Search

Different stainless steel slags have been successfully employed in previous experiments, for the treatment of industrial acidic wastewaters. Although, before this technology can be implemented on an industrial scale, upscaled pilot experiments need to be performed. In this study, the parameters of the upscale trials, such as the volume and mixing speeds, are firstly tested by dispersing a NaCl tracer in a water bath. Mixing time trials are used to maintain constant mixing conditions when the volumes are increased to 70, 80 and 90 L, compared to the 1 L laboratory trials. Subsequently, the parameters obtained are used in pH buffering trials, where stainless steel slags are used as reactants, replicating the methodology of previous studies. Compared to laboratory trials, the study found only a minor loss of efficiency. Specifically, in previous studies, 39 g/L of slag was needed to buffer the pH of the acidic wastewaters. To reach similar pH values within the same time span, upscaled trials found a ratio of 43 g/L and 44 g/L when 70 and 90 L are used, respectively. Therefore, when the kinetic conditions are controlled, the technology appears to be scalable to higher volumes. This is an important finding that hopefully promotes further investments in this technology. QC 20220322

Recycling of steelmaking slags has well-established applications, such as their use in cement, asphalt, or fertilizer industries. Although in some cases, such as the electric arc furnace (EAF) high-alloyed stainless-steel production, the slag&rsquo, s high metal content prevents its use in such applications. This forces companies to accumulate it as waste. Using concepts such dematerialization, waste management, industrial symbiosis, and circular economy, the article drafts a conceptual framework on the best route to solving the landfilling issue, aiming at a zero-waste process re-design. An experimental part follows, with an investigation of the use of landfill slag as a substitute of limestone for the neutralization of acidic wastewater, produced by the rinsing of steel after the pickling process. Neutralization of acidic wastewater with both lime and slag samples was performed with two different methods. Two out of four slag samples tested proved their possible use, reaching desired pH values compared to lime neutralizations. Moreover, the clean waters resulting from the neutralizations with the use of both lime and slag were tested. In terms of hazardous element concentrations, neutralization with slag yielded similar results to lime. The results of these trials show that slag is a potential substitute of lime for the neutralization of acidic wastewater.