Search

Forty Holstein vealers (approximately 16 weeks of age) were slaughtered, skinned, split longitudinally and one side was electrically stimulated (700 V, 2 A and seventeen impulses) for 1 min. Internal temperatures of the rib and round were recorded at 1 h and 24 h post mortem. Approximately 24 h post mortem, lean colour scores were assigned to the cross-section of the longissimus muscle at the 11th-12th rib interface, to the outside surface of the biceps femoris muscle and to the rectus abdominis and transverse abdominis muscles of the flank; lean texture and firmness scores were also assigned to the cut surface of the longissimus muscle. 'House grades' were assigned to each side of each carcass by plant personnel. Initial (1 h) rib and round temperatures were significantly higher for the electrically stimulated sides; however, at 24 h, neither round nor rib temperatures differed between control and electrically stimulated sides. Lean colour, firmness and texture scores for longissimus muscles were significantly (P < 0·0001) improved by electrical stimulation. Electrically stimulated sides also had lighter lean colour scores in the rectus and transverse abdominis and biceps femoris muscles. Electrical stimulation increased the number of carcasses receiving the top 'house grade' and reduced the number of carcasses in the lowest 'house grade'. These data indicate that electrical stimulation will improve lean colour, firmness and texture of veal carcasses when ribbed and evaluated after a 24 h chill., (Copyright © 1982. Published by Elsevier Ltd.)

Thirty-eight steers and thirty heifers (14 to 17 months of age, from F(1) Hereford × Brahman cows bred to Angus or Hereford bulls), were either forage-fed for 123 days on millet-bermudagrass pasture or grain-fed for 90 days on a high-concentrate diet and were then commercially slaughtered. Warm carcass weights ranged from 167·8 kg to 324·3 kg. At 24 h post mortem, Texas Agricultural Experiment Station personnel (1) assigned scores or took measurements on each carcass for all factors used in yield grading and quality grading, (2) measured the length of hind leg (HL) and carcass length (CL) and (3) assigned a score for carcass muscling (MS) and, as appropriate, made an adjusted longissimus muscle area (ALA) evaluation. The 9th-10th-11th rib section from one side of each carcass was physically separated into longissimus muscle, fat, 'other soft tissue' and bone and ether extract determinations of the longissimus muscle and 'other soft tissue' components were made and used to adjust the yields of each of these components to a fat-free basis. Muscle to bone ratios ranged from 2·38 to 4·37. With both age and carcass weight held constant, diet, breed and sex explained only 35·8% of the variation in muscle to bone ratio. The best simple correlation with muscle to bone ratio was ALA/CL (r = ·59). Other measures significantly correlated with muscle to bone ratio included ALA (r = 0·55), MS (r = 0·50) and carcass weight (r = 0·49). Multiple regression analyses identified a three-variable subset comprised of ALA, carcass weight and CL which was related (P < 0·01) to muscle to bone ratio R(2) = 0·41). Data suggest that muscle to bone ratios differ widely among beef carcasses of similar genetic-management history and that there are carcass measures useful for predicting muscle to bone ratio., (Copyright © 1982. Published by Elsevier Ltd.)

Twenty-five carcasses from each of three breedtypes (Brahman, Angus and Brahman × Angus) were physically separated into fat, lean and bone. Several muscles from the round and the femur were used to derive equations to predict carcass composition and muscle-to-bone ratio. The femur (as a percentage of the carcass) was shown to predict percentage carcass bone with 90% accuracy. All of the muscles studied were highly related to total carcass lean but the percentage of carcass as M. biceps femoris was the best single muscle indicator of carcass lean of the muscles studied. More variation in carcass lean could be accounted for by a multiple regression equation, involving all four muscles studied, than by any single muscle. M. biceps femoris-to-femur ratio was found to predict carcass muscle-to-bone ratio with a high degree of accuracy. The USDA yield grades were found to be reliable indicators of carcass composition. A two-variable equation involving adjusted fat thickness and biceps femoris accounted for 88·6% of the variation (RSD = 1/·64) in percentage of carcass as separable lean., (Copyright © 1985. Published by Elsevier Ltd.)

Thirty Santa Gertrudis bulls (approximately 15-18 months old) were slaughtered, dressed and split into siides. The right side of each carcass was electrically stimulated (ES) with seventeen impulses (1·8s impulse duration; 1·8s interval between impulses) of 550 V (AC) and 5 A while the left side served as a non-stimulated control (not-ES). At 24h post morten, USDA quality and yield grade data were obtained from each side. On the second day post mortem, all sides were fabricated and strip loins, top sirloin butts and ribeyes were obtained from each side for post-mortem ageing and blade tenderisation studies. Steaks were removed after a post-mortem ageing period of 4 or 18 days and before (not-BT) or after blade tenderisation (BT) for sensory panel evaluations or shear force determinations. ES sides had more youthful lean maturity (P < 0·0001), higher marbling (P < 0.·002), higher USDA quality grades (P < 0·0.0001) and finer-textured lean (P < 0·002) than did not-stimulated (not-ES) sides. ES significantly improved (P < 0·05) palatability traits in two of twenty-four comparisons; BT significantly improved palatability traits in twelve of twenty-four comparisons and 18-day post-mortem ageing significantly improved palatability traits in seven of twelve comparisons. No significant reductions (P < 0·05) in shear force values were observed for steaks from ES versus not-ES sides while significant reductions (P < 0·05) were observed for steaks from BT versus non-BT cuts (four of six comparisons) and for steaks from cuts aged for 18 versus 4 days (ten of twelve comparisons). BT and 18-day post-mortem ageing were more effective for increasing palatability or for decreasing shear force requirements than was ES; however, ES greatly improved lean colour of meat from bulls., (Copyright © 1982. Published by Elsevier Ltd.)

Hot and cold Fat Depth Indicator (FDI) readings were taken on seventy-four pork sides to examine the relative precision of different measurement locations. Fat measurements taken over the M. longissimus opposite the fourteenth thoracic vertebra (CD = 47·5; RSD = 1·63) and the last lumbar vertebra (CD = 61·1; RSD = 1·40) were the measurement locations most closely associated with percentages of four trimmed lean cuts. Using certain combinations of carcass weight and/or hot and cold FDI readings in multiple regression equations, 71·0% (RSD = 1·35) and 63·3% (RSD = 1·55), respectively, of the variability in percentage yields of four lean cuts could be explained; this was as much as 40 percentage points more than that explained by average backfat thickness (first rib, last rib, last lumbar vertebra) taken on the split surface in the dorsal midline. When added to an unpublished equation, the addition of up to four hot or cold FDI readings made dramatic increases in the explained variation in carcass yields of four lean cuts. In each of two studies involving green, skinned hams, FDI readings explained a low percentage of the variability in percentage of boneless, defatted, deseamed lean. However, it was determined that these low relationships were primarily due to the site selections at which the hams were probed-not because of an inadequacy of the FDI to measure fatness. A third study, involving different FDI probe sites, taken on intact sides along the ham to loin-belly juncture, determined that the best of these FDI readings could account for a maximum of 66·1% of the variability (RSD = 2·75) in yield of bone-in, skinned, defatted hams; a four-variable prediction equation developed using two FDI readings, untrimmed ham weight and muscling score explained 83·9% of the variation (RSD = 2·04)., (Copyright © 1984. Published by Elsevier Ltd.)

Steer, heifer and cow carcasses (N=280) were selected from seven commercial firms in three states and completely fabricated to provide information on bone-in and boneless yields from the four primal wholesale cuts. Equations using combinations of easily obtainable subjective and objective traits accounted for between 63 and 80% of the variation in yields of bone-in or boneless retail cuts from the round, loin, rib or chuck. When bone was removed in preparation of retail cuts, scores or measures of muscling increased in importance as components of prediction equations. Prediction equations comprised of two, three or four independent variables that could be used in a commercial grading situation were developed for rounds, loins, ribs and chucks.

Sixty feeder steers were assigned scores for frame size (small, medium or large) and muscle thickness (No. 1, No. 2 or No. 3), fed for 112 days and slaughtered. Grade data were collected for all 60 carcasses; 12 sides (four from each muscle thickness group) were fabricated into boneless, closely trimmed retail cuts and the 12 rounds from each of these sides were also physically separated into muscle, fat and bone. Marbling score and USDA quality grade varied inversely (P < 0·05) with frame size. Carcass quality grades were: 33·3% Choice; 67·7% Good and 0·0% Standard for small-framed cattle; 30·3% Choice, 42·4% Good and 27·3% Standard for medium-framed cattle and 5·5% Choice, 66·7% Good and 27·8% Standard for large-framed cattle. Analysis of variance showed significant (P < 0·05) differences among all muscle thickness groups in the longissimus muscle area and carcass weight but no difference in yield grade between the No. 1 and No. 3 muscle thickness groups; the larger mean longissimus muscle area of carcasses from steers in the No. 1 muscle thickness group was offset by their heavier carcass weight and their greater thickness of fat over the longissimus muscle. However, when analysis of covariance was used to hold fatness or fatness and frame size constant, the difference in yield grade between muscle thickness groups No. 1 and No. 3 was significant (P < 0·05). Also, carcasses from cattle assigned muscle thickness scores of No. 1, as feeders, had the highest (P < 0·05) muscle to bone ratio of the round (4·1 to 1) while carcasses from cattle assigned thickness scores of No. 3, as feeders, had the lowest (P < 0·05) muscle to bone ratio of the round (3·4 to 1)., (Copyright © 1982. Published by Elsevier Ltd.)

Fifteen slaughter cattle from five groups (Charolais crossbred bulls, Brahman crossbred steers, Holstein steers, mixed-Exotic crossbred heifers and Hereford-Angus crossbred steers) were randomly selected from a commercial feedlot. Time-on-feed was 108, 114, 102, 108 and 145 days for the aforementioned groups, respectively. Carcasses from Charolais crossbred bulls had the highest percentage yield of chuck and round, but the lowest percentage yield of loin; hereford-Angus crossbred steers had the lowest percentage yield of round and Holstein steers had the lowest percentage yield of rib. Carcasses from Charolais crossbred bulls had the highest percentage yield of major retail-ready subprimals and lean trim, Hereford-Angus crossbred steers had the highest percentage yield of fat trim and Holstein steers had the highest percentage yield of bone from the major wholesale cuts. Mean percentage yields of closely trimmed, boneless retail cuts were highest for carcasses from the bulls and lowest for carcasses from the Hereford-Angus steers. Although Holstein steer carcasses had less fat trim than Brahman-crossbred steers mixed-Exotic heifers, this advantage was largely offset by their higher percentage of bone. Loin steaks from carcasses of Charolais crossbred bulls, Holstein, mixed-Exotic heifers were comparable (P > 0·05)with those of Hereford-Angus steers for shear force and sensory panel tenderness ratings. However, loin steaks from carcasses of Brahman-crossbred steers had significantly higher (P < 0·05) shear force values (least tender) and lower (P < 0·05) tenderness and overall palatability ratings. No diffeerences (P > 0·05) were found for flavor desirability of loin steaks among any of the groups. For bottom round steaks, Hereford-Angus steers received the highest palatability ratings while those from Holstein steers received the lowest palatability ratings., (Copyright © 1985. Published by Elsevier Ltd.)

Twenty-five steers of each of three breedtypes (Angus, Brahman and F(1) Brahman x Angus) were sorted by frame size and muscle thickness, assigned to groups (five steers of each breedtype) to be fed for 0, 56, 112, 168 or 224 days, slaughtered and compared for various carcass traits. Steers of each breedtype had similar dressing percentages. Carcasses from all three breedtypes merited similar USDA quality and yield grades; breedtypes differences in quality grade were slight. Differences were found in the fat deposition patterns exhibited by the three breedtypes. Brahman steers tended to deposit more of their total fat as subcutaneous fat early in the feeding period. Angus steers had more (P < 0·05) seam fat as a percentage of carcass weight at all five feeding periods and more (P < 0·05) kidney, pelvic and heart fat at two of the five feeding periods than Brahman steers. Brahman steers had a higher percentage of their separable lean in the muscles of the round than did steers of the other breedtypes., (Copyright © 1985. Published by Elsevier Ltd.)