Search

To adapt porous material for its application as low noise trailing edge, a special rolling process, using a time-varied rolling gap, was used in previous research to produce a porosity gradient in the direction of rolling. Investigations suggest that a gradient in porosity may also be produced in the thickness direction of the material, i.e., in the rolling gap direction, without using a specialized rolling mill. Such a gradient may help to further increase acoustic efficiency of porous materials. The aim of this study was to analyze the dependency of such a gradient on the rolling parameters, and to clarify which stress components are significantly responsible for an increased near-surface compaction. Experiments using different relative compressed lengths were performed to analyze shear-dominated and friction-dominated rolling. The material was characterized using compression tests, computed tomography and flow resistance measurements. It is shown that the compressed length is an important parameter for adjusting a porosity gradient. Rolling with small values of compressed length during all rolling passes leads to increased compaction of near-surface regions, compared to interior ones. The difference in porosity achieved was up to 15%. Furthermore, the results suggested that a gradient in hydrostatic stress is responsible for the porosity gradient. Validation of the results by FE simulation is forthcoming, but not part of this publication.

Noise reduction of aircrafts during take-off and landing has become an important part of research in aviation. The circulation of air around the airframe is a major source of noise during landing. This includes noise generated at the trailing edge. Open porous materials, such as porous aluminum, are investigated for the reduction of this noise. In this study, cold rolling is used to enhance the structure of porous aluminum in matters of aeroacoustics and mechanical properties. An important parameter characterizing the acoustic behavior is flow resistivity which is measured using the alternating airflow method. The flow resistivity is highly dependent upon the pore structure which is analyzed using three-dimensional computer tomography (CT). Additionally, CT combined with discontinuous tensile testing is used to study the influence of cold rolling on the damage behavior of porous aluminum. Besides the damage behavior, mechanical parameters have been determined to identify reasonable degrees of deformation. A cold rolling technique to produce material with a gradient in porosity is described and experimental porous trailing edges for measurements in an acoustic wind tunnel are shown. The findings of this study show that cold rolling is a promising way to customize porous aluminum for low-noise trailing edge applications.