Search

Compression therapy is widely used as the gold standard for management of chronic venous insufficiency and venous leg ulcers, and the amount of pressure applied during the compression therapy is crucial in supporting healing. A fibre optic pressure sensor using Fibre Bragg Gratings (FBGs) is developed in this paper to measure sub-bandage pressure whilst removing cross-sensitivity due to strain in the fibre and temperature. The interface pressure is measured by an FBG encapsulated in a polymer and housed in a textile to minimise discomfort for the patient. The repeatability of a manual fabrication process is investigated by fabricating and calibrating ten sensors. A customized calibration setup consisting of a programmable translation stage and a weighing scale gives sensitivities in the range 0.4-1.5 pm/mmHg (2.6-11.3 pm/kPa). An alternative calibration method using a rigid plastic cylinder and a blood pressure cuff is also demonstrated. Investigations are performed with the sensor under a compression bandage on a phantom leg to test the response of the sensor to changing pressures in static situations. Measurements are taken on a human subject to demonstrate changes in interface pressure under a compression bandage during motion to mimic a clinical application. These results are compared to the current gold standard medical sensor using a Bland-Altman analysis, with a median bias ranging from -4.6 to -20.4 mmHg, upper limit of agreement (LOA) from -13.5 to 2.7 mmHg and lower LOA from -32.4 to -7.7 mmHg. The sensor has the potential to be used as a training tool for nurses and can be left in situ to monitor bandage pressure during compression therapy.

In this study, the effects of bio-oxidative leaching on several synthetic uranium minerals - Uraninite [UO 2 ], Pitchblende [U 3 O 8 ], Coffinite [USiO 4 ], Brannerite [UTi 2 O 6 ] and Betafite [(U,Ca) 2 (Ti,Nb,Ta) 2 O 7 ]) compared to chemical leaching in the presence of pyrite was investigated. In all cases, bio-oxidative leaching was faster and increased overall %U extraction compared to chemical leaching. The results indicated that the bio-oxidative leachability of the uranium minerals was in the order: pitchblende≈ uraninite > coffinite>> brannerite > betafite. The leaching of pitchblende and uraninite was fast and complete; U extraction from coffinite was slower over 28 days' during the bioleaching. The use of thermophiles doubled the recovery of U from refractory brannerite. The results highlight the significant capability of bio-leaching in the recovery of U from brannerite; both mesophilic and thermophilic bacteria was found to enhance U recovery likely through enhanced breakdown of the titanate structure. Brannerite is often found in significant quantities within ore tailings due to its refractory nature, which can lead to subsequent release of U into the environment. Conversely, betafite is highly stable in the presence of mesophile and moderate thermophiles, which suggested that betafite materials can be a viable future host for long term storage for spent nuclear fuels., (Copyright © 2020 Elsevier B.V. All rights reserved.)

Textile-based strain sensors combine wearability with strain sensing functionality by using only the tensile and electrical properties of the threads they are made of. In this study, two conductive sleeves were manufactured for the elbow and three for the knee using a Santoni circular machine with different combinations of elastomeric and non-elastomeric yarns. Linearity, repeatability and sensitivity of the sleeves resistance with strain were compared during 5 repetitive trials, each of them consisting of 4 sequences of 50 joint flexion-extension cycles. All knitted conductive sleeves registered motion over 1000 cycles, proving their suitability for joint motion tracking. In addition, sleeves whose inner layer was made only with nylon exhibited the highest sensitivity and predictability of changes (i.e. a linear trend of the non-elastic deformation). On the other hand, sleeves whose inner layer was made with lycra and polyester or lycra and nylon showed a more balanced performance in terms of linearity, sensitivity and repeatability either for low or high number of cycles. Based on requirements, knitted conductive sleeves show a potential for application in rehabilitation both in healthcare and sports.

The dispersion of radionuclides in dust and inhalation dose rates to the public from the planned remediation of the Ranger uranium mine in the wet-dry tropics of Australia was modelled using RESRAD-OFFSITE. Dust inhalation dose rates were predicted to be highest on the remediated site and decrease with an approximate inverse square to inverse cubic dependence with distance from the site. The annual dose above natural background to a hypothetical individual permanently occupying the remediated site (representing the worst case scenario for radionuclide in dust exposure) was estimated to be 5.3 × 10 -3 mSv. The estimated doses from exposure to radionuclides in dust were two to three orders of magnitude lower than those from exposure to 222 Rn. A sensitivity analysis showed that source-related and receptor-related model parameters had direct proportional influences on dust inhalation dose rates. Four transport-related model parameters (atmospheric stability class, deposition velocity of particulates, precipitation and wind speed) were also influential and generally had an increasing influence with distance from the source. The results of this study may provide general guidance to similar sites elsewhere on the relative importance of dust versus gaseous 222 Rn transport pathways and the relative influence of dispersion modelling parameters on predicted exposures and doses., (Crown Copyright © 2019. Published by Elsevier Ltd. All rights reserved.)

The dispersion of 222 Rn from the planned remediation of the Ranger U mine in the wet-dry tropics of Northern Australia was modelled. Dry and wet season contour maps of 222 Rn dose normalised to 226 Ra activity concentration in the proposed waste rock substrate on the remediated landform were developed. Three example exposure scenarios were assessed based on an anticipated waste rock 226 Ra activity concentration of 800 Bq kg -1 . The estimated above-background annual dose from 222 Rn to hypothetical receptors at the Aboriginal community at Mudginberri (∼10 km NNW) was 0.005 mSv and at the township of Jabiru (∼7 km W) was 0.033 mSv. The estimated above-background annual dose for the hypothetical worst case scenario, representing a receptor 1 km WNW of the landform centroid during the dry season and at the centroid during the wet season, was 0.13 mSv. Variability analysis on the 20 y meteorological dataset used in the dispersion modelling showed that the dry and wet season 222 Rn dose predictions in any single year could be approximately double those of an average year, which suggests that estimates of average 222 Rn dose should potentially be doubled if the assessment aim is to demonstrate compliance with the public dose limit., (Crown Copyright © 2018. Published by Elsevier Ltd. All rights reserved.)

Since the first large scale commercial nuclear power plant became operational in 1958, the nuclear power industry has been faced with the growing problem of disposal of radionuclides produced from nuclear fission. The current global production of high level nuclear waste is approximately 10,000 metric tons p.a., consisting predominantly of uranium, plutonium, actinides and other minor radionuclides. Developing a safe and cost-effective method for long term storage and disposal of nuclear waste is a key issue of concern to the nuclear power industry. A promising approach to radionuclide disposal is incorporation of the nuclear waste into refractory oxide host minerals or mineral matrices. This technique offers lower leaching rates when compared to the commonly used glass-based vitrification approaches. The refractory pyrochlore supergroup of minerals are particularly attractive for this purpose as they can incorporate considerable amounts of the radionuclides: 93 Zr, 133 Ba, 135 Cs, Th, U, 238 Pu, and 244 Cm, while demonstrating very low leachability. This review examines the structural, compositional and chemical properties of radionuclide-containing pyrochlore supergroup minerals. Compiled leaching data for radionuclides hosted in pyrochlores demonstrates that these materials offer a high degree of aqueous durability making them strong candidates for radionuclide disposal, offering a viable storage alternative to traditional vitrification methods., (Crown Copyright © 2018. Published by Elsevier B.V. All rights reserved.)

Combining stainless steel with polyester fibres adds an attractive conductive behaviour to the yarn. Once knitted in such a manner, fabrics develop sensing properties that make the textiles, also known as e-textiles, suitable for smart/wearable applications. Structural deformations of the fibres (e.g. stretching) will cause changes in the conductivity of the fabric. This work investigates changes in the electrical properties exhibited by four knitted conductive textiles made of 20% stainless steel and 80% polyester fibres during cyclic loading. The samples were preconditioned first with 500 hundred cycles of unidirectional elongation and, after a rest interval, tested again for repeatability at the same conditions. In both cases the electrical behaviour stabilises after a few tens of cycles. In particular the repeatability test exhibited a considerably smaller settling time and a larger resistance due to the mechanical stabilisation and the loosening of the fabrics, respectively. It was found that the current provided to the fabrics affects the resistance measurements by decreasing the resistance value at which the samples become electrically stable. The reported findings present a valid method for the electrical characterisation of conductive textiles for use in further studies as a wearable technology.

Betafite of composition [(Ca,U)2(Ti,Nb,Ta)2O7] was prepared via a solid state synthesis route. The synthesis was shown to be sensitive to initial reactant ratios, the atmosphere used (oxidising, neutral, reducing) and time. The optimum conditions for the synthesis of betafite were found to be heating the reactants required at 1150°C for 48 h under an inert gas atmosphere. XRD characterisation revealed that the synthesised betafite contained minor impurities. EPMA analysis of a sectioned surface showed very small regions of Ca-free betafite on grain boundaries as well as minor rutile impurities. Some heterogeneity between the Nb:Ta ratio was observed by quantitative EPMA but was generally within the nomenclature requirements stated for betafite. SEM analysis revealed the synthesised betafite was comprised mostly of hexaoctohedral crystals of ∼ 3 μm in diameter. XPS analysis of the sample showed that the uranium in the synthesised betafite was predominately present in the U(5+) oxidation state. A minor amount of U(6+) was also detected which was possibly due to surface oxidation., (Copyright © 2014 Elsevier B.V. All rights reserved.)