Search

Improving the performance of solar modules requires the implementation of both spectral and directional irradiance optimization. The performance of bifacial four-terminal tandem minimodules with a 100 cm2 area is reported, both indoor and outdoor measurements. We demonstrate a 24.5 mW/cm2 (bifacial irradiance 200 W/m2) bifacial tandem power density, measured according to a tandem adapted IEC60904-1-2 protocol, which constitutes a 3 mW/cm2 gain with respect to monofacial use. In addition, we show that in outdoor measurements bifacial four terminal tandems outperform identical monofacial four terminal tandems by 26% on average, depending on incident angle, injection level and temperature, in a 10% albedo environment. The average gain is higher for outdoor performance than for indoor performance, due to variations in relative rear irradiance.

Improving the performance of solar modules requires the implementation of both spectral and directional irradiance optimization. The performance of bifacial four-terminal tandem minimodules with a 100 cm2 area is reported, both indoor and outdoor measurements. We demonstrate a 24.5 mW/cm2 (bifacial irradiance 200 W/m2) bifacial tandem power density, measured according to a tandem adapted IEC60904-1-2 protocol, which constitutes a 3 mW/cm2 gain with respect to monofacial use. In addition, we show that in outdoor measurements bifacial four terminal tandems outperform identical monofacial four terminal tandems by 26% on average, depending on incident angle, injection level and temperature, in a 10% albedo environment. The average gain is higher for outdoor performance than for indoor performance, due to variations in relative rear irradiance. [ABSTRACT FROM AUTHOR]

This paper presents the results from an extensive interlaboratory comparison of angular‐dependent measurements on encapsulated photovoltaic (PV) cells. Twelve international laboratories measure the incident angle modifier of two unique PV devices. The absolute measurement agreement is ±2.0% to the weighted mean for angles of incidence (AOI) ≤ 65°, but from 70° to 85°, the range of measurement deviations increases rapidly from 2.5% to 23%. The proficiency of the measurements is analysed using the expanded uncertainties published by seven of the laboratories, and it is found that most of the angular‐dependent measurements are reproducible for AOI ≤ 80°. However, at 85°, one laboratory's measurement do not agree to the weighted mean within the stated uncertainty, and measurement uncertainty as high as 16% is needed for the laboratories without uncertainty to be comparable. The poor agreement obtained at 85° indicates that the PV community should place minimal reliance on angular‐dependent measurements made at this extreme angle until improvements can be demonstrated. The cloud‐based Daidalos ray tracing model is used to simulate the angular‐dependent losses of the mono‐Si device, and it is found that the simulation agrees to the median measurement within 0.6% for AOI ≤ 70° and within 1.4% for AOI ≤ 80°. Finally, the impact that the angular‐dependent measurement deviations have on climate specific energy rating (CSER) is evaluated for the six climates described in the IEC 61853‐4 standard. When one outlier measurement is excluded, the angular‐dependent measurements reported in this work cause a 1.0%–1.8% range in CSER and a 1.0%–1.5% range in annual energy yield, depending on the climate. [ABSTRACT FROM AUTHOR]