Search

The effects of inlet circumferential position around the fuselage on the characteristics of a half-conical scoop inlet having a 24.6deg half-angle cone have been investigated in the langley 4- by 4-foot supersonic pressure tunnel. Pressure-recovery results have been obtained at a Mach number of 2.01 for a fixed boundary-layer-bleed height which was 60 percent of the boundary-layer thickness at an angle of attack of 0deg, and for cowling position parameters of 42.4deg and 38.0deg. inlet had a capture area equal to 24.9 percent of the basic-fuselage frontal area. The angle of attack was varied from 0deg to 12deg. The most favorable pressure-recovery characteristics at angles of attack were obtained with the Inlet located on the bottom of the fuselage where the maximum recovery increased from a value of 81 percent at an angle of attack of 0deg to 87 percent at 12deg. In general, the pressure recovery decreased with increasing angle of attack for all other inlet locations. At a given angle of attack the pressure recovery decreased as the inlet location was progressively moved from the bottom to the top of the fuselage. Stable subcritical operation of the inlet with nearly constant pressure recovery was obtained for inlet mass-flow ratios from 1.0 to about 0.76 at an angle of attack of 0deg with the central body in the design position.

At the request of the Bureau of Aeronautics, Navy Department, investigations of the static-pressure losses and total-head distributions of the Westinghouse X24-C-2 inlet screen were made in the induction aerodynamics laboratory at Langley. The screen was investigated in two configurations, both before and after rounding the leading edges of the vanes. Investigations were conducted through air flows up to about pounds per second. The results of the investigations indicate that maximum lift coefficients of 1.36, 1.71 and 2.11 were measured on the model with flaps neutral and deflected 20 deg. and 55 deg, respectively, at a reynolds number of 8,600,000. When the duct inlet was replaced by a basic airfoil nose the flap neutral maximum lift coefficient was increased from 1.36 to 1.41. The results also showed that at maximum lift with flaps neutral or deflected 55 deg most of the area between the nacelles was stalled while only small areas on other portions of the model were stalled; when the duct inlet was replaced by the basic airfoil nose the stall was delayed to a slightly higher angle of attack but the nature of the stall was relatively unaffected.