Search

Bilateral sagittal split osteotomy is one of the most frequently performed operations in orthognathic surgery. The health of the temporomandibular joint (TMJ) is an important prerequisite for its functionality. The aim of this finite element study was to assess the developed stresses during mouth opening after bilateral sagittal split osteotomy. Different osteotomy gap widths and disc positions were evaluated. Computed tomography and magnetic resonance data of a dentulous cadaver head were used in order to create two finite element models simulating split distances of 5 and 10 mm, respectively. The fixation of the distal and proximal segments was made by a four- or a six-hole titanium mini plate and four monocortical screws respectively. For both models, three different situations of the articular disc were created: a physiological disc position, anterior disc displacement and posterior disc displacement. The mandible was vertically displaced in the midline in order to simulate a mouth opening of 20 mm. The simulation showed high stresses in the area of the titanium plates (up to 850 MPa), implying an increased risk of material failure. High stresses were found within the discs in the models with normal disc position and anterior disc displacement as well (up to 8 MPa), indicating a higher risk of developing craniomandibular disorders. Regarding the stresses within the fixation screws, the highest values were recorded in the area of the upper thread. The degree of mandibular advancement after a bilateral sagittal split osteotomy affects the stress balance in the mandible and the articular discs during mouth opening. © 2020 Elsevier Ltd

Introduction: Torque of the maxillary incisors is essential in esthetics and proper occlusion, while torque expression is influenced by many factors. The aim of this finite element study was to assess the relative effect of tooth morphology, bracket prescription, and bracket positioning on tooth displacement and developed stresses/strains after torque application. Methods: A three-dimensional upper right central incisor with its periodontal ligament (PDL) and alveolus was modelled. The tooth varied in the crown-root angle (CRA) between 156°, 170°, and 184°. An 0.018-inch slot discovery® (Dentaurum, Ispringen, Germany) bracket with a rectangular 0.018 × 0.025-inch β-titanium wire was modelled. Bracket torque prescription varied between 0°, 12°, and 22°, with bracket placement at the centre of the middle, gingival or incisal third of the crown. A total of 27 models were generated and a buccal root torque of 30° was applied. Afterwards, crown and apex displacement, strains in the PDL, and stresses in the bracket were calculated and analysed statistically. Results: The palatal crown displacement was significantly affected by bracket positioning (up to 94 per cent), while the buccal apex displacement was significantly affected by bracket prescription (up to 42 per cent) and bracket positioning (up to 23 per cent). Strains in the PDL were affected mainly by CRA (up to 54 per cent), followed by bracket positioning (up to 45 per cent). Finally, bracket prescription considerably affected the stresses in the bracket (up to 144 per cent). Limitations: These in silico results need to be validated in vivo before they can be clinically extrapolated. Conclusion: Tooth anatomy and the characteristics of the orthodontic appliance should be considered during torque application. © The Author 2016. Published by Oxford University Press on behalf of The European Orthodontic Society. All rights reserved. For permissions, please email: journals.permissions@oup.com