Search

GaN nanorods (NRs) with exceptional crystal-defined morphologieswere grown by near-equilibrium hydride vapor phase epitaxy (HVPE)on c-plane sapphire (0001) and silicon (111) substrates. Hexagonalfaceted individual, bunched, and hyperbunched GaN NRs were synthesizedby using a catalyst-free process. GaN NRs with a diameter in the rangeof 125–700 nm and a length in the range of 0.9–3 μmwere grown in a record short process time of 30 min. The influenceof growth temperature and ammonia gas flow rate was investigated toestablish the nucleation and the growth mechanisms of the GaN NRs.Shape and crystallographic facets of the NRs are discussed and a condensationgrowth mechanism is proposed for the formation of bunched GaN NRs.Emphasis is placed on the crystal symmetry of the nuclei in the firststage of growth. The morphology and the structural properties wereanalyzed by field emission scanning electron microscopy (SEM) andX-ray diffraction spectroscopy (XRD). [ABSTRACT FROM AUTHOR]

Reconfiguration of amorphous complex oxides provides a readily controllable source of stress that can be leveraged in nanoscale assembly to access a broad range of 3D geometries and hybrid materials. An amorphous SrTiO 3 layer on a Si:B/Si 1- x Ge x :B heterostructure is reconfigured at the atomic scale upon heating, exhibiting a change in volume of ≈2% and accompanying biaxial stress. The Si:B/Si 1- x Ge x :B bilayer is fabricated by molecular beam epitaxy, followed by sputter deposition of SrTiO 3 at room temperature. The processes yield a hybrid oxide/semiconductor nanomembrane. Upon release from the substrate, the nanomembrane rolls up and has a curvature determined by the stress in the epitaxially grown Si:B/Si 1- x Ge x :B heterostructure. Heating to 600 °C leads to a decrease of the radius of curvature consistent with the development of a large compressive biaxial stress during the reconfiguration of SrTiO 3 . The control of stresses via post-deposition processing provides a new route to the assembly of complex-oxide-based heterostructures in 3D geometry. The reconfiguration of metastable mechanical stressors enables i) synthesis of various types of strained superlattice structures that cannot be fabricated by direct growth and ii) technologies based on strain engineering of complex oxides via highly scalable lithographic processes and on large-area semiconductor substrates., (© 2021 Wiley-VCH GmbH.)

We report the fabrication of near-vertically elongated GaN nanorods on quartz substrates. To control the preferred orientation and length of individual GaN nanorods, we combined molecular beam epitaxy (MBE) with pulsed-mode metal-organic chemical vapor deposition (MOCVD). The MBE-grown buffer layer was composed of GaN nanograins exhibiting an ordered surface and preferred orientation along the surface normal direction. Position-controlled growth of the GaN nanorods was achieved by selective-area growth using MOCVD. Simultaneously, the GaN nanorods were elongated by the pulsed-mode growth. The microstructural and optical properties of both GaN nanorods and InGaN/GaN core-shell nanorods were then investigated. The nanorods were highly crystalline and the core-shell structures exhibited optical emission properties, indicating the feasibility of fabricating III-nitride nano-optoelectronic devices on amorphous substrates.

We report the Au catalyst-assisted synthesis of 20 μm long GaAs nanowires by the vapor-liquid-solid hydride vapor phase epitaxy (HVPE) exhibiting a polytypism-free zincblende phase for record radii lower than 15 nm down to 5 nm. HVPE makes use of GaCl gaseous growth precursors at high mass input of which fast dechlorination at the usual process temperature of 715 °C results in high planar growth rate (standard 30-40 μm/h). When it comes to the vapor-liquid-solid growth of nanowires, fast solidification at a rate higher than 100 μm/h is observed. Nanowire growth by HVPE only proceeds by introduction of precursors in the catalyst droplets from the vapor phase. This promotes almost pure axial growth leading to nanowires with a constant cylinder shape over unusual length. The question of the cubic zincblende structure observed in HVPE-grown GaAs nanowires regardless of their radius is at the heart of the paper. We demonstrate that the vapor-liquid-solid growth in our conditions takes place at high liquid chemical potential that originates from very high influxes of both As and Ga. This yields a Ga concentration systematically higher than 0.62 in the Au-Ga-As droplets. The high Ga concentration decreases the surface energy of the droplets, which disables nucleation at the triple phase line thus preventing the formation of wurtzite structure whatever the nanowire radius is.

High aspect ratio, rod-like and single crystal phase GaAs nanowires (NWs) were grown by gold catalyst-assisted hydride vapor phase epitaxy (HVPE). High resolution transmission electron microscopy and micro-Raman spectroscopy revealed polytypism-free zinc blende (ZB) NWs over lengths of several tens of micrometers for a mean diameter of 50 nm. Micro-photoluminescence studies of individual NWs showed linewidths smaller than those reported elsewhere which is consistent with the crystalline quality of the NWs. HVPE makes use of chloride growth precursors GaCl of which high decomposition frequency after adsorption onto the liquid droplet catalysts, favors a direct and rapid introduction of the Ga atoms from the vapor phase into the droplets. High influxes of Ga and As species then yield high axial growth rate of more than 100 μm/h. The diffusion of the Ga atoms in the liquid droplet towards the interface between the liquid and the solid nanowire was investigated by using density functional theory calculations. The diffusion coefficient of Ga atoms was estimated to be 3 × 10(-9) m(2)/s. The fast diffusion of Ga in the droplet favors nucleation at the liquid-solid line interface at the center of the NW. This is further evidence, provided by an alternative epitaxial method with respect to metal-organic vapor phase epitaxy and molecular beam epitaxy, of the current assumption which states that this type of nucleation should always lead to the formation of the ZB cubic phase.

GaN nanowires with exceptional lengths are synthesized by vapor-liquid-solid coupled with near-equilibrium hydride vapor phase epitaxy technique on c-plane sapphire substrates. Because of the high decomposition frequency of GaCl precursors and a direct supply of Ga through the catalyst particle, the growth of GaN nanowires with constant diameters takes place at an exceptional growth rate of 130 μm/h. The chemical composition of the catalyst droplet is analyzed by energy dispersive X-ray spectroscopy. High-resolution transmission electron microscopy and selective area diffraction show that the GaN nanowires crystallize in the hexagonal wurzite structure and are defect-free. GaN nanowires exhibit bare top facets without any droplet. Microphotoluminescence displays a narrow and intense emission line (1 meV line width) associated to the neutral-donor bound exciton revealing excellent optical properties of GaN nanowires.