Search

We report Global Positioning System (GPS) measurements of postseismic deformation following the 2015 Mw7.8 Gorkha (Nepal) earthquake, including previously unpublished data from 13 continuous GPS stations installed in southern Tibet shortly after the earthquake. We use variational Bayesian Independent Component Analysis (vbICA) to extract the signal of postseismic deformation from the GPS time series, revealing a broad displacement field extending >150 km northward from the rupture. Kinematic inversions and dynamic forward models show that these displacements could have been produced solely by afterslip on the Main Himalayan Thrust (MHT) but would require a broad distribution of afterslip extending similarly far north. This would require the constitutive parameter (a − b)σ to decrease northward on the MHT to ≤0.05 MPa (an extreme sensitivity of creep rate to stress change) and seems unlikely in light of the low interseismic coupling and high midcrustal temperatures beneath southern Tibet. We conclude that the northward reach of postseismic deformation more likely results from distributed viscoelastic relaxation, possibly in a midcrustal shear zone extending northward from the seismogenic MHT. Assuming a shear zone 5–20 km thick, we estimate an effective shear‐zone viscosity of ~3·1016–3·1017 Pa·s over the first 1.12 postseismic years. Near‐field deformation can be more plausibly explained by afterslip itself and implies (a − b)σ ~ 0.5–1 MPa, consistent with other afterslip studies. This near‐field afterslip by itself would have re‐increased the Coulomb stress by ≥0.05 MPa over >30% of the Gorkha rupture zone in the first postseismic year, and deformation further north would have compounded this reloading. Key Points: New GPS data show that postseismic deformation of the 2015 Mw7.8 Gorkha (Nepal) earthquake extended far northward into southern TibetKinematic and dynamic models suggest that the northward reach of deformation likely reflects the influence of viscoelastic relaxationAfterslip likely dominated postseismic deformation in the near field, transferring stress back to the (relocked) Gorkha rupture zone [ABSTRACT FROM AUTHOR]

Knowledge on the interaction of active structures is essential to understand mechanics of continental deformation and estimate the earthquake potential in complex tectonic settings. Here we use Sentinel-1A radar imagery to investigate coseismic deformation associated with the 2016 Menyuan (Qinghai) earthquake, which occurred in the vicinity of the left-lateral Haiyuan fault. The ascending and descending interferograms indicate thrust-dominated slip, with the maximum line-of-sight displacements of 58 and 68 mm, respectively. The InSAR observations fit well with the uniform-slip dislocation models except for a larger slip-to-width ratio than that predicted by the empirical scaling law. We suggest that geometric complexities near the Leng Long Ling restraining bend confine rupture propagation, resulting in high slip occurred within a small area and much higher stress drop than global estimates. Although InSAR observations cannot distinguish the primary plane, we prefer the west-dipping solution considering aftershocks distribution and the general tectonic context. Both InSAR modelling and aftershock locations indicate that the rupture plane linked to the Haiyuan fault at 10 km depth, a typical seismogenic depth in Tibet. We suggest that the earthquake more likely occurred on a secondary branch at a restraining bend of the Haiyuan fault, even though we cannot completely rule out the possibility of it being on a splay of the North Qilian Shan thrusts. [ABSTRACT FROM AUTHOR]

Abstract: The M s 8.0, Wenchuan earthquake, which devastated the mountainous western rim of the Sichuan basin in central China, produced a surface rupture over 200 km-long with oblique thrust/dextral slip and maximum scarp heights of ~10 m. It thus ranks as one of the world''s largest continental mega-thrust events in the last 150 yrs. Field investigation shows clear surface breaks along two of the main branches of the NE-trending Longmen Shan thrust fault system. The principal rupture, on the NW-dipping Beichuan fault, displays nearly equal amounts of thrust and right-lateral slip. Basin-ward of this rupture, another continuous surface break is observed for over 70 km on the parallel, more shallowly NW-dipping Pengguan fault. Slip on this latter fault was pure thrusting, with a maximum scarp height of ~3.5 m. This is one of the very few reported instances of crustal-scale co-seismic slip partitioning on parallel thrusts. This out-of-sequence event, with distributed surface breaks on crustal mega-thrusts, highlights regional, ~EW-directed, present day crustal shortening oblique to the Longmen Shan margin of Tibet. The long rupture and large offsets with strong horizontal shortening that characterize the Wenchuan earthquake herald a re-evaluation of tectonic models anticipating little or no active shortening of the upper crust along this edge of the plateau, and require a re-assessment of seismic hazard along potentially under-rated active faults across the densely populated western Sichuan basin and mountains. [Copyright &y& Elsevier]

Restraining double-bends along strike-slip faults inhibit or permit throughgoing ruptures depending on bend angle, length, and prior rupture history. Modeling predicts that for mature strike-slip faults in a regional stress regime characterized by simple shear, a restraining bend of >18° and >4 km length impedes propagating rupture. Indeed, natural evidence shows that the most recent rupture(s) of the Xorkoli section (90°–93°E) of the eastern Altyn Tagh fault (ATF) ended at large restraining bends. However, when multiple seismic cycles are considered in numerical dynamic rupture modeling, heterogeneous residual stresses enable some ruptures to propagate further, modulating whether the bends persistently serve as barriers. These models remain to be tested using observations of the cumulative effects of multiple earthquake ruptures. Here we investigate whether a large restraining double-bend on the ATF serves consistently as a barrier to rupture by measuring long-term slip rates around the terminus of its most recent surface rupture at the Aksay bend. Our results show a W—E decline in slip as the SATF enters the bend, as would be predicted from repeated rupture terminations there. Prior work demonstrated no Holocene slip on the central, most misoriented portion of the bend, while 19–79 m offsets suggest that multiple ruptures have occurred on the west side of the bend during the Holocene. Thus we conclude the gradient in the SATF's slip rate results from the repeated termination of earthquake ruptures there. However, a finite slip rate east of the bend represents the transmission of some slip, suggesting that a small fraction of ruptures may fully traverse or jump the double-bend. This agreement between natural observations of slip accumulation and multi-cycle models of fault rupture enables us to translate observed slip rates into insight about the dynamic rupture process of individual earthquakes as they encounter geometric complexities along faults. [ABSTRACT FROM AUTHOR]

Fluvial erosion of small mountain belts is widely represented as a wave of upstream migration of knickpoints, starting from a stationary boundary of a high topography created by increased rock uplift rates. However, fluvial erosion remains poorly constrained when orogens expand in width with their boundaries continuously advancing towards the foreland. Here we propose a simple analytical solution for a laterally expanding orogen dominated by fluvial erosion, and apply it to the propagation of Eastern Tibet where the plateau margin is characterized by widespread low-relief surfaces incised by steep river valleys. Our analytical solution is based on the assumption that the topography of Eastern Tibet was built by high uplift rates located in a belt along the plateau margins migrating outwards during plateau growth, as well as carved by erosion of large rivers originating from the interior of the plateau. We validate our analytical solution by comparing it to numerical models and various types of data from five large rivers in Eastern Tibet (Salween, Mekong, Yangtze, Yalong, and Dadu Rivers). The results show that the models with optimized parameter values are generally consistent with the observed river-profile morphologies, exhumation magnitudes, and low-temperature thermochronometric ages. Our results show that the long-term fluvial erosion in Eastern Tibet features mainly a downstream migration of high erosion rates, which is fundamentally different from the headward erosion of most of small mountain rivers. The analytical solutions also predict a characteristic maximum plateau size set by the balance between the horizontal propagating velocity of plateau growth and the bedrock erodibility. The characteristics described by our simple analytical solution may represent a common pattern of outward growing mountains and plateaus in tectonically active regions on Earth. • A new analytical solution for laterally growth orogen dominated by fluvial erosion. • We validate analytical solution by comparing it to observations in Eastern Tibet. • Erosion in Eastern Tibet features mainly downstream migration of high erosion rates. • Plateau erosion is different from headward erosion of most small mountain rivers. • The analytical solution also predicts a characteristic maximum plateau size. [ABSTRACT FROM AUTHOR]

High-elevation, low-relief surfaces are widespread in many mountain belts. However, the origin of these surfaces has long been debated. In particular, the southeast Tibetan Plateau has extensive low-relief surfaces perched above deep valleys and in the headwaters of three of the world's largest rivers (Salween, Mekong, and Yangtze Rivers). Various geologic data and geodynamic models show that many mountain belts grow first to a certain height and then laterally in an outward propagation sequence. By translating this information into a kinematic propagating uplift function in a landscape evolution model, we propose that the high-elevation, low-relief surfaces in the southeast Tibetan Plateau are simply a consequence of mountain growth and do not require a special process to form. The propagating uplift forms an elongated river network geometry with broad high-elevation, low-relief headwaters and interfluves that persist for tens of millions of years, consistent with the observed geochronology. We suggest that the low-relief interfluves can be long-lived because they lack the drainage networks necessary to keep pace with the rapid incision of the large main-stem rivers. The propagating uplift also produces spatial and temporal exhumation patterns and river profile morphologies that match observations. Our modeling therefore reconciles geomorphic observations with geodynamic models of uplift of the southeast Tibetan Plateau, and it provides a simple mechanism to explain the low-relief surfaces observed in several mountain belts on Earth. [ABSTRACT FROM AUTHOR]