Search

Abstract Background The objective of this study was to investigate the impact of sensitivity encoding on the quantitative assessment of cardiac motion in black blood cine tissue phase mapping (TPM) sequences. Up to now whole volume coverage of the heart is still limited by the long acquisition times. Therefore, a significant increase in imaging speed without deterioration of quantitative motion information is indispensable. Methods 20 volunteers were enrolled in this study. Each volunteer underwent myocardial short-axis TPM scans with different SENSE acceleration factors. The influence of SENSE acceleration on the measured motion curves was investigated. Results It is demonstrated that all TPM sequences with SENSE acceleration have only minimum influence on the motion curves. Even with a SENSE factor of four, the decrease in the amplitude of the motion curve was less than 3%. No significant difference was observed for the global correlation coefficient and deviation between the motion curves obtained by the reproducibility and the SENSE accelerated measurements. Conclusions It is feasible to accelerate myocardial TPM measurements with SENSE factors up to 4 without losing substantial information of the motion pattern.

Abstract Background The assessment of myocardial motion with tissue phase mapping (TPM) provides high spatiotemporal resolution and quantitative motion information in three directions. Today, whole volume coverage of the heart by TPM encoding at high spatial and temporal resolution is limited by long data acquisition times. Therefore, a significant increase in imaging speed without deterioration of the quantitative motion information is required. For this purpose, the k-t BLAST acceleration technique was combined with TPM black-blood functional imaging of the heart. Different k-t factors were evaluated with respect to their impact on the quantitative assessment of cardiac motion. Results It is demonstrated that a k-t BLAST factor of two can be used with a marginal, but statistically significant deterioration of the quantitative motion data. Further increasing the k-t acceleration causes substantial alteration of the peak velocities and the motion pattern, but the temporal behavior of the contraction is well maintained up to an acceleration factor of six. Conclusions The application of k-t BLAST for the acceleration of TPM appears feasible. A reduction of the acquisition time of almost 45% could be achieved without substantial loss of quantitative motion information.

With the introduction of cone beam (CB) scanners, cardiac volumetric computed tomography (CT) imaging has the potential to become a noninvasive imaging tool in clinical routine for the diagnosis of various heart diseases. Heart rate adaptive reconstruction schemes enable the reconstruction of high-resolution volumetric data sets of the heart. Artifacts, caused by strong heart rate variations, high heart rates and obesity, decrease the image quality and the diagnostic value of the images. The image quality suffers from streak artifacts if suboptimal scan and reconstruction parameters are chosen, demanding improved gating techniques. In this paper, an artifact analysis is carried out which addresses the artifacts due to the gating when using a three-dimensional CB cardiac reconstruction technique. An automatic and patient specific cardiac weighting technique is presented in order to improve the image quality. Based on the properties of the reconstruction algorithm, several assessment techniques are introduced which enable the quantitative determination of the cycle-to-cycle transition smoothness and phase homogeneity of the image reconstruction. Projection data of four patients were acquired using a 16-slice CBCT system in low pitch helical mode with parallel electrocardiogram recording. For each patient, image results are presented and discussed in combination with the assessment criteria. Index Terms--Artifact analysis, cardiac cone beam computed tomography, improvement of 3-D cardiac reconstruction.