Search

[EN] For more than fifty years, hundreds of research works have focused on the study of annular flow because of its huge importance in many industrial processes, for instance, chemical, petroleum, etc., being of particular interest in nuclear industry. Specifically, interfacial waves play a vital role in the mass, momentum and energy transference processes between gas and liquid phases. This paper describes the new experimental measurements of vertical upward co-current two-phase gas-liquid flow carried out in a tube with an inner diameter of 44 mm. The liquid film thickness and the major characteristics of the interfacial waves have been measured using a non-intrusive instrument, a conductance probe. The physical phenomenon in which this device is based is the change in the electrical conductivity between air and water, i.e., the electrical signal collected in the sensor receiver depends on the thickness of the liquid film layer. The experimental measurements range from 2000 to 3500 l/min for the gas volumetric flow rate, and from 4 to 10 l/min for the liquid volumetric flow rate. Correlation of the experimental measurements of liquid film thickness and the major properties of the interfacial waves have been analyzed using non-dimensional numbers. An important part of the document focuses on the comparison of the experimental data and the fitting correlations against several of the most widely used expressions. Throughout this paper, in addition to present all the available correlations, the existing scattering found when comparing against other expressions have been also confirmed, underlining the existence of gaps of knowledge even today. Emphasize that the proposed correlations are the ones that better fit the data of all experimental series carried out under the present study for the analyzed variables, with almost all the experimental points covered by the +/- 10% error bands of the new correlations.

Peer Reviewed, Postprint (published version)

Air-water two-phase flow is present in natural and industrial processes of different nature as nuclear reactors. An accurate local prediction of the boiling flow could support safety and operation analyses of nuclear reactors. A new Eulerian-Lagrangian approach is investigated in this contribution. A new solver has been developed and implemented in the framework of the open source package OpenFOAM R and based on the PIMPLE algorithm coupled with the Lagrangian equation of motion has been implemented for computing incompressible bubbly flows. Each bubble is divided in equivolumetric volumes and tracked into the Eulerian mesh for an appropriate assignment of the effect of the bubble in the cell without resolving the interface. The coupling between phases is done considering in the momentum equation the interfacial forces and bubble induced contribution along the bubble path during an Eulerian time step. The bouncing of the bubbles between themselves and the wall is modeled with a dynamic soft sphere model. The computational results obtained for different flow conditions are validated with the recently released experimental data on upward pipe flow. The test section used is a 52 mm pipe of 5500 mm of length maintained under adiabatic conditions with air and water circulating fluids working with inlet velocity ranges of 0-2 m/s and 0-0.3 m/s for the continuous and dispersed phase respectively. Averaged results of radial distribution for void fraction, chord length, turbulence kinetic energy, dispersed and continuous velocity profiles show a good agreement among different flow conditions.

Despite its variable degree of application, intrusive instrumentation is the most accurate way to obtain local information in a two-phase flow system, especially local interfacial velocity and local interfacial area parameters. In this way, multi-needle probes, based on conductivity or optical principles, have been extensively used in the past few decades by many researchers in two-phase flow investigations. Moreover, the signal processing methods used to obtain the time-averaged two-phase flow parameters in this type of sensor have been thoroughly discussed and validated by many experiments. The objective of the present study is to develop a miniaturized multi-needle probe, based on capacitance measurements applicable to a wide range of non-conductive two-phase flows and, thus, to extend the applicability of multi-needle sensor whilst also maintaining a signal processing methodology provided in the literature for conductivity probes. Results from the experiments performed assess the applicability of the proposed sensor measurement principle and signal processing method for the bubbly flow regime. These results also provide an insight into the sensor application for more complex two-phase flow regimes.