Search

It was compared the reduction effect of contaminants and odor according to DO change and EM (effective microorganisms) addition in maturation process of piggery slurry. The maturation processes were divided into three cases as follows: R-1 was operated at of DO without the addition of EM, R-2 was operated at of DO without the addition of EM and R-3 was operated at of DO with the addition of EM. The addition of EM was more effective than the increase of DO for the reduction of CODcr, and T-N in the maturation of piggery slurry. In addition, the reducing effect of odor intensity appeared high even in the short-term maturation period in case of adding EM and one could not even smell the stimulating odor of piggery slurry.

The changes of contaminants and odor corresponding to anaerobic maturation process of piggery slurry were investigated by applying the additives, such as different kinds of complex microorganism products and deodorants containing microorganism activating agents. The pHs during 20-day anaerobic maturation were operated stably without great change regardless of the additives, although they were rather lower in the case that the additives were contained than the case that they were not contained. The effects of removing CODcr, , T-N, and T-S in case that the additives were not contained, were not so great during the 20-day operation and so it would be difficult to remove the organic materials and nitrogen ingredients simply with anaerobic maturation process. However, in case of anaerobic maturation process that the additives were contained, their average removal rates were improved with the values of for above each of items, even if the 20-day of short-term maturation period was applied. Especial1y, odor intensity with the additives was lowered continuously during the operation period and it had more than two times of lowering effect compared to that without those.

Butyltin compounds (BTs), namely tributyltin (TBT), dibutyltin (DBT) and monobutyltin (MBT), were measured in surface and core sediments collected in 2001 inside Seogwipo Harbor, in order to evaluate their distribution characteristics. Seogwipo Harbor is one of major harbors of Jeju Island where a lot of shipping occurs and is designated as a trade port by the Korea Maritime and Port Law. BTs were detected in surface and core sediments of all stations and their concentrations in surface sediments were low, compared with to those in other sites of domestic and foreign countries. The main species among BTs was MBT, although there was a little difference with a survey site in surface sediments and in core sediments with depth. No or low correlations were obtained between organic matter or particles size of surface and core sediments and total BTs, indicating that these factors did not affect the distribution of BTs. It was estimated that more complex factors including BTs loads and surrounding sedimentary environments, affect the distribution of BTs. The high correlations between BTs indicated that DBT and MBT were mainly degraded from TBT based on antifouling paints of vessel etc. and other sources, such as DBT and MBT, could be ignored. The butyltin degradation indices ([DBT]+[MBT]/[TBT]) in surface sediments were in the range of (mean 3.0), indicating that the parent compound, TBT, were inflowed into the surface sediments a long years ago, degraded and deposited. The sedimentation age of BTs contaminated core sediments could not estimated because the content of activity were nearly all the same and so the sedimentation rate could not obtained.

The treatment of styrene vapor was carried out using the biofilter packed with loess/polyurethane composite during continuous operation of 74 days. The microorganisms were adapted within 2-3 days under the experimental conditions of inlet concentration and empty bed contact time (EBCT). At 200 sec of EBCT, the removal efficiency of styrene was 100\% with 200 ppmv of inlet concentration, while with 400 ppmv of inlet concentration. The biofilter showed the stable removal efficiencies of over under the EBCT range from 300 to 75 sec at the 150 ppmv of inlet styrene concentration. The maximum capacity of styrene removal for the biofilter packed with loess/polyurethane was . During continuous operation of 74 days, pH of the drain water changed slightly and the pressure drop through the biofilter column was below .

The effects of pH (5, 7 and 9) and ionic strength of different salts on the flocculation characteristics of humic acid by inorganic (alum, polyaluminum chloride (PAC) with degree of neutralization, r=(OH/Al) of 1.7) and organic (cationic polyelectrolyte) coagulants, have been examined using a simple continuous optical technique, coupled with measurements of zeta potential. The results are compared mainly by the mechanisms of its destabilization and subsequent removal. The destabilization and subsequent removal of humic acid by PAC and cationic polyelectrolyte occur by a simple charge neutralization, regardless of pH of the solution. However, the mechanism of those by alum is greatly dependent on pH and coagulant dosage, i.e., both mechanisms of charge neutralization at lower dosages and sweep flocculation at higher dosages at pH 5, by sweep flocculation mechanism at pH 7, and little flocculation because of electrostatic repulsion between negatively charged humic acid and aluminum species at pH 9. The ionic strength also affects those greatly, mainly based on the charge of salts, and so is more evident for the salts of highly charged cationic species, such as and However, it is found that the salts have no effect on those at the optimum dosage for alum acting by the mechanism of sweep flocculation at pH 7, regardless of their charge.

Adsorption characteristics of toluene vapor, which is one of important source of volatile organic compounds (VOCs), by activated carbon were investigated using a fixed bed adsorption column. The operating parameters such as breakthrough curve, adsorption capacity, mass transfer zone (MTZ), and length of unused bed (LUB) were studied. The experimental results showed that the breakthrough time decreased with increasing inlet toluene concentration and gas flow rate. MTZ and LUB increased with the increase of inlet concentration, gas flow rate, and particle size of activated carbon. The adsorption capacity increased with the increase of inlet toluene concentration, while it decreased with increasing particle size. However, it was kept at constant value regardless of the increase of gas flow rate. Adsorption isotherm of toluene vapor could be represented by the Freundlich adsorption equation fairly well. From the adsorption experiments using some VOC gases such as toluene, xylene, butyl acetate. butanol and acetone, it was also found that the adsorption capacity was higher in the case of gas with higher boiling point and lower vapor pressure.

The starch-filled waterborne acrylate (SWAC) films were prepared. The structures and properties of SWAC films were investigated by infrared spectroscopy, thermogravimetric analysis, and strength test. The biode­gradability of SWAC film was also studied by determination of reduced sugar products after enzymatic hydrolysis. The surface morphology of the SWAC film was investigated by scanning electron microscopy (SEM). The results showed that the tensile strength and elongation of SWAC film decreased with the increase of starch content. The SWAC film showed significantly higher water absorbed content than waterbonre acrylate film. The biodegradability of SWAC film increased as the content of starch increased. The biodegradation of starch in SWAC film by of that of pure starch.