Search

Polychlorotrifluoroethylene is used as a coating material over metallic seals in low-temperature applications to arrest fluid leakage from the impeller side in turbopumps. Typically, polychlorotrifluoroethylene coating is applied on V-type seals, with a thickness ranging from 80 to 130 μm by spraying an emulsion over the substrate followed by heat treatment. An attempt has been made to measure the polychlorotrifluoroethylene coating thickness over V-type seals using terahertz time-domain spectroscopy in reflection geometry, a noncontact, non-invasive NDT method. When the terahertz pulse from a transmitter photo-conductive antenna is incident on the V-type seal, it penetrates through the polychlorotrifluoroethylene coating. It gets reflected from the coating/base coat interface. Here, the reflected echoes from the air-to-polychlorotrifluoroethylene coating interface and polychlorotrifluoroethylene coating to the basecoat interface get overlapped in the time domain as the polychlorotrifluoroethylene coating layer is very thin. The sparse deconvolution technique separates the individual reflected signals and obtains the time delay signals from various interfaces. From the estimation of time delay values, the thickness of the coating has been computed using the refractive index value extracted using terahertz time-domain spectroscopy in transmission mode before the reflection measurements. The obtained thickness values are in close agreement with the coating thickness measured using optical microscopy. [ABSTRACT FROM AUTHOR]

Cork phenolic sheets with thermal protection paints are used as thermal protection system in launch vehicles. Detecting debonds and inclusions at the interface of cork phenolic-composite structure and thickness measurement of multi-layer TPS is highly challenging with single-side access. In this study, Terahertz imaging in reflection mode is used to detect the defects. The sample is raster scanned in X-Y directions, and the reflected signal is measured at each pixel and consolidated to obtain a Terahertz C-scan image of the entire area. The image obtained using Terahertz time-domain spectroscopy imaging system can distinguish between the healthy and debond/inclusion areas. Terahertz time-domain spectroscopy in transmission mode is carried out to obtain the refractive index and absorption coefficient of individual layers, which is a prerequisite for thickness measurement. The time-of-flight principle is used for thickness estimation of multi-layer thermal protection systems over carbon fibre reinforced plastic samples. The Sparse deconvolution technique is used to resolve the overlapping echoes to obtain the time delay for each layer. The thickness values obtained for cork phenolic sheet and red and white thermal protection paints over carbon fibre-reinforced plastic samples using Terahertz-time domain spectroscopy are in close agreement with the actual values. [ABSTRACT FROM AUTHOR]