Search

The effects of severe plastic deformation (SPD) process via high-speed high-pressure torsion technique on martensitic transformation of Ni–Fe–Ga Heusler shape memory alloy are the subject of this work. The results show that moderate degrees of deformation lead to a decrease in the martensitic transformation temperatures, while the heat of reaction is enhanced only for the sample processed with the lowest degree of deformation. The results are explained by the interplay between the constituent tetragonal L10 and the cubic gamma crystal structures and the evolution of the samples morphology with the severity of deformation. The reduction in the samples granulation due to the progressive increase in the SPD is reflected by the magnetic properties of the samples with decreasing coercivity and Curie temperatures. At the highest applied degree of deformation, sample nanostructuring and a possible amorphization might explain the vanishing of MT.

The influence of the rapid solidification technique and heat treatment on the martensitic transformation, magnetic properties, thermo- and magnetic induced strain and electrical resistivity is investigated for the Cu doped NiMnGa Heusler-based ferromagnetic shape memory ribbons. The martensitic transformation temperatures are unexpectedly low (below 90 K—which can be attributed to the disordered texture as well as to the uncertainty in the elements substituted by the Cu), preceded by a premartensitic transformation (starting at around 190 K). A thermal treatment slightly increases the transformation as well as the Curie temperatures. Additionally, the thermal treatment promotes a higher magnetization value of the austenite phase and a lower one in the martensite. The shift of the martensitic transformation temperatures induced by the applied magnetic field, quantified from thermo-magnetic and thermo-magnetic induced strain measurements, is measured to have a positive value of about 1 K/T, and is then used to calculate the transformation entropy of the ribbons. The magnetostriction measurements suggest a rotational mechanism in low fields for the thermal treated samples and a saturation tendency at higher magnetic fields, except for the temperatures close to the phase transition temperatures (saturation is not reached at 5 T), where a linear volume magnetostriction cannot be ruled out. Resistivity and magnetoresistance properties have also been measured for all the samples.

In this paper, we investigate the influence of Cu, Co, and Al substitutions on the transport properties, and in particular, the magnetoresistive effect in Ni–Fe–Ga ferromagnetic shape memory alloys (FSMAs) prepared as ribbons by melt spinning method and subjected to different thermal treatments. X-ray diffraction, differential scanning calorimetry, magnetometry, and magnetoresistive characterizations were performed. In the range of the martensitic transformation (MT), different FSMA compositions show a rich spectrum of different behaviors. For one of the compositions (Ni52Fe20Co2Ga23Al3), the magnetoresistance (MR) showed a local minimum or, on the contrary, a local maxima of reduced amplitude on cooling, in the range of the MT, depending on the performed thermal treatments. In the same composition, by replacing one Al atom with a Co one, no local extremes are seen, the alloy having a concomitant magneto-structural transition. When the magnetic field was varied, the MR showed a nonmonotonic variation in the martensite phase for some compounds, possibly due to the dynamics of the martensite variants realignment. From the studied compositions, the highest MR found on the MT of −9% for 5 T is for Ni50Fe20Ga27Cu3.

The effect of “in situ” thermal treatments (by DSC measurements) on the martensitic transformation in two representative Ni-Fe-Ga and Ni-Mn-Ga alloys has been studied and discussed by correlating the structural and magnetic properties. The alloys were prepared from high purity elements, by arc melting under argon protective atmosphere as bulk and also as melt-spun ribbons - an alternative preparation route that also allows to assess the influences of grains size and strain induced by this processing method. All samples presented reversible thermo-elastic transformations. The thermal treatments promote a reduction of the martensitic transformation temperatures in the Ni-Fe-Ga investigated samples, as opposed to the stoichiometric Ni2MnGa where the temperatures increase with increasing the annealing temperatures. Interestingly however, the off-stoichiometric Ni-Mn-Ga with increased Ni content recovers the behaviour with reduction of transformation temperatures by thermal treatments. The precipitation of the secondary FCC (γ) phase is inherently found in Ni-Fe-Ga alloys with Ga ≤ 27% at, and also -although in lower amounts- in the off-stoichiometric Ni-Mn-Ga. The γ phase is considered to contribute to the decrease of the MT temperatures (via valence electrons concentration depletion of the main matrix) and of the transformation heat as well as to the final structural degradation if the temperature of the thermal treatments is further increased. In addition, this phase, located mainly at the grain boundaries, is responsible for the improved ductility of Ni-Fe-Ga based alloys. Changes in the transformation heat due to thermal treatments are observed and discussed in both types of alloys, the maxima of the transformation heat being associated with the highest atomic order. Thermo-magnetic measurements show that Ni-Fe-Ga alloys have close magnetic and structural transitions temperatures, with promising applications for magnetic refrigeration.

Specific functional characteristics of the ferromagnetic shape memory alloy Fe67.5Pd30.5Ga2 prepared as ribbons by rapid quenching technique are reported. The shift of the martensitic transformation temperature induced by the applied magnetic field was determined from the thermomagnetic measurements at various fields up to 5T being proved to be in good agreement with the result obtained from calorimetric data via the Clapeyron - Claussius relation. Magnetostriction measurements reveal a pure spin rotation mechanism under low applied magnetic fields, allowed by the reduced magnetic anisotropy. In high magnetic fields and at temperatures close to martensitic transformation, the magnetostriction has a linear increase up to the maximum considered magnetic induction of 3T. This behavior has been discussed in connection with the forced magnetostiction aspects.

The functionality of the ferromagnetic shape memory alloys is related to the martensitic and magnetic order-disorder transformations, both of which may be tailored by doping with other elements or by suitable thermal treatments, so that alloys with concomitant (or sequential but close) structural and magnetic phase transitions may be obtained. Concerning the magnetocaloric applications, it is assumed that the thin melt-spun ribbons assure a more efficient heat transfer. In the present work we investigate the influence of Co and Al substitutions on magnetocaloric effect characteristics of NiFeGa in bulk and also in ribbons prepared by melt spinning method and subjected to different thermal treatments. X-ray diffraction, differential scanning calorimetry, magnetocaloric and magnetoresistive characterizations have been performed. The results highlight the differences between the bulk and the ribbons (both as prepared and annealed) and the role of substitutions.

The Mossbauer spectra of a FeSe0.3Te0.7 single crystal grown by the Bridgman method were analysed across the superconducting transition by considering the interplay between the structure and electron configuration of the transition metal. The magnetically determined superconducting critical temperature is TC ∼ 14 K. The 57Fe Mossbauer spectra collected in the temperature range from 5 to 200 K mainly have an asymmetric doublet pattern, which was conveniently fitted by the full Hamiltonian method. No effective magnetic moment ascribed to the superconducting phase was observed down to 5 K. The unusual behaviour observed below ∼17 K for the chemical isomer shift and quadrupole splitting may be associated with an electron reconfiguration process intimately related to an unusual lattice distortion accompanying the superconducting transition. The decreasing trend of the total absorption spectral area and second-order Doppler shift during cooling the sample below the critical temperature, point to enhanced phonon...