Search

Quantifying interseismic deformation of fault networks which are predominantly deforming in a north-south direction is challenging, because GNSS networks are usually not dense enough to resolve deformation at the level of individual faults. The alternative, interferometric synthetic aperture radar (InSAR), provides high spatial resolution but is limited by a low sensitivity to N-S motion. We study the active normal fault network of Western Türkiye, which is undergoing rapid N-S extension, using InSAR. Since most faults in the study region are normal faults, we overcome the low N-S sensitivity by focusing on the vertical deformation component, which presents its own challenges. Sediment-filled grabens show rapid anthropogenically induced subsidence, whereas urban areas tend toward erroneous uplift signals. Additionally, the morphological relief results in topographic and atmospheric disturbances of the InSAR signal. Our solution to these challenges is a systematic analysis of the high-resolution vertical velocity field to deduce insights into regional deformation patterns, combined with detailed investigations of deformation along individual faults in the Western Anatolian Extensional Province. We show that tectonic deformation in the large graben systems is not restricted to the main faults. Smaller and seemingly less active faults are accommodating strain, favoring a continuum model of deformation over block models. We also observe a potential correlation between recent seismicity and active interseismic surface deformation. Observed deformation rates provide an estimate of current activity for many faults in the region. We discuss the potential and limitations of InSAR time series analysis for extensional regimes., (© 2024. The Author(s).)

Surface faulting earthquakes are known to cluster in time from historical and palaeoseismic studies, but the mechanism(s) responsible for clustering, such as fault interaction, strain-storage, and evolving dynamic topography, are poorly quantified, and hence not well understood. We present a quantified replication of observed earthquake clustering in central Italy. Six active normal faults are studied using 36 Cl cosmogenic dating, revealing out-of-phase periods of high or low surface slip-rate on neighboring structures that we interpret as earthquake clusters and anticlusters. Our calculations link stress transfer caused by slip averaged over clusters and anti-clusters on coupled fault/shear-zone structures to viscous flow laws. We show that (1) differential stress fluctuates during fault/shear-zone interactions, and (2) these fluctuations are of sufficient magnitude to produce changes in strain-rate on viscous shear zones that explain slip-rate changes on their overlying brittle faults. These results suggest that fault/shear-zone interactions are a plausible explanation for clustering, opening the path towards process-led seismic hazard assessments., (© 2022. The Author(s).)

Whether the stress-loading of faults to failure in earthquakes appears to be random or to an extent explainable, given constraints on fault/shear-zone interaction and the build-up and release of stress over many earthquake cycles, is a key question for seismic hazard assessment. Here we investigate earthquake recurrence for a system of 25 active normal faults arranged predominantly along strike from each other, allowing us to isolate the effects of stress-loading due to regional strain versus across- and along-strike fault interaction. We calculate stress changes over 6 centuries due to interseismic loading and 25 > Mw 5.5 earthquakes. Where only one fault exists across strike, stress-loading is dominated by the regional tectonics through slip on underlying shear zones and fault planes have spatially smooth stress with predominantly time-dependent stress increase. Conversely, where faults are stress-loaded by across-strike fault interactions, fault planes have more irregular stress patterns and interaction-influenced stress loading histories. Stress-loading to failure in earthquakes is not the same for all faults and is dependent on the geometry of the fault/shear-zone system.

Successive locations of individual large earthquakes (M w  > 5.5) over years to centuries can be difficult to explain with simple Coulomb stress transfer (CST) because it is common for seismicity to circumvent nearest-neighbour along-strike faults where coseismic CST is greatest. We demonstrate that Coulomb pre-stress (the cumulative CST from multiple earthquakes and interseismic loading on non-planar faults) may explain this, evidenced by study of a 667-year historical record of earthquakes in central Italy. Heterogeneity in Coulomb pre-stresses across the fault system is >±50 bars, whereas coseismic CST is <±2 bars, so the latter will rarely overwhelm the former, explaining why historical earthquakes rarely rupture nearest neighbor faults. However, earthquakes do tend to occur where the cumulative coseismic and interseismic CST is positive, although there are notable examples where earthquake propagate across negatively stressed portions of faults. Hence Coulomb pre-stress calculated for non-planar faults is an ignored yet vital factor for earthquake triggering.

The 28th December 1908 Messina earthquake (Mw 7.1), Italy, caused >80,000 deaths and transformed earthquake science by triggering the study of earthquake environmental effects worldwide, yet its source is still a matter of debate. To constrain the geometry and kinematics of the earthquake we use elastic half-space modelling on non-planar faults, constrained by the geology and geomorphology of the Messina Strait, to replicate levelling data from 1907-1909. The novelty of our approach is that we (a) recognise the similarity between the pattern of vertical motions and that of other normal faulting earthquakes, and (b) for the first time model the levelling data using the location and geometry of a well-known offshore capable fault. Our results indicate slip on the capable fault with a dip to the east of 70° and 5 m dip-slip at depth, with slip propagating to the surface on the sea bed. Our work emphasises that geological and geomorphological observations supporting maps of capable non-planar faults should not be ignored when attempting to identify the sources of major earthquakes.