Search

Posidonia oceanica significantly contributes to the health of oceans and coastal areas; however, its progressive decline is becoming an increasing source of concern. The present preliminary study aims to assess the chemical parameters that describe the state of preservation of the aforementioned plant meadows located in the Tremiti Islands archipelago. To better understand the plants’ response to external factors, the emission of biogenic volatile organic compounds (BVOCs) was investigated using Posidonia oceanica as a biological indicator. Subsequently, the heavy metal concentrations (Ag, Al, As, Ba, Be, Cd, Co, Cr, Cu, Fe, Mn, Mo, Ni, Pb, Sb, Se, Sn, Ti, Tl, V, Zn) in sediments, leaves, and seawater were determined and pollution indicators were calculated to assess the deviation from the natural background levels of sediments. The dimethyl sulfoniopropionate (DMSP) to dimethyl sulfoxide (DMSO) ratio was calculated to evaluate the oxidative stress levels in the meadows because the DMSP naturally present in Posidonia oceanica is oxidized to DMSO and decreases the ratio of DMSP/DMSO. BVOC analysis revealed dimethyl sulphide (DMS) as the most abundant molecule. Morphological features led to variations in metal concentrations across sampling sites, with sheltered bays displaying a higher metal content. Degradation is indicated by a greater DMSO content in the outer leaves. In accordance with the metal content, the bioindicator ratio confirms greater degradation on the south side, which aligns with increased oxidative stress.

Many staple foods originate from durum wheat and its milling products; because of this, it is very important to know their characteristics. This study investigates elemental contents in these products and if differences exist because of organic farming. The concentrations of 28 elements in the whole seed and in milling products, that is, bran, semolina and flour, of durum wheat, were determined through ICP-OES. The wheats were grown under conventional or organic agronomic practices to verify the possibility of discriminating, using the elemental content, between products coming from one or the other practice. The elements were more abundant in the outer layer of the seed, the bran, but most of them were also present in the others. Traces of Sb were present only in 3% of the samples, while traces of Tl were detected in approximately half of the seed and bran samples but not in other samples. The absence of an element was more characteristic of specific products, e.g., most semolina and flour lacked Co, while other elements showed small differences between products from organic and conventional cultivation or between different milling products, which was the case, for example, for traces of Ag, B, and V. The concentrations of these elements were coupled with multivariate discriminant analysis, specifically PLS-DA, to identify the cultivation provenance of the milled products. A few elements, although different for each product, are sufficient to attain precision and accuracy of classification close to 1; small differences exist for different products. The worst is flour, where the predicted precision and accuracy are 0.92, although using only three elements: B, K, and Se. Semolina attains perfect prediction when also adding to the three previous elements, Ag, Cd, and Cu. Further elements are necessary for bran, while Fe and Mg replace K and Ag to classify seeds. In conclusion, five elements, B, Cd, Cu, K, and Se, are the most important in distinguishing between organic and conventional agriculture; these elements also permit some differentiation among products. The method could help in fraud prevention.

A measurement campaign was conducted on San Domino Island, part of the Tremiti Islands archipelago, located in Foggia, Italy. The area is almost entirely covered by vegetation, dominated by the following main species: Juniperus turbinata, Helichrysum italicum, Myrtus communis, Rosmarinus officinalis, Pistacia lentiscus and Pinus halepensis.This study focused on the BVOCs emitted by plants and the ground, employing a simple, economical, and efficient sampling and analysis method. The main known BVOC species emitted by Mediterranean plant species as α-pinene, β-pinene, camphene and limonene were detected. The measurements highlighted a daily complementarity between plant and soil emissions. The daily variations in BVOCs emitted by both plants and the soil are differ, ensuring an almost constant concentration throughout the day. At the same time, the composition of sea spray aerosol (SSA) was also measured.The measurement sites were selected based on botanical characterization to account for the predominant species on San Domino Island, and the sampling was conducted at human height to accurately identify the species for potential use.The combination of beneficial effects of the substances emitted by plant species and soil, along with the simultaneous presence of SSA, are factors that could enhance the effectiveness of forest therapy in a previously unexplored location.

This article highlights recent experimental advances in the use of inorganic substances in the encapsulation of pollutants and, in particular, discusses the potential applicability and constraints of the geopolymerization process for the treatment of wastewater containing chromium. A great percentage of waste containing chromium salts is produced by the leather industry during the tannery process. Such industrial waste is in the form of liquor containing almost 40% of the initial chromium combined with many other pollutants. The stabilization/solidification (S/S) treatment of this type of waste must be combined with chromium encapsulation in an economic, environmentally friendly and efficient process to be industrially feasible. Here we present a novel process in which the wastewater is used as a component of the formulation together with a clay by-product and with the addition of NaOH pellets with the goal of a no-water plus no-waste technology approach. The final solidified “ceramic-like” material successfully immobilized the heavy metal cations as well as anions and macromolecules of surfactants, avoiding environmental damages to soil and groundwater. The article is completed by mentioning other S/S processes where wastewater has been treated and the resulting sludge encapsulated. The future of the S/S technologies in the tannery industry should progress in the direction of significantly reducing the amount of wastewater directed to the treatment plants, with associated reductions in transport and their CO2 emissions. This article intends to be a contribution in the direction of preventing waste, aligning circular economy and waste management objectives.