Search

Sulphur Emission Control Areas (SECAs), mandated by the International Maritime Organization (IMO), regulate fuel sulphur content (FSC) to mitigate the environmental and health impact of shipping emissions in coastal areas. Currently, FSC is limited to 0.1% (w/w) within and 0.5% (w/w) outside SECAs, with exceptions for ships employing wet sulphur scrubbers. These scrubbers enable vessels using non-compliant fuels such as high-sulphur heavy fuel oils (HFOs) to enter SECAs. However, while sulphur reduction via scrubbers is effective, their efficiency in capturing other potentially harmful gases remains uncertain. Moreover, emerging compliant fuels like highly aromatic fuels or low-sulphur blends lack characterisation and may pose risks. Over three years, we assessed emissions from an experimental marine engine at 25% and 75% load, representative of manoeuvring and cruising, respectively. First, characterizing emissions from five different compliant and non-compliant fuels (marine gas oil MGO, hydro-treated vegetable oil HVO, high-, low- and ultra-low sulphur HFOs), we calculated emission factors (EF). Then, the wet scrubber gas-phase capture efficiency was measured using compliant and non-compliant HFOs. NO x EF varied among fuels (5200-19700 mg/kWh), with limited scrubber reduction. CO (EF 750-13700 mg/kWh) and hydrocarbons (HC; EF 122-1851 mg/kWh) showed also insufficient abatement. Carcinogenic benzene was notably higher at 25% load and about an order of magnitude higher with HFOs compared to MGO and HVO, with no observed scrubber reduction. In contrast, carbonyls such as carcinogenic formaldehyde and acetaldehyde, acting as ozone precursors, were effectively scrubbed due to their polarity and water solubility. The ozone formation potential (OFP) of all fuels was examined. Significant EF differences between fuels and engine loads were observed, with the wet scrubber providing limited or no reduction of gaseous emissions. We suggest enhanced regulations and emission abatements in the marine sector to mitigate gaseous pollutants harmful to human health and the environment., Competing Interests: Declaration of competing interest The authors declare that they have no known competing financial interests or personal relationships that could have appeared to influence the work reported in this paper., (Copyright © 2024 The Authors. Published by Elsevier Inc. All rights reserved.)

The reliability of analytical results is critical and indispensable when applied in regulated environments such as the pharmaceutical industry. Therefore, analytical workflows must be validated. However, validation guidelines are often designed for quantitative targeted analysis and rarely apply to qualitative untargeted approaches. In this study, we employ a risk assessment approach to identify critical parameters which might influence the qualitative results derived by online derivatisation - comprehensive two-dimensional gas chromatography coupled to a high-resolution time-of-flight mass spectrometer (GC × GC-HR-ToF-MS) for the analysis of the active pharmaceutical ingredient (API) sodium bituminosulfonate (SBS). To show the complexity and feasibility of such an approach, we focus on investigating three potential risk factors: sample preparation, vapourability, and the thermal stability of sulfonates. Through the individual evaluation of these potential risk factors due to the application of sample preparation approaches and thermal gravimetric analysis (TGA), we demonstrate the high derivatisation efficiency and repeatability of the online derivatisation method and confirm the absence of derivatisation-induced side reactions. In addition, we also show the potential thermal instability of an incompletely derivatised API. To address the limitation of these individual assessments, we applied a holistic evaluation step with negative electrospray ionisation Fourier transform ion cyclotron resonance mass spectrometry (ESI( -) FT-ICR MS) as an orthogonal technique. This confirms that most of the API is detected via the presented GC-based method. Thereby, we demonstrated the practical feasibility of the risk assessment-based approach to ensure the validity of the qualitative data for a complex untargeted method., (© 2023. The Author(s).)

The European pharmacopeia provides analytical methods for the chemical characterization of active pharmaceutical ingredients (APIs). However, the complexity of some APIs exceeds the limitations of the currently prevailing physicochemical methods. Sodium bituminosulfonate (SBS) is described by the collection of key parameters of generalizing criteria such as dry matter, sulfur and sodium content, and neutrality, but techniques to unravel the complexity on a molecular level are lacking. We present a study based on online derivatization with tetramethylammonium hydroxide in combination with comprehensive two-dimensional gas chromatography coupled to an electron ionization high-resolution time-of-flight mass spectrometer (GC × GC-HR-ToF-MS) for the chemical description of SBS as well as its process intermediates. The application of GC × GC allowed the comprehensive description of the chemical components in the API and the process intermediates for the first time. Furthermore, it was possible to classify peaks regarding their elemental and structural composition based on accurate mass information, elution behavior, and mass fragmentation pattern. This work demonstrates not only the general applicability, advantages but also limitations of GC × GC for the characterization of APIs for complex drugs., (© 2022. The Author(s).)

The emissions of marine diesel engines have gained both global and regional attentions because of their impact on human health and climate change. To reduce ship emissions, the International Maritime Organization capped the fuel sulfur content of marine fuels. Consequently, either low-sulfur fuels or additional exhaust gas cleaning devices for the reduction in sulfur dioxide (SO 2 ) emissions became mandatory. Although a wet scrubber reduces the amount of SO 2 significantly, there is still a need to consider the reduction in particle emissions directly. We present data on the particle removal efficiency of a scrubber regarding particle number and mass concentration with different marine fuel types, marine gas oil, and two heavy fuel oils (HFOs). An open-loop sulfur scrubber was installed in the exhaust line of a marine diesel test engine. Fine particulate matter was comprehensively characterized in terms of its physical and chemical properties. The wet scrubber led up to a 40% reduction in particle number, whereas a reduction in particle mass emissions was not generally determined. We observed a shift in the size distribution by the scrubber to larger particle diameters when the engine was operated on conventional HFOs. The reduction in particle number concentrations and shift in particle size were caused by the coagulation of soot particles and formation/growing of sulfur-containing particles. Combining the scrubber with a wet electrostatic precipitator as an additional abatement system showed a reduction in particle number and mass emission factors by >98%. Therefore, the application of a wet scrubber for the after-treatment of marine fuel oil combustion will reduce SO 2 emissions, but it does not substantially affect the number and mass concentration of respirable particulate matters. To reduce particle emission, the scrubber should be combined with additional abatement systems., Competing Interests: Declaration of competing interest The authors declare that they have no known competing financial interests or personal relationships that could have appeared to influence the work reported in this paper., (Copyright © 2022 Elsevier Ltd. All rights reserved.)

The health effects of exposure to secondary organic aerosols (SOAs) are still limited. Here, we investigated and compared the toxicities of soot particles (SP) coated with β-pinene SOA (SOA βPin -SP) and SP coated with naphthalene SOA (SOA Nap -SP) in a human bronchial epithelial cell line (BEAS-2B) residing at the air-liquid interface. SOA βPin -SP mostly contained oxygenated aliphatic compounds from β-pinene photooxidation, whereas SOA Nap -SP contained a significant fraction of oxygenated aromatic products under similar conditions. Following exposure, genome-wide transcriptome responses showed an Nrf2 oxidative stress response, particularly for SOA Nap -SP. Other signaling pathways, such as redox signaling, inflammatory signaling, and the involvement of matrix metalloproteinase, were identified to have a stronger impact following exposure to SOA Nap -SP. SOA Nap -SP also induced a stronger genotoxicity response than that of SOA βPin -SP. This study elucidated the mechanisms that govern SOA toxicity and showed that, compared to SOAs derived from a typical biogenic precursor, SOAs from a typical anthropogenic precursor have higher toxicological potency, which was accompanied with the activation of varied cellular mechanisms, such as aryl hydrocarbon receptor. This can be attributed to the difference in chemical composition; specifically, the aromatic compounds in the naphthalene-derived SOA had higher cytotoxic potential than that of the β-pinene-derived SOA., (Copyright © 2022 The Authors. Published by Elsevier Ltd.. All rights reserved.)

Background: Secondary organic aerosols (SOAs) formed from anthropogenic or biogenic gaseous precursors in the atmosphere substantially contribute to the ambient fine particulate matter [PM ≤ 2.5 μ m in aerodynamic diameter ( PM 2.5 )] burden, which has been associated with adverse human health effects. However, there is only limited evidence on their differential toxicological impact., Objectives: We aimed to discriminate toxicological effects of aerosols generated by atmospheric aging on combustion soot particles (SPs) of gaseous biogenic ( β -pinene ) or anthropogenic (naphthalene) precursors in two different lung cell models exposed at the air-liquid interface (ALI)., Methods: Mono- or cocultures of lung epithelial cells (A549) and endothelial cells (EA.hy926) were exposed at the ALI for 4 h to different aerosol concentrations of a photochemically aged mixture of primary combustion SP and β -pinene ( SOA β PIN -SP ) or naphthalene ( SOA NAP -SP ). The internally mixed soot/SOA particles were comprehensively characterized in terms of their physical and chemical properties. We conducted toxicity tests to determine cytotoxicity, intracellular oxidative stress, primary and secondary genotoxicity, as well as inflammatory and angiogenic effects., Results: We observed considerable toxicity-related outcomes in cells treated with either SOA type. Greater adverse effects were measured for SOA NAP -SP compared with SOA β PIN -SP in both cell models, whereas the nano-sized soot cores alone showed only minor effects. At the functional level, we found that SOA NAP -SP augmented the secretion of malondialdehyde and interleukin-8 and may have induced the activation of endothelial cells in the coculture system. This activation was confirmed by comet assay, suggesting secondary genotoxicity and greater angiogenic potential. Chemical characterization of PM revealed distinct qualitative differences in the composition of the two secondary aerosol types., Discussion: In this study using A549 and EA.hy926 cells exposed at ALI, SOA compounds had greater toxicity than primary SPs. Photochemical aging of naphthalene was associated with the formation of more oxidized, more aromatic SOAs with a higher oxidative potential and toxicity compared with β -pinene . Thus, we conclude that the influence of atmospheric chemistry on the chemical PM composition plays a crucial role for the adverse health outcome of emissions. https://doi.org/10.1289/EHP9413.

Widespread smoke from wildfires and biomass burning contributes to air pollution and the deterioration of air quality and human health. A common and major emission of biomass burning, often found in collected smoke particles, is spherical wood tar particles, also known as "tar balls". However, the toxicity of wood tar particles and the mechanisms that govern their health impacts and the impact of their complicated chemical matrix are not fully elucidated. To address these questions, we generated wood tar material from wood pyrolysis and isolated two main subfractions: water-soluble and organic-soluble fractions. The chemical characteristics as well as the cytotoxicity, oxidative damage, and DNA damage mechanisms were investigated after exposure of A549 and BEAS-2B lung epithelial cells to wood tar. Our results suggest that both wood tar subfractions reduce cell viability in exposed lung cells; however, these fractions have different modes of action that are related to their physicochemical properties. Exposure to the water-soluble wood tar fraction increased total reactive oxygen species production in the cells, decreased mitochondrial membrane potential (MMP), and induced oxidative damage and cell death, probably through apoptosis. Exposure to the organic-soluble fraction increased superoxide anion production, with a sharp decrease in MMP. DNA damage is a significant process that may explain the course of toxicity of the organic-soluble fraction. For both subfractions, exposure caused cell cycle alterations in the G2/M phase that were induced by upregulation of p21 and p16. Collectively, both subfractions of wood tar are toxic. The water-soluble fraction contains chemicals (such as phenolic compounds) that induce a strong oxidative stress response and penetrate living cells more easily. The organic-soluble fraction contained more polycyclic aromatic hydrocarbons (PAHs) and oxygenated PAHs and induced genotoxic processes, such as DNA damage.

Atmospheric brown carbon (BrC) is an important contributor to the radiative forcing of climate by organic aerosols. Because of the molecular diversity of BrC compounds and their dynamic transformations, it is challenging to predictively understand BrC optical properties. OH radical and O 3 reactions, together with photolysis, lead to diminished light absorption and lower warming effects of biomass burning BrC. The effects of night-time aging on the optical properties of BrC aerosols are less known. To address this knowledge gap, night-time NO 3 radical chemistry with tar aerosols from wood pyrolysis was investigated in a flow reactor. This study shows that the optical properties of BrC change because of transformations driven by reactions with the NO 3 radical that form new absorbing species and lead to significant absorption enhancement over the ultraviolet-visible (UV-vis) range. The overnight aging increases the mass absorption coefficients of the BrC by a factor of 1.3-3.2 between 380 nm and 650 nm. Nitrated organic compounds, particularly nitroaromatics, were identified as the main products that contribute to the enhanced light absorption in the secondary BrC. Night-time aging of BrC aerosols represents an important source of secondary BrC and can have a pronounced effect on atmospheric chemistry and air pollution.

Comprehensive chemical investigation of non-volatile complex mixtures, without extensive sample pretreatment, remains challenging due to the high number of constituents with different chemical properties. In past years, direct high-resolution mass spectrometry established itself as powerful technique for the detailed molecular description of ultra-complex mixtures, but was mainly used with atmospheric pressure ionization. In this study, we present a direct inlet approach with vacuum ionization and high-resolution time-of-flight mass spectrometry. Exemplary, the non-volatile fractions of crude oil were directly inserted into the ion source and volatilized under reduced pressure conditions. An applied temperature gradient enabled thermal pre-separation, according to volatility, prior to electron ionization and mass spectrometric detection. With exact mass information, peaks were assigned to elemental compositions and grouped into component classes. Moreover, the application of supervised and unsupervised statistical tools allowed differentiation of the samples on a molecular level and the identification and attribution of significant chemical features., (Copyright © 2019. Published by Elsevier B.V.)

59 children without symptoms of sinusitis or URI, aged 6 to 8 years had positive radiologica findings of sinus pathology in 32%. Correspond ultrasonographic findings were positive in 22%. A correlation was detected in 67,8%. In non correlating cases, x-ray had a tendency to more pathological findings in 63%. When correlating x-ray and ultrasound in a diagram of 118 maxillary sinuses only 6% had changes worth treatable. The classical radiological signs os sinusitis in children are therefore questionable.