Search

A new generation of high-gradient normal conducting 1.3 GHz RF gun with 1% duty factor was developed to provide a high-quality electron source for superconducting linac driven free-electron lasers like FLASH and European XFEL. Compared to the Gun4 series, Gun5 aims for a ~50% longer RF pulse length (RF pulse duration of up to 1 ms at 10 Hz repetition rate) combined with high gradients (up to ~60 MV/m at the cathode). In addition to the improved cell geometry and cooling concept, the new cavity is equipped with an RF probe to measure and control the amplitude and phase of the RF field inside the gun. The first characterization of Gun5.1 included measurements of RF amplitude and phase stability (pulse-to-pulse and along 1 ms RF pulse). The dark current was measured at various peak power levels. The results of this characterization will be reported.

The Photo Injector Test Facility at DESY in Zeuthen (PITZ) develops a prototype of an accelerator-based high-power tunable THz source for pump-probe experiments at the European XFEL. The PITZ injector is also the site for the development and preparation of the high-brightness electron source for the main linac of the European XFEL and has the same pulse train structure as the X-ray photon source of the XFEL. For the proof-of-principle experiments on high-power THz generation an LCLS- I undulator (on loan from SLAC) is installed in the tunnel annex downstream of the existing accelerator. The extension of the beam line consists of a bunch compressor and a collimation system in the main PITZ tunnel, as well as a matching section, the undulator and the THz diagnostic setup in the tunnel annex. A Self-Amplified Spontaneous Emission (SASE) FEL is used to generate the THz pulses. High radiation power can be achieved by utilizing high charge (up to several nC) electron bunches from the PITZ photo injector. A beam energy of ~17 MeV is used to generate THz radiation with a centre wavelength of 100 μm. The transport of this space charge dominated electron beam and its thorough matching into the planar LCLS-I undulator with a strong vertical focusing is one of the project challenges. The installation of the first THz beamline setup was finished in summer 2022 and com-missioning with electron beam started. A specially developed procedure for a high charge beam matching into the undulator was successfully tested resulting in a first THz pulse generation. The start-up THz diagnostics is based on pyrodetectors. First measurements of the THz generation from 1,2 and 3 nC bunches have been taken, the statistics properties analysis corresponds to the expected SASE performance. The gain curve for the 3 nC case reflects the onset of saturation regime.

Research and development of an accelerator-based THz source prototype for pump-probe experiments at the European XFEL are ongoing at the Photo Injector Test Facility at DESY in Zeuthen (PITZ). A proof-of-principle experiment to generate THz SASE FEL radiation using an LCLS-I undulator driven by an electron bunch from the PITZ accelerator has been prepared. After four years of designs and construction, the first commissioning with an electron beam was started in July 2022. This paper presents and discusses the experience and results of the first commissioning.

5th International Beam Instrumentation Conference, IBIC 2016, Barcelona, Spain, 11 Sep 2016 - 15 Sep 2016; JACoW, Geneva, Switzerland 1-4 (2016). doi:10.18429/JACoW-IBIC2016-WEPG47, A transverse deflecting system (TDS) is under commissioning at the Photo Injector Test Facility at DESY, Zeuthen site (PITZ). The structure was designed and manufactured by the Institute for Nuclear Research (INR RAS, Moscow, Russia) as prototype for the TDS in the injector part of the European XFEL. Last year the deflection voltage was limited for safety reasons, but after thorough investigations of the waveguide system we are now able to operate the cavity close to design specifications. The PITZ TDS streaks the electron beam vertically, allowing measurements of the longitudinal bunch profile, and, in combination with a subsequent horizontal bending magnet, also of the longitudinal phase space and slice energy spread. Furthermore, several quadrupole magnets and screen stations can be employed for slice emittance measurements using the TDS. This paper describes the progress in commissioning of the hardware, measurement techniques and simulations, and outlines the prospects of reliable slice emittance measurements at 20 MeV/c, where space charge forces complicate the determination of transfer matrices., Published by JACoW, Geneva, Switzerland

The Photo Injector Test facility at DESY, Zeuthen site (PITZ), develops, optimizes and characterizes high brightness electron sources for free electron lasers like FLASH and the European XFEL. In the last year, the facility was significantly upgraded by the installation of a new normal conducting radio- frequency (RF) gun cavity with its new waveguide system for the RF feed, which should allow stable and reliable gun operation, as required for the European XFEL. Other relevant additions include beamline modifications for improving the electron beam transport through the PITZ accelerator, extending the beam-based measurement capabilities, and preparing the installation of a plasma cell. Furthermore, the laser hutch was re-arranged in order to be able to house an additional, new photo cathode drive laser system which should be able to produce 3D ellipsoidal laser pulses to further improve the electron beam quality. This paper describes in detail the aforementioned facility upgrades and reports on the first operation experience with the new gun setup., Proceedings of the 6th Int. Particle Accelerator Conf., IPAC2015, Richmond, VA, USA

For successful operation of X-ray Free Electron Lasers, one crucial parameter is the ultrashort electron bunch length yielding a high peak current and a short saturation length. In order to effectively compress the bunches during the acceleration process, a detailed understanding of the full longitudinal phase space distribution already in the injector is required. Transverse deflecting RF structures (TDS) can shear the bunch transversely, mapping the longitudinal coordinate to a transverse axis on an observation screen downstream. In addition to the bunch length, the slice emittance along the bunch as well as the full longitudinal phase space can be obtained. At the Photo Injector Test Facility at DESY, Zeuthen site (PITZ), an S-band traveling wave TDS is under commissioning since 2015. This cavity is a prototype for the TDS in the injector part of the European XFEL and has been designed and manufactured by the Institute for Nuclear Research (INR, Moscow, Russia). In this paper, first commissioning results of the system at PITZ are presented and discussed., Proceedings of the 37th International Free Electron Laser Conference, FEL2015, Daejeon, Republic of Korea