Search

HgCdTe detector arrays with a cutoff wavelength of ~10 ${\mu}$m intended for the NEOCam space mission were subjected to proton beam irradiation at the University of California Davis Crocker Nuclear Laboratory. Three arrays were tested - one with 800 $\mu$m substrate intact, one with 30 $\mu$m substrate, and one completely substrate-removed. The CdZnTe substrate, on which the HgCdTe detector is grown, has been shown to produce luminescence in shorter wave HgCdTe arrays that causes elevated signal in non-hit pixels when subjected to proton irradiation. This testing was conducted to ascertain whether or not full substrate removal is necessary. At the dark level of the dewar, we detect no luminescence in non-hit pixels during proton testing for both the substrate-removed detector array and the array with 30 ${\mu}$m substrate. The detector array with full 800 ${\mu}$m substrate exhibited substantial photocurrent for a flux of 103 protons/cm$^2$-s at a beam energy of 18.1 MeV (~ 750 e$^-$/s) and 34.4 MeV ($\sim$ 65 e$^-$/s). For the integrated space-like ambient proton flux level measured by the Spitzer Space Telescope, the luminescence would be well below the NEOCam dark current requirement of <200 e$^-$/s, but the pattern of luminescence could be problematic, possibly complicating calibration., Comment: 9 figures, 32 pages

We present high spectral resolution (~3 km/s) observations of the nu_2 ro-vibrational band of H2O in the 6.086--6.135 micron range toward the massive protostar AFGL 2591 using the Echelon-Cross-Echelle Spectrograph (EXES) on the Stratospheric Observatory for Infrared Astronomy (SOFIA). Ten absorption features are detected in total, with seven caused by transitions in the nu_2 band of H2O, two by transitions in the first vibrationally excited nu_2 band of H2O, and one by a transition in the nu_2 band of H2{18}O. Among the detected transitions is the nu_2 1(1,1)--0(0,0) line which probes the lowest lying rotational level of para-H2O. The stronger transitions appear to be optically thick, but reach maximum absorption at a depth of about 25%, suggesting that the background source is only partially covered by the absorbing gas, or that the absorption arises within the 6 micron emitting photosphere. Assuming a covering fraction of 25%, the H2O column density and rotational temperature that best fit the observed absorption lines are N(H2O)=(1.3+-0.3)*10^{19} cm^{-2} and T=640+-80 K., Comment: 6 pages, 3 figures, 1 table, accepted for publication in ApJL

The physical structures of the outer atmospheres of red giants are not known. They are certainly complex and a range of recent observations are showing that we need to embrace to non-classical atmosphere models to interpret these regions. This region's properties is of importance, not the least, for the understanding of the mass-loss mechanism for these stars, which is not still understood. Here, we present observational constraints of the outer regions of red giants, based on mid-IR, high spectral resolution spectra. We also discuss possible non-LTE effects and highlight a new non-LTE code that will be used to analyse the spectra of these atmospheric layers. We conclude by mentioning our new SOFIA/EXES observations of red giants at 6 microns, where the vibration-rotation lines of water vapour can be detected and spectrally resolved for the first time., Comment: Talk presented at the "Why Galaxies Care About AGB Stars III" conference in Vienna, July 2014. It will be published in the Astronomical Society of the Pacific Conference Series

We examine cosmic ray rejection methodology on data collected from InSb and Si:As detectors. The application of an Up-the-Ramp sampling technique with cosmic ray identification and mitigation is the focus of this study. This technique is valuable for space-based observatories which are exposed to high-radiation environments. We validate the Up-the-Ramp approach on radiation-test data sets with InSb and Si:As detectors which were generated for SIRTF. The Up-the-Ramp sampling method studied in this paper is over 99.9% effective at removing cosmic rays and preserves the structure and photometric quality of the image to well within the measurement error., Comment: 30 pages, 13 figures. Accepted for publication in the PASP, 25 October 2000

In this paper we discuss the optimization of the detector design, material growth and processing that has culminated in realization of 15 micron cutoff 128x128 QWIP focal plane array camera, hand-held and palmsize 256x256 long wavelength QWIP cameras and 648x480 long-wavelength camera, holding forth great promise for myriad applications in 6-25 micron wavelength range in science, medicine, defense and industry.

NASA, commercial, medical, and defense applications such as Earth observation systems, astronomy, weather monitoring, thermal mapping, thermography, missile tracking, and night vision aids, etc. require high performance large format long wavelength infrared (LWIR) detector arrays in the range of 8-16 µm.

Quantum Well Infrared Photodetectors (QWIPs) offer greater flexibility than usual extrinsically doped semiconductor IR detectors because the wavelength of the peak response and cutoff can be continuously tailored by varying layer thickness (well width), barrier composition (barrier height), and carrier density (well doping density).

A broad-band infrared detector, sensitive over a 10 - 16 mu m spectral range, based on GaAs/A1xGa1-xAs quantum wells grown by molecular beam epitaxy, has been demonstrated.

High performance long-wavelength GaAs/AlxGa1-xAs quantum well infrared photodetectors for low background applications have been demonstrated.

In this paper we discuss the optimization of the detector design, material growth and processing that has culminated in realization of 15 micron cutoff 128 x 128 QWIP focal plane array camera, hand-held and palmize 256 x 256 long-wavelength QWIP cameras and 648 x 480 long-wavelength cameras, holding forth great promise for myriad applications in 6-25 micron wavelength range in science, medicine, defense and industry.

High performance long-wavelength GaAs/Al(x)Ga(1-x)As quantum well infrared photodetectors for low background applications have been demonstrated. This is the first theoretical analysis of quantum well infrared photodetectors for low background applications and the detectivity D* of 6 x 10(exp 13) cm.square root of Hz/W has been achieved at T = 40 K with 2 x 10(exp 9) photons/cm2/sec background. In addition, this paper describes the demonstration of mid-wavelength/long-wavelength dualband quantum well infrared photodetectors and long-wavelength/very long-wavelength dualband quantum well infrared photodetectors in 4-26 micrometers wavelength region.

The design of a long-slit echelle spectrograph covering the 16 - 210 micron range for use on the Stratospheric Observatory for Infrared Astronomy (SOFIA) is under study at NASA-Ames. This wavelength range is selected for its content of important astrophysical spectral lines accessible from an airborne platform, and availability of suitable detectors. Two dimensional arrays will be used to simultaneously provide spectral coverage in the dispersion direction and imaging in the cross-dispersion direction. Major goals are: (1) to reach sensitivities limited primarily by the background from the residual atmosphere and the telescope; (2) to provide imaging not far from the diffraction limit of the 2.5 meter (effective) aperture of the telescope; and (3) to obtain diffraction-limited spectral resolution from the large echelle grating, which means that the resolving power increases with decreasing wavelength. To meet these requirements, three detector types are forseen: a commercially available monolithic Si:Sb IBC array to cover the wavelength range from 16 to 40 microns, a Ge:Sb photoconductor array to cover the range from 40 to 125 microns, and a stressed Ge:Ga photoconductor array covering the range from 125 to 210 microns. The paper discusses details of the studies and plans for the field optics, detectors, and readouts.

256 x 256-element IBC Si:As arrays have been evaluated for applications in IR astronomy from space-borne platforms. Basic figures of merit were measured at IR flux levels simulating those expected in space-based astronomical observations. Results include dark current less than 20 e(-)/s, G-eta as high as 3.8, eta/beta of 20%, and read noise below 100 rms(e(-)).

A new infrared camera (AIR Camera) has been developed at NASA - Ames Research Center for observations from ground-based telescopes. The heart of the camera is a Hughes 58 x 62 pixel Arsenic-doped Silicon detector array that has the spectral sensitivity range to allow observations in both the 10 and 20 micron atmospheric windows.

A novel cryogenic design of a source follower per detector (SFD) direct readout multiplexer is demonstrated. This design has proven to be a good prototype for the development of new low-noise large-area cryogenic multiplexers. In the absence of clocking noise, the readout demonstrates as low as about 30 electrons of rms read noise. There is still an excess noise component feeding through when the array is clocked, which manifests itself only at the lower temperatures. The shape of this component is dependent on a number of the bias voltages, and especially on the temperature of the chip. Analysis of the noise spectral density of the unit cell under various bias conditions shows that there is an excess spectral noise component at the lower temperatures.