, we assessed the biocompatibility of nanodiamonds in detail. We investigated different sizes and concentrations of nanodiamonds and sperm preparation methods. We evaluated if the metabolic activity, membrane integrity, morphology and formation of reactive oxygen species were altered. These parameters were tested for sperm cells in their uncapacitated and capacitated states. Unfortunately, FNDs are not universally biocompatible. Generally, cells in the capacitated state are more prone to stress. Additionally, larger particles and lower concentrations are tolerated better than smaller and higher concentrated particles.

Background: Pharmacological activity of intramammary drugs depends on adequate drug concentrations within the cistern, but sampling is often limited. Insight into the active drug concentration within the mammary cistern may assist in determining effective and appropriate therapeutic decisions for cows being treated for mastitis. Objective: Evaluate the disposition of ceftiofur hydrochloride administered intramammary in diseased and nondiseased quarters. Whole milk and ultrafiltrate sampling techniques were compared. Animals: Ten mature, late lactation Holstein (n = 9) and Jersey (n = 1) dairy cows (422‐670 kg) with naturally occurring clinical mastitis, producing between 1.4 and 15.9 kg/day of milk. Methods: Ultrafiltration probes were placed in both mastitic and healthy quarters. Each quarter was treated with 2 doses of 125 mg ceftiofur hydrochloride suspension, and whole milk and milk ultrafiltrate samples were collected. Ceftiofur concentrations in composite whole milk and milk ultrafiltrate were analyzed. Results: The maximum concentration of ceftiofur was higher in ultrafiltrate samples, but no differences were identified in healthy or mastitic quarters. The use of ultrafiltration probes provides a novel technique for free drug concentrations within the mastitic and healthy bovine mammary gland. Conclusions and Clinical Importance: Significant inter‐ and intracow variability and lower daily milk weights may overestimate ceftiofur concentrations available within the cistern. The pharmacokinetic (PK) parameters reported in milk ultrafiltrate will help establish a link between the PK and the corresponding drug effect, potentially providing a meaningful rationale for the selection of a safe and effective dose in cows with mastitis. [ABSTRACT FROM AUTHOR]

The paper considers the problem of nonparametric estimation of nonlinear characteristic in the FIR Wiener system. Methods proposed so far have suffered from the so-called 'curse of dimensionality' and their practical applications have been limited to the very short impulse responses of the linear component. In the proposed approach, the class of (stochastically initialised) repeated exponential input excitations is introduced, and a modified kernel-based estimator is presented. It is shown that the rate of convergence to the genuine system characteristic is significantly improved and does not depend on the length of the impulse response of the linear dynamic block. [ABSTRACT FROM AUTHOR]

Starting in 2021, Poland's emission reduction target for 2030, in the sectors not covered by the European Union Emissions Trading System (EU ETS) is −7% compared to the emissions level in the non-ETS sectors in 2005. This is a big change in comparison with the target for the period of 2013–2020, which assumed potential emissions increase relative to the same baseline and was +14% by 2020. In order to cope with the need to make a much greater reduction effort, Poland will likely need to use flexibility mechanisms to support achieving the more ambitious target.

Primary open-angle glaucoma is one of the leading causes of blindness worldwide. With limited therapeutics targeting the pathogenesis at the trabecular meshwork (TM), there is a great need for identifying potential new targets. Recent evidence has implicated Toll-like receptor 4 (TLR4) and it is signaling pathway in augmenting the effects of transforming growth factor beta-2 (TGFβ2) and downstream extracellular matrix production. In this review, we examine the role of TLR4 signaling in the trabecular meshwork and the interplay between endogenous activators of TLR4 (damage-associated molecular patterns (DAMPs)), extracellular matrix (ECM), and the effect on intraocular pressure

This article describes the effects of microstructures in an analysis of lead-free solders, namely SnAg, SnBi and SnIn, using X-ray fluorescence spectrometry (XRF). The size of the microstructures in the samples and calibration materials has a strong impact on the calibration accuracy and results. A comparison of the microstructure size and critical thickness values demonstrated the importance of the former parameter in terms of the analyzed volume of the specimen. The re-melting and casting in an induction furnace at developed conditions were determined to be a way to obtain samples with fine-grained microstructures. Calibration with re-melted reference materials yielded more accurate calibration curves than calibration using the materials in their original state. Re-melting of the samples resulted in improvements in the XRF results in comparison to the reference values. This improvement is especially important in case of alloying elements with concentrations that determine the recognition of a specific solder grade., Author(s): Tadeusz Gorewoda [sup.1], Zofia Mzyk [sup.1], Jacek Anyszkiewicz [sup.1], Katarzyna Bilewska [sup.1], Andrzej Cybulski [sup.1], Joanna Golebiewska-Kurzawska [sup.1], Magdalena Knapik [sup.1], Justyna Kostrzewa [sup.1], Magdalena Grzegorczyk [sup.1], Szymon Malara [...]

To date 15% of couples are suffering from infertility with 45–50% of males being responsible. With an increase in paternal age as well as various environmental and lifestyle factors worsening these figures are expected to increase. As the so-called free radical theory of infertility suggests, free radicals or reactive oxygen species (ROS) play an essential role in this process. However, ROS also fulfill important functions for instance in sperm maturation. The aim of this review article is to discuss the role reactive oxygen species play in male fertility and how these are influenced by lifestyle, age or disease. We will further discuss how these ROS are measured and how they can be avoided during in-vitro fertilization.