Search

The meniscus has inadequate intrinsic regenerative capacity and its damage can lead to degeneration of articular cartilage. Meniscus tissue engineering aims to restore an injured meniscus followed by returning its normal function through bioengineered scaffolds. In the present study, the structural and biological properties of 3D-printed polyurethane (PU) scaffolds dip-coated with gellan gum (GG), hyaluronic acid (HA), and glucosamine (GA) were investigated. The optimum concentration of GG was 3% (w/v) with maintaining porosity at 88.1%. The surface coating of GG-HA-GA onto the PU scaffolds increased the compression modulus from 30.30 kPa to 59.10 kPa, the water uptake ratio from 27.33% to 60.80%, degradation rate from 5.18% to 8.84%, whereas the contact angle was reduced from 104.8° to 59.3°. MTT assay, acridine orange/ethidium bromide (AO/EB) fluorescent staining, and SEM were adopted to assess the behavior of the seeded chondrocytes on scaffolds, and it was found that the ternary surface coating stimulated the cell proliferation, viability, and adhesion. Moreover, the coated scaffolds showed higher expression levels of collagen II and aggrecan genes at day 7 compared to the control groups. Therefore, the fabricated PU-3% (w/v) GG-HA-GA scaffold can be considered as a promising scaffold for meniscus tissue engineering.

Developing new barrier membranes with improved biomechanical characteristics has acquired much interest owing to their crucial role in the field of periodontal tissue regeneration. In this regard, we enriched the electrospun polycaprolactone (PCL)/gelatin (Gel) membranes by adding bioglass (BG) or Cu-doped bioglass (CuBG) and examined their cellular adhesion and proliferation potential in the presence of alveolar bone marrow-derived mesenchymal stem cells (aBMSCs). The membranes were fabricated and characterized using mechanical strength, SEM, FTIR, EDX, and ICP assay. Besides, aBMSCs were isolated, characterized, and seeded with a density of 35,000 cells in each experimental group. Next, the cellular morphology, cell adhesion capacity, proliferation rate, and membrane antibacterial activity were assessed. The results displayed a significant improvement in the wettability, pore size, and Young’s modulus of the PCL membrane following the incorporation of gelatin and CuBG particles. Moreover, all scaffolds exhibited reasonable biocompatibility and bioactivity in physiological conditions. Although the PCL/Gel/CuBG membrane revealed the lowest primary cell attachment, cells were grown properly and reached the confluent state after seven days. In conclusion, we found a reasonable level of attachment and proliferation of aBMSCs on all modified membranes. Meanwhile, a trace amount of Cu provided superiority for PCL/Gel/CuBG in periodontal tissue regeneration.

The unique physicochemical and functional characteristics of starch-based biomaterials and wound dressings have been proposed for several biomedical applications. Film dressings of cornstarch/hyaluronic acid/ ethanolic extract of propolis (CS/HA/EEP) were prepared by solvent-casting and characterized by attenuated total reflectance/Fourier transform infrared spectroscopy, scanning electron microscopy, gas chromatography/mass spectrometry, light transmission, opacity measurements, EEP release, equilibrium swelling, and in vitro and in vivo evaluations. The CS/HA/0.5%EEP film dressing exhibited higher antibacterial activity against Staphylococcus aureus (2.08 ± 0.14 mm), Escherichia coli (2.64 ± 0.18 mm), and Staphylococcus epidermidis (1.02 ± 0.15 mm) in comparison with the CS, CS/HA, and CS/HA/0.25%EEP films. Also, it showed no cytotoxicity for the L929 fibroblast cells. This wound dressing could effectively accelerate the wound healing process at Wistar rats' skin excisions. These results indicate that enrichment of cornstarch wound dressings with HA and EEP can significantly enhance their potential efficacy as wound dressing material.

One-layer wound dressings cannot meet all the clinical needs due to their individual characteristics and shortcomings. Therefore, bilayer wound dressings which are composed of two layers with different properties have gained lots of attention. In the present study, polycaprolactone/gelatin (PCL/Gel) scaffold was electrospun on a dense membrane composed of polyurethane and ethanolic extract of propolis (PU/EEP). The PU/EEP membrane was used as the top layer to protect the wound area from external contamination and dehydration, while the PCL/Gel scaffold was used as the sublayer to facilitate cells’ adhesion and proliferation. The bilayer wound dressing was investigated regarding its microstructure, mechanical properties, surface wettability, anti-bacterial activity, biodegradability, biocompatibility, and its efficacy in the animal wound model and histopathological analyzes. Scanning electron micrographs exhibited uniform morphology and bead-free structure of the PCL/Gel scaffold with average fibers’ diameter of 237.3 ± 65.1 nm. Significant anti-bacterial activity was observed against Staphylococcal aureus (5.4 ± 0.3 mm), Escherichia coli (1.9 ± 0.4 mm) and Staphylococcus epidermidis (1.0 ± 0.2 mm) according to inhibition zone test. The bilayer wound dressing exhibited high hydrophilicity (51.1 ± 4.9°), biodegradability, and biocompatibility. The bilayer wound dressing could significantly accelerate the wound closure and collagen deposition in the Wistar rats’ skin wound model. Taking together, the PU/EEP-PCL/Gel bilayer wound dressing can be a potential candidate for biomedical applications due to remarkable mechanical properties, biocompatibility, antibacterial features, and wound healing activities.

Modern dressings increase the rate of wound healing rather than just covering them. Dressing can protect the injured skin and keep it appropriately moist to speed up the healing process. In this study, the ethanolic extract of propolis loaded with corn starch was successfully prepared using solvent casting. Characterizations of the samples performed in respect to their mechanical properties were examined by scanning electron microscopy, contact angle, and attenuated total reflectance—fourier transform infrared spectroscopy, as well as antimicrobial capacities. The MTT assay using fibroblast cells showed the cell viability of corn starch in the ethanolic extract of propolis wound dressing. The results showed that by increasing the amount of ethanolic propolis extract from 0.25 to 1%, the tensile strength and the Young’s modulus of the samples were decreased, the elongation at the break increased about 15% as compared to the control films, and the contact angle properties were detected by a slightly hydrophobic character of the films in the antibacterial activity against Escherichia coli and Staphylococcus aureus even at low ethanolic extract of propolis concentrations (1%), mainly due to its phenolic compounds. Therefore, ethanolic extract of propolis loaded with corn starch film will be a potential candidate for wound dressing and skin tissue engineering.

A facile approach for the formation of microporous (chitosan) hydrogel scaffolds based on self-crosslinking is presented. It is simple and does not require any sacrificial porogen, toxic initiator/catalyst, harmful irradiation, or sophisticated equipment. The pore size, porosity, and mechanical properties of our hydrogels can be readily tuned.

A biocompatible and antibacterial scaffold with efficient wound healing activity can be an appropriate option for wound dressing application. In this study, polyurethane-hyaluronic acid (PU-HA) nanofibrous wound dressing was fabricated and then enriched with three different concentrations of ethanolic extract of propolis (EEP). The obtained samples were characterized by attenuated total reflectance/Fourier transform infrared spectroscopy, thermal gravimetric analysis, scanning electron microscopy, mechanical investigations, antibacterial tests, water uptake exam, and in vitro and in vivo evaluations. The PU-HA/1% EEP and PU-HA/2% EEP samples exhibited higher antibacterial activity against Staphylococcus aureus (2.36 ± 0.33 and 5.63 ± 0.87 mm), Escherichia coli (1.94 ± 0.12 and 3.18 ± 0.63 mm) in comparison with other samples. However, the PU-HA/1% EEP sample exhibited significantly higher biocompatibility for L929 fibroblast cells in comparison with PU-HA/2% EEP. Also, the PU-HA/1% EEP sample could significantly accelerate the wound healing progression and wound closure at the animal model. At the histopathological analyses, improved dermis development and collagen deposition at the healed wound area of the PU-HA/1% EEP sample in comparison with other groups was observed. These results indicate that 1 wt% EEP enriched PU-HA nanofibrous scaffold can be a promising candidate with considerable biocompatibility, wound healing, and antibacterial activities for further biomedical applications.

Cartilage is under extensive investigation in tissue engineering research. Herein, we evaluated scaffolds prepared by composites of polyvinyl alcohol (PVA) and collagen incorporated with zeolite and silica nanoparticles (nZe and nSi). The scaffolds were prepared by the electrospinning method. The mean diameters of nanofibers were 0.61 ± 0.34 µm for PVA/collagen versuss 0.62 ± 0.22 µm and 0.66 ± 0.25 µm for the PVA/collagen/nZe and the PVA/collagen/nSi scaffolds, respectively. DAPI staining results revealed that cell proliferations on the PVA/collagen/nZe and PVA/collagen/nSi were strikingly higher than on the pure PVA/collagen. The results encouraged further investigation of PVA/collagen/nSi scaffolds as biomimetic platform for chondrocyte cells in tissue engineering.

Background: Wound healing is a complex biological process. Some injuries lead to chronic nonhealing ulcers, and healing process is a challenge to both the patient and the medical team. We still look forward an appropriate wound dressing. Materials and Methods: In this study, starch-based nanocomposite hydrogel scaffolds reinforced by zeolite nanoparticles (nZ) were prepared for wound dressing. In addition, a herbal drug (chamomile extract) was added into the matrix to accelerate healing process. To estimate the cytocompatibility of hydrogel dressings, fibroblast mouse cells (L929) were cultured on scaffolds. Then, 3-(4, 5-dimethylthiazol-2-yl)-2, 5-diphenyltetrazolium-bromide assay test and interaction of cells and scaffolds were evaluated. For evaluating healing process, 48 male rats were randomly divided into four groups of four animals each (16 rats at each step). The ulcers of the first group were treated with the same size of pure hydrogels. The second group received a bandage with the same size of hydrogel/extract/4 wt% nZ (hydrogel NZE). The third group was treated with chamomile extract, and the fourth group was considered as control without taking any medicament. Finally, the dressings were applied on the chronic refractory ulcers of five patients. Results: After successful surface morphology and cytocompatibility tests, the animal study was carried out. There was a significant difference between starch/extract/4 wt% nZ and other groups on wound size decrement after day 7 (P < 0.05). At the clinical pilot study step, the refractory ulcers of all five patients were healed without any hypersensitivity reaction. Conclusion: Starch-based hydrogel/zeolite dressings may be safe and effective for chronic refractory ulcers.