Search

Millimetre-waves offer the possibility of wide bandwidth and consequently high data rate for wireless communications. For both uni- and dual-polarized systems, signals sent over a link may suffer severe degradation due to antenna misalignment. Orientation robustness may be enhanced by the use of mutual orthogonality in three dimensions. Multiple-input multiple-output polarization diversity offers a way of improving signal reception without the limitations associated with spatial diversity. Scattering effects often assist propagation through multipath. However, high path loss at millimetre-wave frequencies may limit any reception enhancement through scattering. We show that the inclusion of a third orthogonal dipole provides orientation robustness in this setting, as well as in a rich scattering environment, by means of a Rician fading channel model covering all orientations for a millimetre-wave, tri-orthogonal, half-wave dipole transmitter and receiver employing polarization diversity. Our simulation extends the analysis into three dimensions, fully exploiting individual sub-channel paths. In both the presence and absence of multipath effects, capacity is observed to be higher than that of a dual-polarized system over the majority of a field of view.

A common problem in the analysis of forensic human DNA evidence, or for that matter any nucleic acid analysis, is the presence of contaminants or inhibitors. Contaminants may copurify with the DNA, inhibiting downstream PCR or they may present samples effectively as containing fewer templates than exist in the PCR, even when the actual amount of DNA is adequate. Typically, these challenged samples exhibit allele imbalance, allele dropout, and sequence-specific inhibition, leading to interpretational difficulties. Lessening the effects of inhibitors may increase the effective yield of challenged low template copy samples. High pressure may alter some inhibitors and render them less effective at reducing the yield of PCR products. In an attempt to enhance the amplicon yield of inhibited DNA samples, pressure cycling technology was applied to DNA exposed to various concentrations of hematin (0, 1.25, 2.5, 5, and 7 μM) and humic acid (0, 1.25, 2.5, 5, and 7 ng/μL). The effect of high pressure on the inhibitors, and subsequently the PCR process, was assessed by measuring DNA quantity by quantitative PCR and evaluating short tandem repeat typing results. The results support that pressure cycling technology reduces inhibitory effects and thus, in effect, enhances yield of contaminated amplified products of both hematin and humic acid contaminate samples. Based on the results obtained in this study, this method can improve the ability to type challenged or inhibited DNA samples.

Sample preparation is critical to the success of two-dimensional gel electrophoresis and other analytical methods. Pressure-cycling technology (PCT) uses alternating cycles of high and low pressure to induce cell lysis. Cell suspensions were placed in PULSE Tubes and subjected to alternating cycles of high and low pressure in a Barocycler instrument. each cycle consisted of 20 sec at 35,000 psi followed by 20 sec at ambient pressure. For the bacterium Escherichia coli, PCT extracted 14.2% more total protein than was extracted using a standard bead mill. Image analysis of two-dimensional gels revealed 801 protein spots in the PCT lysate, compared to 760 protein spots in the bead mill lysate.

Reduction and alkylation of protein disulfides prior to IEF, when performed directly in a centrifugal ultrafiltration device, provides an effective means of terminating the alkylation reaction, concentrating the proteins for analysis, and removing ionic impurities that interfere with IEF. When cells were lysed in "buffers" that support the activity of enzymes such as lysozyme and benzonase, the conductivity of the resulting lysate was an order of magnitude higher than when lysis was induced by chaotropic urea detergent solutions. Following reduction and alkylation, the conductivity of both lysates was lowered by ultrafiltration to the 0.1-0.2 mS/cm range in preparation for IEF. The detergent 3-(4-heptyl)phenyl 3-hydroxypropyl dimethylammonio propanesulfonate (C7BzO), which favors the solubilization of proteins, but which interferes with SDS equilibration and second dimension PAGE, was effectively removed by ultrafiltration and exchanged with CHAPS without measurable loss of protein. Disparate protein patterns of Rhodopseudomonas palustris lysates were revealed by two-dimensional gel electrophoresis depending on which reagent was used to induce cell lysis.

An assay is described for titration of human immunodeficiency virus type 1 (HIV-1) and for quantitative analysis of virus expression in vitro. The assay utilizes a liquid RNA-RNA hybridization method coupled with reversible target capture (RTC) on oligo(dT) derivatized magnetic particles. The assay provides a rapid, specific, and sensitive method for quantitation of HIV-1 RNA molecules present either in cells or in viral particles from cell-free culture media. Chronically infected monocytoid U1.1 cells were found to carry 52 pg HIV-1 RNA per 200,000 cells (160 HIV-1 RNA molecules per cell). In contrast, acutely infected CEM and H9 cells carried 3010 and 4370 pg HIV-1 RNA per 200,000 cells (9040 and 13,110 HIV-1 RNA molecules per cell, respectively). No hybridization was observed with uninfected cells or cells infected with HIV-2, HTLV-I, HTLV-II, or EBV. Use of liquid HIV-1 RNA hybridization in association with HIV-1 protein detection methods permits more complete characterization of HIV-1 expression in host cells than either method alone, and also provides a method for standardizing preparations of virus.

One addition mutation and several small deletion mutations have been created in vitro at a unique site in the gene coding for M1 RNA, the RNA subunit of Escherichia coli RNase P. The mutant genes exhibit a wide range of efficiencies in complementing another mutant that is thermosensitive for RNase P function in vivo. The transcripts of the mutated genes cleave a precursor tRNA in vitro with efficiencies that parallel their ability to function in the complementation assay in vivo. The secondary structures in solution of the mutant gene transcripts are shown to be different from the parent molecule by probing the structure of the transcripts with ribonuclease T1. A local region of secondary structure, between nucleotides 275 and 295, must be maintained for normal function of M1 RNA.

The gene for the catalytic RNA subunit of RNase P has been isolated from several Enterobacteriaceae by complementation of an Escherichia coli strain that is temperature-sensitive for RNase P activity. The selection procedure relies on the ability of the heterologous gene products to function enzymatically in E. coli. This procedure obviates the need for positive results in DNA blot hybridization experiments or for the purification of holoenzyme to identify the RNA component of RNase P and its corresponding gene from organisms other than E. coli. Comparisons of the variations in sequences provide the basis for a refined two-dimensional model of the secondary structure of M1 RNA.