Search

Adding porosity to battery electrodes is believed to be universally useful for adding space to accommodate volumetric expansion, electrolyte access to all active materials, helping to mitigate poor C-rate performance for thicker electrodes and for allowing infilling with other materials. Ordered porous electrode, such as inverse opals that have macroporosity, have been a model system: binder and conductive additive free, interconnected electrically, defined porosity and pore size with thickness, good electrolyte wettability and surprisingly good electrode performance in half cells and Li-battery cells at normal rates. We show that the intrinsic electronic conductivity is important, and at fast rates the intrinsic conductivity ultimately suppresses any charge storage in electrode materials. Using a model system of inverse opal V2O5in a flooded Li battery three-electrode cell, whose Li electrochemistry is very well understood, we show that beyond 10 C, electrodes can store almost no charge, but completely recover once reduced to < 1C. We show how the IO material is modified under lithiation using X-ray diffraction, Raman scattering and electron microscopy, and that little or no reaction occurs to the material at higher rates. We also use chronoamperometry to examine rate behaviour and link the limitations in high rate performance, and complete capacity suppression, to the intrinsic out-of-plane conductivity of the IO network. The data show that even idealized electrodes with nanoscale dimensions, functional porosity and full material interconnectivity, are fundamentally limited for high rate performance when they are less conductive even when fully soaked with electrolyte. While adding so-called functional size reduction, porosity etc. can be useful for some materials, these potential benefits are clearly not universally useful for high rate electrodes in Li-ion batteries., Comment: 30 pages, 10 figures

Conductive and paintable inks of 2D layered MoS2 with aspect ratio-dependent conductivity are demonstrated. Using ultrasonically assisted solvent-exfoliation of MoS2, high concentration 2D and few-layer suspensions become inks that provide coherent films when painted. Conductivity of paintable 2D MoS2 inks can be modulated by length and width, where the conductivity is linked to the painting direction. Reducing the painted film width, increases conductivity for similar length, and the films conductivity is aspect ratio-dependent. Inks of solvent-exfoliated 2D MoS2 can be painted without polymeric additives., Comment: 11 pages, 4 figures

Plasmonic photocatalysis has facilitated rapid progress in enhancing photocatalytic efficiency under visible light irradiation. Poor visible-light-responsive photocatalytic materials and low photocatalytic efficiency remain major challenges. Plasmonic metal-semiconductor heterostructures where both the metal and semiconductor are photosensitive are promising for light harvesting catalysis, as both components can absorb solar light. Efficiency of photon capture can be further improved by structuring the catalyst as a photonic crystal. Here we report the synthesis of photonic crystal plasmonic photocatalyst materials using Au nanoparticle-functionalized inverse opal (IO) photonic crystals. A catalyst prepared using a visible light responsive semiconductor (V2O5) displayed over an order of magnitude increase in reaction rate under green light excitation ($\lambda$=532 nm) compared to no illumination. The superior performance of Au-V2O5 IO was attributed to spectral overlap of the electronic band gap, localized surface plasmon resonance and incident light source. Comparing the photocatalytic performance of Au-V2O5 IO with a conventional Au-TiO2 IO catalyst, where the semiconductor band gap is in the UV, revealed that optimal photocatalytic activity is observed under different illumination conditions depending on the nature of the semiconductor. For the Au-TiO2 catalyst, despite coupling of the LSPR and excitation source at $\lambda$=532 nm, this was not as effective in enhancing photocatalytic activity compared to carrying out the reaction under broadband visible light, which is attributed to improved photon adsorption in the visible by the presence of a photonic band gap, and exploiting slow light in the photonic crystal to enhance photon absorption to create this synergistic type of photocatalyst., Comment: 19 pages, 8 figures, + Supporting information